墻角試驗 的英文怎麼說

中文拼音 [jiǎoshìyàn]
墻角試驗 英文
corner test
  • 墻 : 名詞（磚、石等築成的屏障或外圍） wall
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Based on the experiment of full - sized cshb walls under lateral and vertical loads, initial crack - resisting stiffen formula was deduced by considering the influence of concrete beams, concrete core columns, structural columns, vertical pressure and window ( or door ). the results calculated from the formula were fit well with the experimental results. by the analysis of displacement at initial crazing, probability statistical mode and its parameters of relative displacement angle were presented

    在介紹和總結本課題的室內足尺寸單片墻抗側力性能試驗的基礎上，考慮了圈樑、芯柱、構造柱和墻體正壓力、開門窗洞等因素對抗側剛度的影響，提出了綜合各種因素的初裂抗側剛度公式，與試驗結果具有很好的一致性；結合試驗的初裂位移分析，給出了層間相對位移角的概率統計模式及相應的統計參數，提出了小砌塊建築層間位移角的控制標準。
  2. The philosophy and methodology of performance - based seismic design ( pbsd ) has been an extensive topic discussed by earthquake engineering experts at home and abroad. in this paper, research work on displacement - based seismic design ( dbsd ) at home and abroad are systematically collected and analyzed. based on the available references of seismic behavior of frame - wall buildings, the method of dbsd of reinforced concrete frame - wall buildings is primarily put forward by taking into account the fault of methods of seismic design in current code. the main contents are as follows : the actual stiffness of frames and seismic walls at different deformation stages are determined from experimental data, and the results are adopted in the dbsd method

    本文對國內外基於位移的抗震設計研究成果進行了較系統的綜述與分析，在已有框架-剪力墻結構抗震性能研究的基礎上，針對現行抗震設計方法的不足，提出了鋼筋混凝土框架-剪力墻結構直接基於位移的抗震設計方法，並對其進行了一些研究和探索，主要內容如下：對國內外框架和剪力墻的模型試驗數據進行分析，量化了剛度退化系數與層間側移角之間的關系，並將其結果引入框架-剪力墻結構直接基於位移的抗震設計方法中。
  3. The mechanic character, destroying pattern, the ductile and dissipation energy capacity of this composite structure under the earthquake have been clarified. the stiffness degradation, natural frequency, damping ratio of this structural system with the development of intensity of earthquake have also been investigated. with consideration of the top displacement, drift of story and micro - strain of longitude steel bars, the equivalent shell wall method has been presented in order to simplify the design of such type structure

    通過試驗，掌握了該結構體系在水平地震荷載作用下的受力特點、變形與耗能性能、結構的破壞形態等力學指標：得到了結構在不同地震烈度條件下的剛度變化、自振頻率、阻尼比等動力特性；綜合結構的頂點位移、層間轉角以及鋼筋的微應變，提出了適合於該結構體系簡化設計的「等效剪力墻法」 。
  4. Though the pseudo - static test of three prototype - modal sandwich wall with angled - steel column, seismic behavior are discussed. based on the concrete nonlinear analyzing theory, this paper constructed the finite element modal by ansys program and proved the modal by test result. designed & further improved methods are presented on the conclusion of tests and calculations

    本文通過對三個角鋼邊框復合剪力墻板的原型擬靜力試驗，研究了角鋼邊框復合剪力墻的抗震性能，同時在現有混凝土非線型分析理論的基礎上，採用ansys有限元分析程序建立了墻板的有限元模型，結合試驗數據對模型進行了驗證。
  5. Based on the experimental studies and calculated analysis, nonlinear finite element analysis of r. c. shear wall with frame column under unilateral load is carried out by ansys program in order to understand the evolution of crack patterns, deformation and failure course of the specimens in theory computing

    在試驗研究的基礎上，採用ansys有限元分析程序，對剪力墻模型結構在單向加載下的性能作了非線性分析，從理論計算角度進一步了解其在水平荷載作用下的開裂、變形及破壞全過程。
  6. Based on domestic and international researches, this paper have experimental researched on crack - resistance and seismic behaviors of prestressed small - sized concrete hollow block masonry, and below is the concrete contents of research : adopt a finite element analysis soft, and proceed nonlinear finite element analysis to different type and different structure measure of walls. the result expresses that the walls which have window, have stress concentration at the window cape, and easily appear the cracks, the same type walls " carrying capacity of crack - resistance are greatly improved after being prestressed, and compare the different type walls, a problem is discovered that window or hole is consumedly lowered the carrying capacity of crack - resistance and stiffness of wall

    具體研究內容如下：採用有限元分析軟體對不同類型、不同構造措施的墻體進行了非線性有限元分析，結果表明：開窗洞墻體在窗角處存在應力集中，容易開裂；同種類型墻體在施加低預應力度后，其抗裂承載力有較大的提高；不同類型的墻體比較發現，窗洞對墻體抗裂性能、剛度有很強的消弱作用，與試驗結果相符。
  7. On the basis of analysis previous experiment data, it is conclusion that allowable value of drift angle of elastic and elastic - plastic is 1 / 550 and 1 / 75 respectively, which is applicable to r. c. frame structure with special - shaped column is given out. the conclusion explains that the deformabiliry of r. c. frame structure with special - shaped column lies between rectangle column frame structure and shear wall structure. the calculating formula of allowable value of axial load ratio of special - shaped column is derived, it is compared with that of equaling areas rectangle column

    根據對前人試驗數據的統計分析，給出了適用於異形柱框架結構的彈性和彈塑性層間位移角限值分別為1 550和1 75 ；指出了異形柱框架結構的層間變形能力介於普通矩形柱框架結構和剪力墻結構之間；以t形柱為例，推導了異形柱軸壓比限值的計算公式，通過與等面積矩形柱的對比分析，認為異形柱的軸壓比限值與其截面尺寸的比例關系有關；當腹板受壓或翼緣受壓時， t形柱軸壓比限值存在較大差異；不同的荷載角作用，軸壓比限值變化較大；矩形柱的軸壓比限值要大於異形柱的軸壓比限值。
分享友人
分享到 Line

分享到臉書