墻體配筋 的英文怎麼說

中文拼音 [tǐpèijīn]
墻體配筋 英文
wall reinforcement
  • 墻 : 名詞（磚、石等築成的屏障或外圍） wall
  • 體 : 體構詞成分。
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 筋 : 名詞1 （肌的舊稱） muscle2 [口語] （肌腱或骨頭的韌帶） tendon; sinew 3 [口語] （可以看見的皮下靜...
  1. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  2. Reinforced concrete masonry shear wall structure is a new type of structure, the theory of computing and analysis for it is juvenility

    配筋砌塊砌體剪力墻結構是一種新型的建築結構體系，其內力分析和計算理論還較不成熟。
  3. In the design, the construction measures such as application of shrinkage - compensating concrete, arrangement of spacing layer between the foundation rock and the bottom slab, adding outside waterproof layer, flexible connection between outlet pipe with side - wall, integerated concrete placement of pump seat with bottom slab and design of reinforcement with application of advanced calculation theory are used according to the characteristics of lager span, larger volume and complex loading conditions of the understructure

    針對下部結構跨度大、體積大、受力復雜的特點，在設計中採取多種措施，包括採用補償收縮混凝土、基巖與底板間設隔離層、增設外防水層、出水管與邊墻採用柔性連接、機座與底板整體澆注、採用先進計算理論指導配筋。
  4. This paper is focused on a series of experiments including two kinds of large - scale composite walls with different joint fashion under low cyclic loadings. the experiments are carried out in order to know the seismic of composite walls out - of - plane and research the impact of deformation out - of - plane on carrying ability in - plane, experimental design reference is expected to achieve and tech support provide

    為了彌補這方面的研究不足，本文對兩種連接方式足尺復合墻片進行了低周反復荷載作用下的恢復力試驗，以了解配筋砌塊復合墻的平面外抗震性能，同時研究平面外變形對墻體平面內抗震性能的影響，為配筋砌塊復合墻的設計提供依據。
  5. Research of power control and simulation in cdma system

    自密實混凝土配筋墻體的力學性能研究
  6. 3. through experimental and theoretic analysis it proved that it has more prominent effects in improving bearing capacity, the structure integer deformation and energy dissipating with concealed bracings in the two wall slabs than only with across inclined reinforcements in the lintel beams. and the key point of the rc coupled shear wall with concealed bracings is that concealed bracings can control the failure mechanism of the shear wall rationally

    通過試驗和理論分析證明了在連梁中加配交叉斜筋對提高承載力和延性效果顯著，兩墻肢加設暗支撐后，兩墻肢抗震能力明顯加強，同時結構整體變形和耗能能力顯著增強，帶暗支撐雙肢剪力墻的關鍵在於合理地控制了剪力墻的破壞機制。
  7. The major factor considered in experiment are followed : the influence of width of wall, the influence of different reinforcement ratio of wall, the influence of axis compress ratio, the influence of mortar layer

    試驗中考慮的主要因素有：墻體厚度對于抗震的影響、墻體不同配筋的影響、軸壓比的影響、砂漿層的影響等。
  8. The major factors of the experiment are listed as following : the influence of different reinforcement ratio of the walls, the influence axial compression ratio, the influence of vertical reinforcing bars at the boundary, the influence of mortar layers etc. furthermore, the load carrying capacity and the elastic stiffness are calculated and experimental results have proved that they are good

    試驗中考慮的主要因素有：墻體不同配筋的影響、軸壓比的影響、兩端豎向加強鋼筋的影響、砂漿層的影響等。並對試件的承載力及彈性剛度進行了實測結果與計算的比較，符合較好。
  9. Experimental research on shear bearing behavior of reinforced masonry wall

    混凝土小砌塊配筋砌體墻片抗剪性能試驗研究
  10. Experimental research on bending bearing behavior of reinforced masonry walls

    混凝土小砌塊配筋砌體墻片的抗彎性能試驗研究
  11. Nonlinear fem analysis for shear capacity of reinforced block masonry shear wall

    配筋砌塊砌體剪力墻抗剪承載力非線性有限元分析
  12. The main work done in this paper is as follows : ( 1 ) simulate the temperature field of basement wall by ansys software, sum up the characteristics of the temperature field of basement wall, and analyze the influence of the types of the molding board, environmental change and cement content ; ( 2 ) the whole simulation analysis process of early - age concrete stress field is realized by sub - development of ansys, and cts - ansys software is developed with fortran ; ( 3 ) based on the cause of cracking, the influence of the thickness of the wall, length, bar arrangement, mix proportion, expanding agent, etc, on the wall stress due to concrete creep and temperature change is analyzed

    本文主要進行了以下幾個方面的研究： （ 1 ）利用ansys軟體，模擬了施工期地下室側墻溫度場，總結了地下室側墻溫度場分佈的特點，分析了模板類型、環境變化和水泥用量等對墻體溫度場的影響； （ 2 ）以大型通用有限元軟體ansys為平臺進行二次開發，運用visualfortran語言編寫了cts - ansys程序，實現了施工期混凝土徐變溫度應力的模擬計算； （ 3 ）從裂縫形成的原因出發，分析了地下室側墻厚度、長度、配筋率、配合比、膨脹劑等因素對墻體徐變溫度應力的影響。
  13. It is found by comparison that as the structural forms of special - shaped columns and short - shear walls are used, the structures should be arranged reasonably so as to meet the needs of lateral stiffness, and axial compression ratio should be controlled strictly so as to meet the needs of constructional reinforcement to prevent the probably curling and shear failure for the purpose of meeting the needs of the construction of small high - buildings

    對比討論發現：採用鋼筋混凝土異形柱和短肢剪力墻的結構形式時，應當進行合理的結構布置以滿足結構整體抗側移剛度的要求，同時嚴格控制豎向構件軸壓比並滿足配筋構造以防止構件可能出現的翹曲和剪切破壞，這樣才能同時滿足小高層住宅對建築和結構的需要。
  14. A program with c + + language was designed to calculate ultimate load of the reinforced concrete masonry shear wall structure. the reliability of the program was proved by comparing the program results with experimental results. ( 2 ) using the program, impact to the shear resistant of the ratio of grout for concrete and the ratio of height to section thickness and the horizontal reinforcement ratio was discussed

    （ 2 ）利用本文編制的程序，討論不同的高寬比、灌芯率和水平配筋率對配筋砌塊砌體剪力墻抗剪承載力的影響，並驗證了《砌體規范》 （ gb50003 - 2001 ）規定允許高寬比和允許配筋率范圍。
  15. The limited range ordinate by the code for design of masonry structures was validated. ( 3 ) using the program, impact to the compressive strength of ratio of grout for concrete and ratio of height to section thickness to the compressive strength was discussed. a new formula was advanced in this article

    （ 3 ）利用本文編制的程序，採用回歸分析方法討論配筋砌塊砌體剪力墻中灌芯率和灌芯混凝土強度對其抗壓強度的影響，並提出了本文建議的配筋砌塊砌體剪力墻抗壓強度的計算公式。
  16. Masonry composite walls with steels is a new - style structure system which accord heat preservation of freezing zone

    配筋砌體復合墻是考慮嚴寒地區保溫問題的一種新型結構。
  17. In this paper, there are three main purposes to be attained. firstly, enough ductility of coupling beams is needed, namely no shear failure occurs too early. secondly, the capacity of energy dissipation is satisfied on the grounds of enough stiffness

    本文的主要研究目的是首先保證連梁具有足夠的延性，即保證連梁端部在達到較大彎矩之前，不過早發生剪切破壞；其次是在保證剪力墻整體強度的前提下，連梁還需具有良好的耗能性能；連梁的配筋構造不太復雜，方便施工。
分享友人
分享到 Line

分享到臉書