壞試驗方法 的英文怎麼說

中文拼音 [huàishìyànfāngfǎ]
壞試驗方法 英文
test method for insulators :mechanical test methodss
  • 壞 : Ⅰ形容詞1 （不好的; 惡劣的; 使人不滿意的） bad 2 （表示程度深 多用在表示心理狀態的動詞或形容詞後面...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 試驗 : trial; experiment; test
  • 方法 : method; means; way; technique; process; procedure; plan; device; recipe; fashion; tool; maneuver
  1. Standard test method for gross defects and mechanical damage in metallic coatings by polysulfide immersion

    用聚硫化物浸入法測試金屬塗層中總疵點和機械損壞的標準試驗方法
  2. Standard test method for adhesion strength and mechanical failure modes of ceramic coatings by quantitative single point scratch testing

    用定量單點劃痕試驗測定陶瓷塗層粘結強度和機械損壞類型的標準試驗方法
  3. Wood preservatives - test method for determining the protective effectiveness against wood destroying basidiomycetes - determination of the toxic values

    木材防腐劑.防木材被擔子菌綱損壞的效果測定的試驗方法.毒性值測定
  4. Wood preservatives - test method for determining the protective effectiveness against wood destroying basidiomycetes - determination of the toxic values ; german version en 113 : 1996 a1 : 2004

    木材防腐劑.抵禦擔子菌破壞效果測定的試驗方法.毒性
  5. Test method for determination of fire - test - response characteristics of components or composites of mattresses or furniture for use in correctional facilities after exposure to vandalism, by employing a bench scale oxygen consumption calori

    用實驗室耗氧熱量計測定遭破壞后修復設施中床墊或傢具用部件或合成材料燃燒試驗響應特性的標準試驗方法
  6. In the first part of this dissertation, theory of fracture mechanics of the frozen soil has been presented. a general strength theory based on fracture mechanics was proposed, and the validity of the theory using in frozen soil was discussed. the fracture toughness values for different kinds of cracks extension were determined, such as the plane strain fracture toughness for mode i cracking ( kic ), fracture toughness for mode cracking of frozen soil and the intersection of frozen soil and concrete

    論文第二章為凍土斷裂力學的基本理論，包括斷裂力學在凍土研究中的工程適用性、條件適用性、平面應變斷裂韌度測試的適用條件等，給出了凍土斷裂韌度k _ （ c ） 、 k _ （ c ） 、 -型復合斷裂測試的基本原理及試驗方法，並基於weibull脆性破壞理論推導了凍土三點彎曲試樣k _ （ c ）尺寸效應系數，為後面的工作提供理論基礎。
  7. Standard test method for determining stress - corrosion cracking resistance of heat - treatable aluminum alloy products using breaking load method

    用破壞載荷法測定可熱處理鋁合金製品的抗應力腐蝕開裂特性的標準試驗方法
  8. Plain bearings - metallic multilay er plain bearings - destructive testing of bond for bearing metals

    雙金屬結合強度破壞性試驗方法
  9. Plain bearings - metallic multilayer plain bearings - destructive testing of bond for bearing metals

    滑動軸承雙金屬結合強度破壞性試驗方法
  10. In general, both of them are used to verify the results. using geomechanical model test method, the overloading process and wreck character of high arch dam was emulated completely for tengzigou arch dam. it is emphasized for stabilization safety evaluation various major loading function of high arch dam must be accounted and arch dam ' s whole stability is the most important

    本文用地質力學模型試驗方法分析了藤子溝拱壩的超載過程和破壞特徵，並強調無論是超載試驗還是超載計算分析，在評價拱壩安全度時都應綜合考慮各種影響拱壩受力的主要荷載因素，以拱壩整體工作能力作為評價依據。
  11. Durability of wood and wood - based products - determination of the natural durability of solid wood against food - destroying fungi, test methods - basidiomycetes

    木材和木基產品的耐用性.實心木材耐食品損壞菌的天然耐久性的測定.試驗方法.擔子菌綱
  12. Thirdly, to improve the application of light gauge steel structure in our country, some experimentations of institute of new - style steel structure which adopting native productions are induced nally, three - dimensional finite element model is presented. compared with the tests, mumerical results are verified much accurate and efficient, therefore a reliable way is provided to utilize the computational technique adequately to reduce the tests and to utilize the experimental results adequately to improve design quality, ( 3 ) study on floor system. not only adequate strength, stiffness and integer stabilization must be provided, but also insulation, fire and acoustics must be satified

    本文首先論述了lgsfcbw各種破壞模式及其原因，總結了各因素對lgsfcbw抗剪性能的影響，從而為我國引進和應用輕鋼龍骨結構體系奠定了基礎；其次從試驗模型、試驗方法和試驗結果三方面探討了國外lgsfcbw抗震性能的研究，並分析該體系的破壞模式和抗震特性、提出研究建議；然後介紹了為推動輕鋼龍骨住宅國產化，我們採用國產材料開展的系列試驗；最後提出了lgsfcbw的有限單元分析法，數值計算與試驗結果一致，為充分利用計算技術減少試驗數量和充分利用試驗成果提高設計水平提供了一條可靠途徑。
  13. The results of analyzing the fatigue behavior of the specimens in direct tension test, cantilever beam bending test, three point bending test and wheel tracking test by apa show that the fatigue failure regularities of specimens in different tests are different

    關于直接拉伸、懸臂梁彎曲、三點彎曲和往返輪載（ apa ）等疲勞試驗的試件所開展的疲勞損傷分析發現，試驗方法不同，其疲勞損傷破壞規律不同。
  14. Plastics piping systems. joints for glass - reinforced thermosetting plastics pipes and fittings. test methods for leaktightness and resistance to damage of flexible and reduced - articulation joints

    塑料管道系統.玻璃纖維增強式熱固性塑料管件和配件接頭.撓性和減縮型鉸鏈接頭耐泄漏和損壞試驗方法
  15. Test method for rub abrasion mar resistance of high gloss coatings

    高光澤度覆層耐摩擦損壞的試驗方法
  16. ( 3 ) analyzing the main destroying reasons and putting forward evaluating methods of mechanical performance of catalytic converter, the evaluating and testing methods being adopted by technical certificating condition of products ( catalytic converter of exhaust emission of petrol engine ) ) of national environment protecting ( standard number : hcrj1999 - 007 )

    （ 3 ）分析了催化轉化器機械破壞的主要原因，提出了針對我國催化轉化器的機械性能評價方法，該評價和試驗方法已被國家環境保護產品《汽油機排氣催化轉化器》的技術認定條件（標準號： hcrj1999 - 007 ）采納。
  17. Fire hazard testing - part 5 - 3 : corrosion damage effects of fire effluent ; leakage - current and metal - loss test method

    著火危險試驗.第5 - 3部分:燃燒廢氣的腐蝕破壞效應.漏泄電流和金屬損失試驗方法
  18. Standard test method for thermal failure of solid electrical insulating materials under electric stress

    在電應力作用下電絕緣材料的熱損壞的試驗方法
  19. Standard test method for time - to - failure of plastic piping systems and components under constant internal pressure with flow

    在恆定內流動壓力下塑料管道系統和組件損壞時間的標準試驗方法
  20. Metallic multilayer plain bearings - method for destructive testing of bond for bearing metal layer thickness 2 mm

    多層金屬滑動軸承.第2部分:厚度為2mm的軸承金屬層粘合力的破壞性試驗方法
分享友人
分享到 Line

分享到臉書