子樣最小質量 的英文怎麼說

中文拼音 [ziyàngzuìxiǎozhíliáng]
子樣最小質量 英文
minimum mess of increments
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 樣 : Ⅰ名詞1. （形狀） appearance; shape 2. （樣品） sample; model; pattern Ⅱ量詞（表示事物的種類） kind; type
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 小 : Ⅰ形容詞1 （體積、面積、數量、強度等不大） small; little; petty; minor 2 （年紀小的; 年幼的） youn...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 質量 : 1 [物理學] mass 2 （產品或工作的優劣程度） quality 3 economy （離子源的）; 質量標準 quality level...
  1. The stability of electric power system has been being focused for a long time toprevent a power system from losing synchronism after sudden fault ， researchers have done much work and got many accomplishments this paper applied the direct feedback linearization ( dfl ) technique on the power system ， a strong nonlinear system simulation results by matlab proved this method efficiency main works and results are as follows ： this paper compared some existing methods in excitation control ， fast valve control and coordinated control respectively, analyzed the developments and actuality of nonlinear control research in brief, illustrated why ransient stability could be greatly improved by using the fast valve control in chapter 3 ， indicated the importance of coordinated control farther this paper introduced the inverse system theory, based on which ， discussed the dfl theory, pointed out which had consistency with the inverse theory, expanded the dfl theory combined the idiographic model equations ， made which adapt to the model of a single machine - infinite bus power system this paper referenced abundance articles and educed a set of equations ， which could describe the dynamical process of excitation and fast valve control for synchronous generators in the equations ， there were several very important parameters of power system - - rotor angle ( ) ， rotor speed ( ) ， generator q axis voltage ( eq ) ， transient voltage ( e ' q ) ， active power ( pe ) ， mechanical input power ( pm ) ， valve opening ( ) ， generator terminal voltage ( vt ) ， based on the model ， nonlinear coordinated controller and terminal voltage optimal controller have been designed by using the expanded dfl theory and lq optimal control theory the simulation results showed that the controller could keep power system transiently stable under the effects of a symmetrical 3 - phase short circuit fault ， which achieved better postfault regulation compared with another two routine methods ， one is the proportion excitation controller and proportion fast valve controller, the other is the proportion excitation controller and the optimal fast valve controller, which could exert good performance when met 1ittle disturbance either

    在介紹逆系統理論的基礎上，詳細介紹了dfl理論，通過比較闡明了dfl理論其本質是逆系統方法的一類，並結合具體課題推導出的模型方程將dfl理論進行了擴展，使之適應于電力系統這個強非線性對象。通過參考大量的書籍文獻推導出一套實用的可將大型汽輪發電機勵磁與汽門綜合起來進行控制的模型方程，此模型方程涵蓋了電力系統中特別引人注目的幾個量- -轉子角、轉子轉速、發電機q軸電勢eq 、暫態電勢e ' q 、有功功率pe 、機械功率pm 、汽門開度、機端電壓vt ，在此基礎上建立了實用的電力系統簡化的數學模型，並將擴展的dfl理論應用於此模型系統，結合線性二次型最優控制理論設計出大型汽輪發電機的非線性綜合控制器及機端電壓最優控制器，通過模擬實驗與採用常規的按電壓偏差進行調節的比例式勵磁控制器+汽門比例控制及採用常規的按電壓偏差進行調節的比例式勵磁調節器和基於二次型性能指標設計的最優快控汽門（考慮發電機的飽和因素）進行了對比，證實了採用此種控制器可以有效地提高電力系統的暫態穩定性，並且在電力系統遭受小干擾時同樣具有良好的調節性能。
  2. This text completely and systematically studies the status and the development of the pyrolysis and the fluidization of biomass, which distill the bio - oil in the domestic and international area, as well as the existing problems. this thesis primarily include following aspects : ( l ), by experimenting and measuring the energy ( heat value ) and the content of c, h, n chemical element of right 20 kinds of common biomass, on the base of the experimental result, and respectively established the biomass energy predict experiment formula with the element of h and c is from change, and passed the ro. os examination, which provides the basis and convenience for flash pyrolysis fluidization device energy to convert the rate to compute with biomass energy utilization calculation ; ( 2 ), proceeded the tg and dtg experimentation equal velocity ( 10 ? / min, 20 ? / min, 40 ? / min, 60 ? / min ) heating and constant temperature heating by studying on eight kinds of biomass samples, according to the experimental data and arrhenius formula, we established the dynamics model of pyrolysis of, then, using the goast - redfern and p function, we also solved the dynamics parameters and analyze out every kind of biomass ' s frequency factor and parameters of activation energy, and established the every kind of dynamics model of pyrolysis of biomass, all of these provide the theories and basis to make sure the reactor ' s flash pyrolysis work temperature scope design and the describing of pyrolysis reactor dynamics ; ( 3 ), in order to study and ascertain the process of heat completely getting to pyrolysis time of varied size biomass particles, we observed and measured the ratio of length and diameter ( l / d ) with the varied biomass through electron microscope, we concluded the l / d ratios usually is from 5. 0 to 6. 0, the average is 5. 3 ; ( 4 ), we studied the process of biomass transiting and the theory of complete pyrolysis time with the theory of complicated heat field, we got the time ( t ) of the varied size biomass particles arriving to complete pyrolysis, and we knew that the complete pyrolysis time and the time which get to the biggest production ratio are identical, all of these studies provide the theory base for design and forecasting the flash pyrolysis reactor solid state resort time ; ( 5 ), according to the above experiment result, synthesize to make use of the engineering the mechanics, engineering the material, machine the design to learn the principle, deduce, establish the theory of rotation cone flash pyrolysis reactor material resort time ( t ) and reasonable rotation velocity ( or frequency ) relation theory ; and ( 6 ), we gave the reactor ' s smallest cone angle certain, reactor cone wall strength design theory, the reactor production ability theory, the power design method and the critical rotation velocity theory

    本文較全面、系統地綜述了國內外生物質熱解液化制取生物燃油技術研究發展現狀及存在的問題，主要研究內容有： （ 1 ）實驗、測定了20種常見生物質的能量（發熱量）和c 、 h 、 n元素含量，根據實驗結果分別建立了以h和c為自變量的生物質能量預測經驗公式，並通過r _ （ 0 . 05 ）檢驗；為閃速熱解液化裝置能量轉化率計算和生物質能量利用率計算提供了依據和方便； （ 2 ）選擇了8種生物質試樣作了等加熱速率（ 10 min 、 20 min 、 40 min 、 60 min ）和恆溫加熱的tg和dtg實驗，根據實驗數據和阿倫尼烏斯公式建立了生物質熱解反應動力學微分方程，並採用goast - redfem積分法和p函數對其動力學參數進行了求解，解析出各種生物質的頻率因子和活化能參數，進而建立了各種生物質的熱解動力學模型，為科學確定反應器的閃速熱解工作溫度范圍及熱解反應動力學描述，提供了理論和依據； （ 3 ）為研究和確定不同尺度的生物質顆粒中心達到全熱解的時間，在體視顯微鏡下對不同粒度的生物質顆粒的長徑比進行了實驗觀察和測定，得出生物質的長徑比（ l d ）一般在5 . 0 6 . 0之間，平均為5 . 3的結果； （ 4 ）採用復雜溫度場傳熱學理論對生物質傳熱過程及充分熱解時間理論進行了研究，解析推導出了不同尺寸生物質顆粒中心溫度達到充分熱解溫度的時間（ t ） ，得出了理論推導的充分熱解時間與最大產油率的熱解時間相一致的結果，為閃速熱解反應器固相滯留時間設計和預測提供了理論依據； （ 5 ）根據上述實驗結果，綜合運用工程力學、工程材料、機械設計學原理，推導、建立了轉錐式閃速熱解反應器物料滯留時間（ ）與轉速（或頻率）合理匹配理論； （ 6 ）提出了轉錐式閃速熱解反應器的最小錐角設計、錐壁強度設計、生產能力設計理論和功率計算方法及臨界轉速理論等。
  3. ( 2 ) several samples of different structure parameters are grown by low - pressure metal - organic chemical vapor deposition ( lp - mocvd ). it is found that pl peak intensity, full width at half maximum ( fwhm ) and light output intensity are greatly dependent on number of wells. ratio of well / barrier width nearly has no effect on pl peak intensity and fwhm, but has little relation to light output intensity

    通過分析pls ，可以及時獲取材料生長和結構設計的數據，對質量控制有重要的指導意義； （ 2 ）對不同結構的gainp algainp多量子阱樣品進行了光致發光及出光強度的測量，發現mqw的周期數目n對pl峰強度、半峰寬和出光強度的影響最大；阱壘寬厚度比a對pl峰強度和半峰寬的影響較小，但對發光強度的影響較大。
分享友人
分享到 Line

分享到臉書