孔隙率單位 的英文怎麼說
中文拼音 [kǒngxìlǜdānwèi]
孔隙率單位
英文
porosity unit-
The paper divided turbidite fan in deep water from long source into braided channel microfacies, inter - braided channel microfacies, medium fan over - belt microfacies, and external fan subfacies, and divided slump turbidite which related with delta into medium fan subfacies and external fan subfacies, and summed up 15 kinds of marking of subfacies and microfacies classification. at the same time, it formed a series of effective technology of analyzing turbidite source at the base of studying region geological which combined with analyzing the content change of terrigenous debris, with the found of logging facies, and with the ancient terrestrial magnetism test and other technology means under the guidance of three - dimensional model of turbidite which has been founded already and the flat surface feature of microfacies
將遠源深水濁積扇劃分為辮狀水道微相、辮狀水道間微相、中扇過渡帶微相和外扇亞相；將與三角洲有關的滑塌濁積扇劃分為中扇和外扇兩個亞相，並總結了濁積巖沉積劃分各種亞相、微相類型的十四種標志，分別為:巖石類型、層理類型、砂巖單層厚度、粒度結構特徵（粒度中值、分選性、概率曲線） 、生物化石、儲層物性（孔隙度、滲透率） 、泥巖隔層特徵（泥巖單層厚度、層數、顏色） 、鮑瑪層序組合和自然電位曲線特徵。The particles aggregation was simulated using particle - cluster and cluster - cluster aggregation model. several type of floes was reached and its morphological characteristics was analyzed the fractal dimension, density and porosity of floes was studied by changing sticking probabilities, sticking position, particle number, particle concentration, difrusion coefficient and motion trajectory. the parameters by which special floes growth were determined. in the study of morphology, floes of yellow river ' s loess particles was observed by tv - microscope. its morphological characteristics were obtained by image analysis. the effect of fractal dimensions by stirring time strring speed, macromolecule flocculant dosage, flocculant concentration and particle concentration was studie. its rule of change was obtained. on the basis of other studies, the flocculation kinetics and floes structure was studied
本文應用計算機模擬技術，在二維空間內採用單體凝聚和集團? ?集團凝聚兩種模型對顆粒凝聚過程進行了模擬，得到了多種形態的絮體，並對絮體進行了形態分析，通過改變粘附概率、粘附位置、顆粒數量、顆粒濃度、擴散系數和運動路徑等模擬參數，我們考察了絮體分形維數、密度和孔隙率隨模擬條件變化的影響規律，得到了形成特定形態絮體的控制參數。In this work, pluronic f127 was used as a progen and different biodegradation rate and surface property as amorphous calcuim phosphate, a - calcuim triphosphate, - calcuim triphosphate and a / p - calcuim triphosphate were selected to make three - dimensional porous composites with plla. in the phase separation of pure plla or cp / plla composite system the ppo block of pf127 can aggregate plla clew to induce phase separation. this resulted big round pores of 50 ~ 300 m and uniform ladder - like structure of 400 ~ 1000 m
具體結果如下：浙江大學碩士學位論文在單純的聚乳酸以及鈣磷酸鹽/聚乳酸復合體系的相分離過程中， pf127的ppo鏈段對plla鏈段有聚集作用，促進相分離過程，在不同溶劑中分別可得到孔徑在50一300林m的較大的圓孔和有序度為400一1000林m的梯狀孔，孔隙率為80 % ~ 93 % 。
分享友人