室壓 的英文怎麼說

中文拼音 [shìyā]
室壓 英文
cell pressure
  • 壓 : 壓構詞成分。
  1. A perturbation in pressure at the upstream end of the feed system could result in sizable oscillations in flow rate and chamber pressure.

    供應系統上游端的壓力擾動可導致相當的流量和室壓振蕩。
  2. With the pressure in the simulated right ventricle ( srv ) and simulated left ventricle ( slv ) kept constant ( standard pressure condition for model iii ), each step of pressure decrease in the scc from 0 mmhg to - 5 mmhg, the sivs moved leftwards ( to the slv direction ) in a corresponding position and from 0 mmhg to + 5 mmhg, the sivs swung left - and rightwards at amplitude of 2. 2 mm. effects of intrathoracic pressure change on the motion of ivs under the same simulated respiratory

    胸壓變化對室間隔運動的影響當模擬右心室和左心室壓力一定時，模擬胸腔內壓力每一次下降（從到一smmhg人模擬室間隔均向左側移位；當模擬胸腔內壓力相同，隨模擬右心室壓力的升高，模擬室間隔的運動幅度增大，當模擬右心室壓力升高到與模擬人心室相等時，模擬室間隔的運動幅度達最大。
  3. They varied both chamber pressure and mixture ratio, making use of a stepfunction change in the oxidizer injection rate.

    他們通過用氧化劑噴射速率階躍函數變化的方法來改變氣室壓力和混合比。
  4. It is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level

    在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制
  5. Abstract : it is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level

    文摘:在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制
  6. Standard test method for cbr california bearing ratio of laboratory - compacted soils

    實驗室壓實泥土的cbr
  7. In addition, we also provide repairing and maintaining service for other brand equipment cold or hot die - casting machines, injection mould machines and hydraulic machine, etc

    同時為了更廣泛地服務于工業界，本廠可提供對其他品牌的各類機器包括冷熱室壓鑄機注塑機油壓機的維修服務，熱誠歡迎來電查詢。
  8. An intriguing question arises when chamber pressure is greater than critical.

    當室壓高於臨界壓力時引起一個有趣的問題。
  9. The ultimate goal of a simulation is to approximate chamber pressure so as to detect and define the source of undesired pressure variation.

    模擬的主要目標是在接近室壓下探測和確定不希望有的壓力變化的來源。
  10. Chamber pressure record

    燃燒室壓力記錄
  11. Cold chamber pressure casting

    冷室壓鑄
  12. Design optimization of chamber pressure and nozzle area expansion ratio of solid rocket motors

    固體火箭發動機燃燒室壓強及噴管擴張比優化設計
  13. The results indicate that with the coefficient of residual oxygen being less than 1 or around 1, when the fuel is injected into the combustor at the same combustor pressure, the higher the combustor temperature is, the less the coefficient of residual oxygen is when auto - ignition occurs ; when the fuel is injected into the combustor at the same combustor temperature, the larger the combustor pressure is, the less the coefficient of residual oxygen is when auto - ignition occurs ; when the fuel is injected into the combustor at the same combustor temperature and pressure, the bigger the coefficient of residual oxygen is, the more easily auto - ignition occurs

    研究結果表明，當推進劑處于余氧系數小於1或略大於1時，在燃燒室壓力相同的情況下噴入燃料，燃燒室溫度越高，可自燃的余氧系數越小;在燃燒室溫度大致相同的情況下噴入燃料，燃燒室壓力越高，可自燃的余氧系數越小;在燃燒室溫度、壓力大致相同的情況下噴入燃料，余氧系數越高，自燃發生的可能性越大。
  14. The method is described as follows : the velocity of the moving part and the gas chamber pressure were measured with a dynamic test measurement system ; a dynamic model was built on force analysis of the moving part ; the total kinetic resistance replaced the horizontal friction and water resistance ; then the resistance - velocity relation curves at moving stages were obtained ; with the empirical formula of the gas chamber pressure and the resistance - velocity relation curves, the preliminary dynamic characteristics were analyzed and the structural form and key parameters of an underwater assault rifle were determined

    具體方法為：由動力學測量系統測得活動件速度和氣室壓力；分析活動件的受力，建立動力學模型；以運動總阻力代替水平方向上的摩擦阻力和水阻力，獲得各運動階段的阻力速度關系曲線；利用氣室壓力經驗公式和阻力速度關系曲線，對水下突擊步槍進行初步的動力學分析，確定其構造型式及主要參數。
  15. Room pressurization test. this test is to verify that there is a proper amount of positive / negative room air pressure

    潔凈室壓力測試。該項試驗用於檢驗潔凈室正/負氣壓的合適性。
  16. This paper develops a whole - course alarm unit for pulsing vacuum high - pressure steam sterilization to monitor hydraulic pressure, vacuumizing ability, sterile time, sterile pressure and drying time. the unit alarms if any parameter mentioned above is out of order

    現特設計一種滅菌全過程監測的報警裝置，可對水源壓力、高壓蒸汽滅菌器真空度、滅菌器夾層壓力、滅菌器內室壓力及計時進行實時監測，當任一程序在使用中出現異常時，報警裝置將發出準確部位的報警信號，提醒工作人員及時排除故障，保障滅菌效果。
  17. Furthermore rev of motor of regulation mode is altered the original strap transmission mechanism for changing frequency mode, which can be avoid error that is caused by mechanism

    本控制系統主要模擬回轉式密封環的工況，並根據所採集的油室壓力的性能曲線判斷回轉式密封環性能的好壞。
  18. Zinc, aluminium or copper alloys ), degassing flux for aluminium or copper alloys, coating paste, spare parts for hot chamber or cold chamber die casting machines, plunger rings and hot work steel

    油、超高級白油、潤滑脂、 （鋅、鋁、銅合金）化渣粉、除氣劑、坩堝塗料、冷熱室壓鑄機配
  19. The precondition of establishing mathematics model of torpedo turbine system in design condition is to fulfill the external conditions ( such as torpedo sailing speed and depth etc. ) and inner conditions ( such as turbine power and efficiency etc. ). after establishing mathematics model of torpedo turbine system in design condition, we compiled simulation program to compute all kinds of inner parameters of turbine engine include engine type, principal layout of turbine, inner structure of turbine and state parameters of gases

    首先分析設計工況時渦輪機動力系統，在滿足魚雷動力系統的各項外部條件（如魚雷航深、航速等）和內部條件（如渦輪機功率、效率，燃燒室壓力、溫度，轉子機械強度等）的前提下，建立起設計工況渦輪發動機的數學模型，編程計算並確定渦輪機內部機械結構和燃氣熱力學狀態各參數。
  20. Much works has been distributed to the development of a vacuum system to simulate the outer space and a measurement system to test the arcjet performance. ignition experiments in various operational modes have been done with argon as propellant. macroscopical working parameters including thrust, mass flow rate, voltage, current, inlet pressure and vacuity are obtained by the test measurement system and actual performance parameters including specific impulse, thrust efficiency, ratio of thrust and power and ratio of power and mass flow are calculated

    以氬氣作為推進劑，在不同工況下進行點火實驗，測量獲得了其工作推力、電弧電壓和電流、推進劑流率和弧室壓力等宏觀參數，得到了不同實驗條件下其工作的實際比沖、推力效率、推力/功率比以及比功率等性能參數，分析了推進劑質量流率、電弧功率、電弧加熱發動機電弧室結構尺寸等因素對其性能的影響，為數值模擬研究和實際的低功率電弧加熱發動機優化設計及研製提供了實驗基礎。
分享友人
分享到 Line

分享到臉書