寬堰 的英文怎麼說

中文拼音 [kuānyàn]
寬堰 英文
flat-crested weir
  • : 名詞(較低的擋水建築物) weir
  1. Standards for municipal wastewater discharge measurement. broad - crested weir

    城市排水流量槽測量標準.
  2. Liquid flow measurement in open channels. round - nose horizontal broad - crested weirs

    明渠液體流量測量.圓頭水平
  3. Standard test method for open channel flow measurement of water with broad - crested weirs

    測量明渠水流量的標準試驗方法
  4. Methods of measurement of liquid flow in open channels - weirs and flumes - rectangular broad - crested weirs

    明渠流量測量.第4部分:溢流和斜槽.第4e節:矩形
  5. Methods of measurement of liquid flow in open channels - weirs and flumes - round nose horizontal broad - crested weirs

    明渠流量測量.第4部分:溢流和斜槽.第4f節:圓端水平
  6. So the labyrinth weir is particularly suited for use where the discharge structure need to enlarge the ability of outflow but the width is restricted the labyrinth weir could be divided into straight - labyrinth weir and curve - labyrinth weir in this paper

    因此,迷宮特別適用於泄水度受限,但又需提高泄流能力的泄水建築物中。本文將迷宮分為直線型迷宮和曲線型迷宮
  7. The effect of gas rates, liquid flow - rates, downcomer width, weir height and the addition of surface active agent on the liquid mean residence time, t, effective diffusion coefficient, de, and froth height, hf were studied. results obtained showed that for two systems, the t in the downcomer of ctst plate is 20 - 50 % smaller than that of fl valve plate, and the de is 40 - 70 % smaller than that of fl valve plate

    通過對氣速、液體流量、降液管度、高和表面活性劑加入的影響進行分析得出下面結論:在相同的操作條件下,對于兩種物系, ctst塔板降液管的液體停留時間比f1浮閥塔板的約小20 50 ,有效擴散系數比f1浮閥塔板的小40 70 ,泡沫高度低110 150mm 。
  8. The labyrinth weir is a special kind of practical and effective weir patterns. it can evidently increase the discharge for a given outflow width

    迷宮作為一種實用高效的特殊型,它在不改變泄水度的情況下,可大幅度提高過流能力。
  9. Methods of measurement of liquid flow in open channels - weirs and flumes - v - shaped broad crested weirs

    明渠流量測量.第4部分:溢流和斜槽.第4i節: v形
  10. Liquid flow measurement in open channels by weirs and flumes. rectangular braod - crested weirs

    用溢流和水槽測定明渠中的水流量.矩形頂溢流
分享友人