層狀形變 的英文怎麼說
中文拼音 [céngzhuàngxíngbiàn]
層狀形變
英文
laminal deformation-
Phenomenology research on deformation and failure modes of slopes composed of argillaceous limestone of the third number of badong group in new site of fengjie county of three gorges reservoir area
三峽地區奉節縣城緩傾層狀岸坡變形破壞模式及成因機制There are typical laminated structure, soft sedimentary - slipping deformed structure, syngenetic brecciated structure in the ore which are the mirror of syngenetic sedimentation. the other type of ore has the charactristic of epigenetic mineralization, which is called as telescoped ore. the ore occurs in vein, pocket, lensoid and bedd
礦石中發育典型的紋層狀構造、軟沉積滑動變形構造、同生角礫構造等反映同生沉積特徵的礦石構造;另一類礦石具有明顯的後生成礦特點,稱之為疊生改造型礦石,礦石產于脈狀、囊狀、透鏡狀及似層狀礦體中,與燕山期巖漿巖及斷裂裂隙構造關系密切。The activities of the cambium - like meristem present in the early affected trees lead to formation of the deformed bark of the trees in the late stage of the disease
早期感病樹中出現的形成層狀分生組織的活動導致晚期病樹樹皮的變形。The spectrum of layered magnetic system and conformal invariance
層狀磁系統能譜及共形不變性When the plane was heated, observation showed that the shape factor increased from 1. 5 to 2. 6 ; the mean velocity profile departed from the law of the wall ; the inertial subrange in the energy spectra curves disappeared ; the intermittent phenomenon occurred
發現在加熱的情況下,邊界層的形狀因子由1 . 5上升至2 . 6時均速度廓線中的平衡湍流層消失以及速度能譜中慣性子區消失等變化。The microstructure of lamellae pearlite has evolved ultrafine cementite particles throughout the ferrite matrix uniformly after five passes. the ferrite matrix is homogeneous grains, average grain size is - 0. 3 m. 2
變形五道次后,片層狀的珠光體組織演變成了超細的滲碳體顆粒均勻分佈於鐵素體基體的組織,鐵素體基體為均勻的等軸晶,平均晶粒大小為0 . 3 m 。The main results are as the following : ( 1 ) the microstructure of lamellae pearlite has evolved ultrafine cementite particles throughout the ferrite matrix uniformly after four passes. the ferrite matrix is homogeneous grains, and average grain size is - 0. 3um
主要結果如下: ( 1 ) ecap變形四道次后,片層狀的珠光體組織演變為了超細的滲碳體顆粒均勻分佈於亞微晶鐵素體基體的組織。The results indicate that if the value of press stress is over certain figure, press stress and al plate ’ s thickness have little influence on sawtooth distortion for the same kind of sawtooth ; sawtooth distortion is well - regulated under static press, while it is irregular under impact press. bottom coating make great influence on bond strength of samples which can improve the value remarkably ; bonding mechanism of clad steel is mechanism of mechanical effect that sawtooth which is hooked occludes with al plate
結果表明:同種齒型,當壓應力大於一定的值時,壓應力和覆板的厚度對齒形的變化影響不大;靜壓下齒形變化比較規則,鋸齒頂端向一側彎曲成鉤狀;沖壓下齒形比較凌亂,鋸齒的頂端沒有明顯的變形;后處理對試樣的結合強度影響很大,打底試樣由於粘結層的作用,結合強度較高;機械作用機制是復合鋼板的主要復合機理,鋸齒彎曲成鉤狀和鋁板形成機械咬合。In this thesis, some key issues of the vr technique are systematically investigated. firstly, for the image filters and image interpolation between slices, a integrated interpolation algorithm is presented based on the contour shape and correspondence matching, which keeps the shapes and grays information the objects of interest. secondly, the fidelity of effect of the vr for medical images is studied, and a continuous - gradient - based method for transparent volume rendering is proposed, which vivifies the results of volume rendering
首先,研究了醫學斷層圖像數據的濾波及層間插值技術,提出了一種基於輪廓形變和對應點匹配相結合的混合插值演算法,在實現圖像層間插值的同時保持了目標的輪廓形狀與灰度信息;其次,對醫學影像容積重建效果的逼真度進行了研究,提出了一種基於連續梯度轉換函數的互動式透明體繪制方法,使重建效果更加生動、真實。Treating the soil as a two - phase mixture and considering the interactive influence of seepage and solid deformation, this paper analyzes the dynamic impedance of group piles in layered saturated porous media by indirect boundary element method and investigates the effects of pore fluid in saturated soils on dynamic impedance of piles
摘要將飽水軟土地基視為兩相介質,考慮水的滲流和土骨架變形的耦合作用,用間接邊界元法分析層狀飽水軟土地基中橫向受荷群樁動力阻抗,探討飽和土中孔隙流體對飽和土中橫向受荷群樁動力阻抗的影響。In the paper, other research results are summarized, and a big test model indoor of row pile retaining and protecting deep foundation pit is designed. for homogeneous soil or samdwich soil structure three different retaining and protecting kinds : dense pile, thin pile and without pile are designed, using excavation simulation and loading on the top of slope, the model test is divided into two stages : foundation pit excavation simulation stage and destroy test stage. in this paper, for three different retaining and protecting kinds, the relation between soil pressure and displacement of piles, the relation between soil stress and strain, interaction of pile and soil and retaining and protecting loss - stability destroy are systemic studied
本文總結了前人研究成果,構築大型室內深基坑排樁支護試驗模型,在均質及層狀土層結構地基上,設計了密排樁、疏排樁及無支護三種不同支護型式,採用模擬開挖與坡頂均布加荷方式,進行了模擬基坑開挖和破壞性的兩個階段試驗,對三種不同支護型式的土壓力與樁位移、土體應力與變形、樁土共同作用及支護結構失穩破壞進行系統研究。In numerical calculations, the effects of rainfall pattern, shape of slope layer and changing slope to the development and decline of subsurface flow were examined
數值計算驗算了降雨的方式,斜坡地層的形狀以及坡度的變化對地下水位進展和衰退過程的影響。With the different loading ratio of parallel to axis and normal to axis direction, damage defects will occur bulking problem. by varying the degree of material anisotropy relative to the loading axis such as poisson ' s ratio and shear modulus, crack growth bulking strain value parallel to or normal to the loading axis is different. the parameters controlling the growth or arrest of the delamination damage are identified as the geometry and the depth of defects and radius of cylindrical etc. at last, it was investigated that the delamination damage is often induced by the tip of matrix damage under higher stress
研究結果表明:殼體筒段受軸向拉伸和內壓載荷作用時,軸向和環向載荷的比率不同,母層和子層可能發生拉伸屈曲,也可能發生收縮屈曲,或者同時發生拉伸和壓縮屈曲;母層與子層各向異性存在差異,即泊松比與剪切模量不匹配時,將使子層板的邊界上承受壓縮和剪切作用,當分層達到臨界狀態則發生屈曲,當母層與子層的各向異性差異越大,則發生分層屈曲的可能性越大;分層損傷的屈曲應變值與子層自身的彈性模量、分層子層的形狀、厚度以及圓柱半徑等因素有關。As annealing temperature is 400, the phase of fexsy is greigite ( fe3s4 ) the fexsy particles cover the porous film of tio2. the average size of fexsy particles range from 5000nm to 20nm as the concentration of the starting solution decreasing. after five times of coating - annealing process, fexsy particles form aggregate in size of 10 m
鐵硫化合物顆粒覆蓋在多孔tio _ 2基底上,顆粒尺寸隨著初始溶液濃度減小從幾個微米減小到十幾個納米,隨著塗膜厚度、退火時間增加,鐵硫化合物的形貌按顆粒狀島狀層狀變化。At first, the mechanical model of joint is discussed, and the constitutive relation of the rough joint, especially the bolt - supported joint, is given. then bedding slide of bedding stratified rock slope is studied adopting limit equilibrium method, and a formula of stability is brought forward. at last, the bedding stratified rock slope ' s buckling deformation and failure mechanism and its evaluating method of stability is investigated, a corresponding mechanics model is established, then detail research to this failure mode is made in theory combining the energy law and elastic stability theory of plate and beam, and an analytical solution of the yielding curve is educed from this model
文中首先對結構面的力學模型進行了一定的探討,提出了粗糙結構面尤其是加錨結構面的本構關系;然後採用極限平衡法,研究了順向層狀巖質邊坡的順層滑動失穩,提出了其穩定性計算公式;最後,結合能量定律和彈性板梁穩定理論,探討了工程中常見的順向層狀巖體邊坡潰屈失穩時的破壞機理、變形規律和穩定性定量評價方法,建立了相應的力學模型,求出了其相應的解析解,並提出了臨界坡長與最大彎曲位置的確定方法。The process and mechanisms of slipping, exfoliation to layered graphite and compounding with polypropylene ( pp ) on nano - scale were systemically studied. the effects of shearing force field offered by pan - milling and confined environment of the exfoliated graphite on the microstructure of polypropylene, the electrical and thermal conductivities of the nanocomposites were also investigated. based on the experimental results, a modified electrical conductive model as well as thermal conductive model for polymer - based composites was proposed
利用層狀無機物(如石墨)的弱層間結構和聚合物的粘彈性特點,在磨盤碾磨剪切力場作用下,通過摩擦和拉伸形變錯位、擠壓嵌合、拉伸滑移、剪切剝離與粉碎和混合分散等過程,實現層狀無機物層間剝離和與聚合物的納米復合。In recent years, theories of elastic foundation and layers elastic body system have been widely applied and perfectly developed, but the theories often consider the medium as continuous, elastic, homogeneous, isotropy and submitting to small deformation hypothesis, and the anisotropy of the material has not been introduced
近代發展的彈性地基和層狀彈性體系理論認為介質是連續、線彈性、均勻的和各向同性的,服從小變形的假設,沒有考慮材料的各向異性。Therefore, this paper makes a research of the stability of bedding stratified rock slope
本文主要對順向層狀巖質邊坡的變形破壞機理與穩定性進行研究。Slice - imagings interpolation can creat new slices. this dissertation presents a gray - level matching interpolation method based on object gray - level distribution probability knowlege, through which we can get more clear scene at the boundary between different matters than that in traditional interpolation methods. with respect to non - similar shapes or no superposition of corresponded contours on adjacent slices and concave contours, this dissertation introduces a method based on variant shape - based interpolation
提出了一種基於對象灰度概率知識引導的對應點匹配的灰度插值演算法,解決了傳統灰度插值的不同種對象物質交界處的模糊問題;對于只關心物體邊界和重構目標形態信息的情況,介紹了當相鄰斷層上的對應輪廓線的形狀不相似,位置差異大時,利用改進的輪廓加權平均演算法進行輪廓形變插值的方法。The mechanical properties of the modified nano ~ cac03 / pp is better than that of unmodified nano - cac03 / pp, especially the impact strength has been improved greatly. but when the dosage of nano - particles is too much, those nano particles will accumulate and this will lead to decreasing of strength of the material. through investigated of xrd and dsc, we found that ? - pp was formed by addition of nano - particles
通過xrd和dsc分析發現,納米粉體對- pp有誘導生成作用:通過sem分析發現表面改性后的納米粒子填充即后,與pp基體結合較好,基體在沖擊方向存在層狀滑移,並有纖維狀形變,顯示基體發生了剪切屈服形變。分享友人