峰值功率控制 的英文怎麼說

中文拼音 [fēngzhígōnglǜkòngzhì]
峰值功率控制 英文
peak power control
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 功 : 名詞1 （功勞） exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. The results show that wavelength locates in gain zone of semiconductor optical amplifier, and have higher peak power and proper time delay between the two pulses for the second order super gauss control pulse in semiconductor optical amplifier. a high quality amplified signal pulse can be achieved. the chirp can be reduced notability by using cascading soa in cross gain modulation based on soa, and the distance and the peak power of conversion optical pulse can be increased notability, and we can let down the demand for wavelength based on xgm in soa and enhance the flexibility of wavelength conversion

    我們應用二階超高斯光脈沖與高斯信號脈沖同時注入soa和應用soa與非線性光學環鏡（ nolm ）相結合的方案來對信號脈沖進行壓縮整形，模擬顯示，在調節系統合適參數的情況下，波長位於soa增益區的二階超高斯控制光脈沖在具有較高的峰值功率和適當時延下輸入soa時，最後可以得到放大的高質量超簡訊號光脈沖；在基於soa的交叉增益調制（ xgm ）全光波長轉換中，採用級聯的soa能有效地使反轉光脈沖的頻率啁啾得到有效降低，波長向下轉換的距離和反轉光的峰值能量都得到明顯提高，降低了利用交叉增益調制（ xgm ）波長轉換中對波長精度的要求，從而提高了波長轉換的靈和性。
  2. In succession, tini thin film is deposited on single - crystal silicon substrate using optimized parameters utilizing sputtering, and its transformation temperature ( a * ) is 72 ? indicated by dsc curve after being annealed in an ultra - high vacuum ( uhv ) chamber. in addition, the composition of the silicon - based tini film was analyzed by an energy dispersive x - ray spectroscopy ( eds ), and the ti content in the film is approximately 51at %

    按照改進的工藝參數，在單晶硅襯底上濺射-淀積了tini薄膜，並進行了超高真空退火， dsc法測得其馬氏體逆相變峰值溫度為72 ，利用能譜分析（ eds ）技術測得其ti含量約為51at ，通過對非晶tini薄膜與單晶硅襯底之間的界面進行eds及x射線衍射（ xrd ）分析，發現在用大功率（ 2000w ）直流磁控濺射法制備tini薄膜過程中，存在ti 、 ni與si的雙向擴散，發生了界面反應，並有三元化合物ni _ 3ti _ 2si生成。
  3. Compare to the operation under the dcm mode, the power switches of the inverter under the ccm mode has lower peak current and rms current, so the efficiency can be improved. as the synchronous rectification strategy can reduce the conduction losses of the rectifier, and also due to the zvs realization of all synchronous rectifiers, the

    採用非互補導通控制，在ccm模式下由於功率管電流峰值和有效值的減小，逆變器變換效率較dcm模式下有所提高;另外， ccm模式下，反激逆變器採用同步整流控制，減小了整流二極體的導通壓降，並且電路中同步整流管可實現零電壓開通。
  4. Based on the analysis and comparison of the peak current - injection mode and average current mode control strategies, the method of designing average current control mode pi regulator is obtained. the digital simulation of the converter has been done with the help of matlab software. the good transient and stable character of the converter is attained while rated load

    在分析與比較峰值電流模式與平均值電流模式控制策略的基礎上，給出平均值電流模式pi調節器的設計方法，利用matlab軟體對變換器進行了數字模擬，證實了變換器在額定功率范圍內動、靜態特性良好；過載情況下變換器具有自動限流、保護主功率器件的特性。
  5. Design of peak - current control circuit for high - power soft - switch inverter

    大功率弧焊逆變器峰值電流控制電路設計
  6. So special burst - mode transmitters and receivers should be adopted at up - stream transmission. the main purpose of the thesis is to research 155mb / s burst - mode transmitter applicable for apon system. with peak - detection automatic power control technology, laser diode is successfully used as light source to emit burst optical signals

    本次論文主要工作是完成apon系統中155mb s突發模式光發射模塊的研製，通過採用峰值檢測的自動功率控制技術，成功的實現了半導體激光器（ ld ）做光源發出突發光信號。
分享友人
分享到 Line

分享到臉書