幀結構控制 的英文怎麼說

中文拼音 [zhèngjiēgòukòngzhì]
幀結構控制 英文
frame structure control
  • 幀 : 量詞（幅, 用於字畫）
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. It is composed of three mian protocols : call synchronization protocol, control frame transmission protocol based on arq mechanism and data transmisstion protocol based on slot precontract mechanism. one scan channel table is shared in the hfmanet. the nodes in the same dwell group work in the same scan channel, and the nodes in the different dwell group work in the different scan channel

    該協議的網路拓撲結構採用分散式分群結構，協議不同於傳統的短波點到點及需要中心節點轉發的組網方式，而是初步實現了短波電臺之間多跳組網功能，其協議內容主要包括同步呼叫協議、基於arq的控制幀傳輸協議和基於虛電路及時隙預約方式的數據幀傳輸協議。
  2. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影（ dsa ）成像系統的組成結構和數據流向進行了深入研究和分析，並對系統中的數據流向進行了完整的歸納和總結，給出了x線數字成像系統中的高速大容量數據通道的設計方案；在對sdram的控制方式做了深入探討后，給出了實現大容量多條sdram共同工作的解決方案，在此基礎上設計了大容量幀存板實現對圖象數據進行高速存儲；通過對pci總線介面的深入研究，優化後端狀態機設計和低層驅動程序開發，給出了完整的pci介面方案實現高速dma數據傳輸，完全可以滿足視頻傳輸要求；深入研究了基於大規模可編程器件的數字系統設計方法，針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點，提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案，從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。
  3. Consequently, the author presents the basic principle of ofdm, and the process how to utilize the certain technology based on fft & ifft to realize the ofdm system

    描述了802 . 11協議介質訪問控制層和物理層的操作及幀結構。接著，作者論述了ofdm的基本原理，以及如何用基於fft和ifft的技術實現ofdm系統。
  4. Computers, may 2000, 49 : 443 - 464. 6 han jungang, wang yanbing, shen wuwei. describing and verifying the behavior of hardware in xyz e language

    首先提出增強型進程式控制制樹，該結構可以清晰地表徵每一時間幀語句的執行情況，以及截止到該時間幀，語句的可觀測性情況。
  5. Many network users use tcp / ip protocols that were composed of a series of protocol layers to finish their communication tasks. the user ' s data information is divided into a great many of data blocks. when the data blocks are transported through the layers of the protocols, they are added the controlled information in their headers

    網路用戶終端大多使用tcp / ip通信協議完成信息的傳輸任務， tcp / ip協議是層次結構的通信協議，用戶數據信息被劃分成一個個的數據分段，經過各層協議時，添加上各層協議的控制信息，作為數據分段的頭部信息，這個頭部信息說明了各相應層通信的規則，數據分段經各層封裝后最終形成物理數據幀通過物理鏈路送到通信網路上傳輸。
  6. Moreover, video control program to implement internal function of fpga is designed including video capture time sequence control, ping - pang frame buffer read and write time sequence control and lcd display time sequence control, and program ' s simulation and analysis is also provided. at last, this paper presents a portable iv ' s video processing system, and proposes three buffer strategy to control capture buffer. and a moving object detection algorithm of combing an adaptive background subtraction technique with a three - frame differencing is adopted

    設計了基於fpga系統結構的車載視頻顯示電路板；利用單片機io口模擬i2c時序，實現了視頻解碼晶元控制；利用fpga實現視頻控制，研究了採集通道時序控制、雙幀存ram讀寫時序控制及lcd顯示時序控制的方法，並進行了軟體模擬和分析；設計了車載視頻檢測系統方案，給出了管理採集緩沖區的三幀緩沖策略，採用綜合三幀差分和自適應背景相減的演算法實現運動檢測，連通體檢測去除虛目標，模擬實驗證明其有效性，同時分析了該演算法在dsp視頻檢測系統中的簡單實現方法。
  7. The mpls technology was raised just in order to make the most of the switching technology in the core of the network and the ip routing technology on the edge of the network. before presenting the solution of the mpls, there are many integration model, the basic method adopted by them were all carry the control information from the ip router, and combine it with the transmition capability and the label switching of the atm switching machine, accordingly constructing a high speed and economic multi layer switching router. but, all these solutions can not communicate and just suit for adapting the atm as the second layer transmiting link, can n ' t work on other interface ( fr, ppp, and ethernet ), this is obviously conflict with the developing way of the based on packet of the internet

    多協議標簽交換（ mpls ）技術就是為了綜合利用網路核心的交換技術和網路邊緣的ip路由技術各自的優點而產生的。在mpls技術方案提出之前已有的各種集成模型解決方案所採取的基本方法都是從ip路由器獲取控制信息，將其與atm交換機的轉發性能和標簽交換方式相結合，從而構建成一個高速而經濟的多層交換路由器。但是，各種方案彼此不能互通，而且僅適用於以atm作為第2層的傳輸鏈路，不能工作在其他多種媒體（如幀中繼、點對點協議、以太網）中，這與internet基於分組的發展方向相矛盾。
  8. A real time control protocol for simplex applications using lsd hsd mlp channels of the fram structue for a 64to 1920kbit s channel in audiovisual teleservices

    採用視聽電信業務中64 1920kbit s通道幀結構的lsd hsd mlp通道單工應用的實時控制協議
  9. Information processing systems - data communication - high - level data link control procedures - frame structure

    信息處理系統-數據通信-高級數據鏈路控制規程-幀結構
  10. In the first part of this thesis, current situation of the access network and the technical of pon are introduced briefly. then, the epon system structure, osi protocol model, especially the mpcp sublayer are introduced, the epon control frame and data frame changed form ethernet frame are analyzed

    本文首先介紹接入網技術的發展狀況和無源光網路的主要技術類型，以及epon系統的網路結構、 osi分層模型，重點介紹epon系統特有的mpcp子層，分析epon系統對以太網數據幀所做的修改和新添加的epon控制幀。
  11. It involves the communication between the visualgenserver and system of tower simulator, the communication between the visualgenserver and visualgenclients. frame control and the synchronization of visualgenclients. in the third part, we present the design and implement of visualgenclient, which deals with how to realize the render of a scene using 3d graphics engine performer

    摘要2 ）著重介紹視景服務器的設計和實現，在此部分涉及到了視景服務器自身的體系結構、鍵盤和鼠標事件處理、視景服務器和塔臺模擬機系統服務器之間的通訊、視景服務器和從視景位之間的通訊，幀率控制以及如何控制從視景位的同步等。
  12. 1 ) realization of software packet embedded in m - es and md - is respectively to accomplish main function of mdlp, including assignment of tei ( temporary equipment identifier ), establishment of multiple frame operation, framing, flow control and error - free transmission of packets, is detailed. 2 ) a test model is established to evaluate the robustness and stability of mdlp and verify the validity of software packets. 3 ) according to the design of radio modem construction used in m - es, the modules of interface between data terminal equipment and radio modem are achieved to enable transmission of short message and continuous pseudo - random bit stream via rs232 uart

    本文首先概述了蜂窩數字分組數據網的結構和空中協議，詳細分析了移動數據鏈路協議，並在此基礎上，重點敘述了以下方面的工作： 1 ）設計並完成了分別應用於m - es和md - is端無線控制器的兩套程序實現數據鏈路層的主要功能，包括分配臨時設備號、建立鏈路、組幀和面向連接的服務保證分組正確無誤地傳輸，並進行適當的流控； 2 ）建立測試模型測試移動數據鏈路協議的可靠性和穩定性，證明了程序包的效用； 3 ）根據cdpd系統無線數據機的軟硬體總體設計方案，完成了介面模塊，實現了rs232異步串口通信，使用戶可以根據需要發送短消息或連續的偽隨機比特流； 4 ）在tms320c54x的軟體、硬體模擬平臺上，建立了cdpd試驗模型，實現了cdpd系統的mdlp基本功能。
  13. In the scheme of scene control, we apply a new algorithm to accelerate the display of the scene by computing the relativity of the output frames. we use this scheme in scene display

    在植物場景輸出優化控制中，本文首先探討了如何利用幀間相關性和幀內掃描線相關性來構造相關性加速演算法，並採用基於圖形和基於圖像的方法輸出場景的實驗結果。
  14. Main contents of this thesis include following parts : firstly the frame format and frame type in 802. 11b are summarized. two mac layer access methods : dcf ( distributed control function ) and pcf ( point control function ) are deeply analyzed. physical layer, management entity and security mechanism are generally narrated

    全文內容主要包括以下幾部分：第一部分總結了802 . 11b協議中的mac層幀結構和幀類型，較深入地分析了mac層的pcf （中心網控方式）和dcf （分散式接入方式）兩種接入方式，概述了物理層、管理實體和安全機制。
  15. 3. implementing the serial communication between the cms and lms. putting forward two rules for software flow control and data transmission, as well as implementing the relevant design for command frame, return frame and data frame of them

    （ 3 ）解決了cms與lms之間的串口無線通信問題，提出了一種軟體流量控制規程與數據傳輸規程，並設計了相應的命令幀、回應幀及數據幀的結構。
分享友人
分享到 Line

分享到臉書