弧形支架 的英文怎麼說

中文拼音 [xíngzhījià]
弧形支架 英文
scythe support
  • : 名詞1. [數學] (圓周的任意一段) arc2. (古代指弓) bow
  • : Ⅰ名詞1 (分支; 支派) branch; offshoot 2 (地支) the twelve earthly branches3 (姓氏) a surname...
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  • 弧形 : arc; curve弧形避雷器 arc-arrester; 弧形槽 arc wall; 弧形構造 arc structure; 弧形閘門 [水文] radial gate
  • 支架 : support; stand; trestle; holder; rack; tressel; spur; sting; husk (hoose); buck; undercarriage
  1. After an introduction to the research on the software for the design of the variant steel arched girder construction, the creation of the structural model, the structure of the supporting seat, the design of the variant arched girder, and the measures taken to ensure the stability of the plane surface of the arched girder, the thesis goes to study the methods for the hoisting and the angle setting of the long - span arched girders, as well as the bolting of the axle pin in the hinge support

    論文首先對變異鋼拱結構設計可採用的軟體、結構模型的建立、座構造式、變異拱梁的設計,以及保證拱梁平面外穩定所採取的措施等進行了研究,然後研究了大跨度變異鋼拱梁吊裝、角度的調整、鉸座穿軸銷等的施工方法,最後對施工完成後的位移進行了實際量測。
  2. In this paper, ansys, the software on finite element analysis, is made use of processing the static and modal analysis on the preliminary models and its " modified ones. by analyzing the results, we can conclude that the stresses on the components of the modified models are tended to equilibration and the location of the branches " brace can also influence stresses and translations on the branches. in addition, the values of the intrinsic frequencies on modified models " are larger than the ones on preliminary models, but the ranges of the frequencies on both models are almost same

    傳統的閘門的臂結構基本上都是三角式的,這主要是因為按平面體系進行計算的傳統設計方法忽略了結構的整體性及閘門的空間結構特點,設計得比較保守,而實際上,將其改為a型結構也存在可行性,本文是利用有限元分析軟體? ? ansys對原模型及修改模型分別進行靜態和固有頻率的計算,通過分析比較其結果可知,臂改為a型后會使閘門的整體受力趨于均勻,即原模型受力大的部件其應力變小,而原模型受力小的部件其應力會變大;而且a型臂的桿在不同的放置位置對臂的應力和位移變化也有一定的影響。
分享友人