弧流頻率 的英文怎麼說
中文拼音 [húliúbīnlǜ]
弧流頻率
英文
arc current frequency-
Multiple functions available : start / crater arc current, increase / decrease time, base / crest value current, pulse frequency, pulse rate, post flow time, hf welding
功能豐富:起始/收弧電流、上升/下降時間、基值電流、峰直電流、脈沖頻率、占空比、滯后關氣時間分別可調,高頻引弧。Multiple funcyions available : start / crater arc current, increase / decrease time, base, crest value current, pulse frequency, pulse rate, post flow time, hf / friction welding, water / gas cooling
功能豐富:起始/收弧電流、上升/下降時間、基值電流、峰值電流、脈沖頻率、占空比、滯后關氣時間分別可調,高頻/接觸引弧、水冷/氣冷可供選用。Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead
通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點,發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下,通過調節焊接迴路中的電感量和電源電壓,可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行,並且熄弧時間最短時,短路過渡頻率最高,在這種情況下,飛濺小,焊道成型好,焊接過程穩定The variable polarity power supply circuit uses two stages full - bridge inverter, the former inverter is regarded as a constant - current source with fast dynamic response, and supplys energy for the second one, and the latter one is to produce variable polarity current excellently, and low - frequency pulse current by variable polarity power supply is used to reduce input energy and control the shape of weld bead while welding. a series of high - frequency pulse current is superposed on direct - current - electrode - negative ( dcen ) current through the high - frequency pulse power supply, which is used to compress the arc and improve process of crystallization
其中變極性電源採用二次全橋逆變結構,一次逆變提供快速的響應速率並給二次逆變提供能量,二次逆變提供良好的變極性性能,使輸出能量最優化,並用其低頻電流特性減小電弧線能量,控制焊縫成形;高頻脈沖電源提供的高頻電流疊加在反極性電流dcen上,利用電流的高頻特性壓縮電弧,改善焊縫金屬結晶過程。By improving surface condition of parts and one shot seal - off clean room grade, using ultrasonic vapor phase cleaning process, the inner parts of vacuum interrupter get cleaner. movable particles have been diminished by automatic current ageing, power frequency hi - voltage ageing and dynamic high current ageing. as the dielectric strength of clearance in vacuum interrupter improved, the probability of re - ignition in test drops evidently
通過提高零件表面加工質量,改善一次封排間的真空衛生條件、制定合理的超聲波氣相清洗工藝提高管內潔凈度,採用自動電流老煉、超高壓工頻老煉、大電流動態老煉等工藝進一步消除真空滅弧室內活動性微粒,可提高真空滅弧室真空間隙介質強度,使真空開關投切電容器組的重燃率大大降低,並通過實驗驗證真空開關投切電容器組的重燃率在製造工藝改進後由原來的10 . 7 %降低至1 . 3 % 。Through studying the principle of dimmer and switch power supply, it was found that in some frequency points, by analyzing the phase of electric voltage and current it can tell if arc faults occur
研究調光燈及開關電源的工作原理可以發現,通過分析迴路中電壓電流在某些頻率點的相位信息,可以有效判別是否發生了故障電弧。分享友人