影錐 的英文怎麼說

中文拼音 [yǐngzhuī]
影錐 英文
shadow cone
  • 影 : Ⅰ名詞1 （物體擋住光線后映出的形象） shadow 2 （鏡中、水面等反映出來的物體形象） reflection; image...
  • 錐 : Ⅰ名詞1. （錐子） awl2. （似錐物） awl-shaped things 3. （錐體） cone Ⅱ動詞（鉆） drill; bore
  1. Because of cone fatigue in the eyes, the color and shape of the afterimage may be complementary to the color and shape of the actual object

    因為眼睛中的錐狀細胞疲勞的緣故，而產生同形狀、顏色互補的影像。
  2. Conic projection with two standard parallels

    雙標準緯線圓錐投影
  3. Conformal conic projection

    保形圓錐射影
  4. The long conical shadow of the moon was scheduled to sweep from brazil to africa on may 29, 1919.

    1919年5月29日，月亮按照預測的時間表從巴西到非洲投下了它那長長的、圓錐形的陰影。
  5. With the use of finite method we have developed computer simulation software for vacuum microtriodes with wedge - shaped and cone - shaped cathode on the basis of stduying deeply the field emission theory of vacuum microelectronics. the software included field section, grid point numbering, and the calculation of electric currents, transconductance and cathode capacitance, moreover, it can simulate the properties of vacuum microeletronic with variant structures and sizes. the relationship was studied and simulated among electic properties and device structures, sizes and cathode materials etc. the optimized design of vacuum microtiode was proposed

    本文在深入研究真空微電子器件場致發射理論的基礎上，根據圓錐形、楔形陰極真空微電子三極體的不同特點，分別建立了物理和數學模型，在考慮空間電荷密度影響的前提下，以有限元法為基礎採用迭代的方法計算出真空微電子三極體內的電勢分佈情況，繪制出了等勢線、電子軌跡線，並得到了器件電學性能隨幾何參數的變化情況。
  6. Bottom water coning is an important factor affecting reservoir development effect, causing earlier water breakthrough, rapid water cut increase and production decrease

    摘要底水錐進是影響底水油藏開發效果的重要因素。
  7. Stereographic conical projection

    透視圖錐投影
  8. Method of taper hardness test in weld heat - affected zone

    焊接熱影響區錐形硬度試驗方法
  9. The synergy of the gravitational field with the other fields influences the mass transfer, heat transfer and affinity adsorption in the tapered bed, and the transfer directions depend upon the synergy results

    上流錐形床親和層析在多場協同下，其傳質、傳熱以及吸附反應相互影響，過程的最終傳遞方向將取決于各場之間綜合作用的結果。
  10. Raised, conical seat prevents solids build - up from interfering with seal. seat is hardfaced with stellite to meet severe service. alternative space age alloys are also used

    凸起的、錐形閥座避免實心顆粒淤積影響密封。閥座採用鎢鉻鈷合金進行硬面處理，能夠經受惡劣環境的考驗。也可採用航空工業用合金製作的閥座。
  11. The glint suppression using high resolution range profile under conical angle measurement is studied, the angle information in signal components of scatters are extracted and averaged to suppress the glint. nonlinear kalman filtering methods under near spherical coordinate are analyzed and used to get more accurate tracking

    研究了圓錐掃描測角體制下基於距離高分辨的角閃爍抑制方法，利用距離維高分辨像，提取強散射中心反射信號分量，在此基礎上估計出各個強散射中心的角度測量值，採用平均方法減少角閃爍對測角的影響。
  12. With gelatin liquor as adhesive and wheat meal as granulation material, the effects on spray granule ' s strength of fluidizing gas velocity, bed temperature, nozzle air pressure and adhesive concentration were studied experimentally in a batch conical fluidized bed spray particle generator

    本文在一間歇錐形流化床噴霧造粒器中，以食用小麥澱粉為原料，以明膠的水溶液為粘結劑，實驗研究了流化氣速、床層溫度、噴嘴霧化空氣壓力、粘結劑濃度對噴霧造粒顆粒強度的影響。
  13. Hsu, s. t., “ a constitutive model for the uplift behavior of anchors in cohesionless soils ” journal of the chinese institute of engineers, vol. 28, no. 2, pp. 305 ~ 317, 2005

    許世宗和郭芷伶沈泥質砂土中錐形擴座地錨錨碇行為之影響參數研究，朝陽學報，第六期，第375 - 401頁， 2001 。
  14. The nozzle diameter and the ejection pressure have a great effect on the flow rate 、 droplet cone shape 、 droplet size and cover area of fluid pesticide

    噴嘴孔徑和噴出壓力在很大程度上影響著藥液的流量特性、霧錐形狀、霧滴大小和覆蓋面積。
  15. According to the experimental data of droplet size 、 particle spectrum range 、 droplet cone shape 、 flow rate 、 cover area and cover area rate which obtained through changing the pressure of power sprayer and the nozzle diameter in greenhouse ， this paper made comparative analysis on atomizing performance in same pressure and different nozzle type between same nozzle type and different pressure. the conclusion is that : the ejection rate and the droplet cone shape change with the variation of pressure and nozzle diameter ， average particle diameter decreases obviously and particle quantity increases obviously with the increase of pressure and decrease of nozzle diameter. these results will lay experimental foundation for precise spraying 、 low pollution and highly effective operation

    本文根據溫室內動力噴霧機壓力與噴嘴孔徑的變化影響霧滴大小、粒譜范圍、霧錐形狀、流量、覆蓋面積及覆蓋面積率的試驗數據，對相同壓力下不同噴嘴型號和相同噴嘴型號時壓力不同時的微粒化性能進行對比分析和研究，得到如下結論噴出量與霧錐形狀隨著壓力和噴嘴孔徑大小變化而變化；平均粒徑隨著壓力的增加和噴嘴孔徑的減小而明顯減小；粒數隨著壓力的增加和噴嘴孔徑的減小而明顯增多，為精噴量、低污染、高防效的防除作業奠定了實驗基礎。
  16. The influence of waviness and taper of seal faces to the operating performance at slow speed of gas face seal

    低速運轉氣膜機械密封端面波度和錐度對其密封性能的影響
  17. Base on helmholtz integral equation, the incoherent scattering of plane wave from rough cone - shaped surface is derived with the far field theory and stationary phase method. and the incoherent scattering of plane wave from rough conical surface is also derived with shadowing function when the the radius of principal

    最後計算並分析了入射光為= 0 . 48 m時，粗糙錐面的平面波散射特性，考察了入射波和散射波的幾何關系，偏振態以及粗糙面統計參量等對散射強度的影響。
  18. The effects of r / h ratio, l / r ratio and cone angle on the dynamic response of the conical shells are discussed in this section

    分析了圓錐殼結構的徑厚比、長徑比及錐角變化對結構應力響應的影響。
  19. Influnce of au cone on distribution of forward hot electrons

    金錐對靶背向超熱電子分佈的影響
  20. In this paper, i will present some algorithms of polyhedral visual hull reconstruction : ( 1 ) polyhedral v isual h ull generation a igorithm b ased one dge - pool - searching, which constrains the 3 - d intersections into the 2 - d planes intersection via the epipolar theory to reduce the complexity a nd c an r educe t he t imes f or c ones t o b e p rejected o nto t he i mage p lanes, i n which we induced the index list to every points on the surface of object, and connected the related points to get sub polygons on surface and in turn get the mesh model, we replace triangulation process of disordered points cloud by edge - pool searching. ; ( 2 ) reconstruction based on degenerated - polygon - intersection, which have the following improvements on traditional bull intersection : using degenerated polygon to orga nize intersected area on cone face, which may be discontinuous ; a fast intersection algorithm of polygons on the cone face based on degenerated polygons, which is consistent between the continuous polygons and the discontinuous ones. the intersection of degenerated polygons is similar to the convergence of two ordered lists, which is comparably simple to the bull operation ; ( 3 ) reconstruction algorithm based on ray - tracing, in which all the rays that run through the vertex on silhouette of object will intersect with all the cones correspondent to other silhouette, and we have to calculate the intersection of all such line segments, the endpoints of which are considered to lie on the surface of object and we will get the point cloud on the surface of object

    同時利用共極線原理把三維計算投影到二維平面以降低求交計算的復雜度，該演算法可以減少光錐向圖像平面投影計算的次數，以邊池搜索取代散亂點集上進行的三角剖分； （ 2 ）基於退化多邊形求交的多面體可見殼模型重構，系統引入退化多邊形的概念，把錐體平面的交集中不連通的部分用一個退化多邊形來表示，並引入了新的基於退化多邊形的求交演算法，與傳統多面體可見殼重構相比，該演算法有以下幾點創新：在圖像平面以退化多邊形組織投影錐體和物體輪廓的交集，把任意錐面與物體輪廓的交集歸一到一個退化多邊形；基於退化多邊形的二維平面上多邊形快速相交演算法，該演算法在一定程度上就是兩個有序鏈表的合併，大大簡化了先前的布爾求交計算； （ 3 ）基於光線跟蹤的演算法，該演算法中所有通過輪廓頂點的光線和對應其它圖像輪廓的光錐進行求交計算，最後得到每次求交計算得到線段的交集，該線段的頂點就認為是物體表面點，從而得到物體表面的點雲。
分享友人
分享到 Line

分享到臉書