恆應力法 的英文怎麼說

中文拼音 [héngyīnglìfǎ]
恆應力法 英文
constant stress method
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. Then the testing method of constant stress accelerated reliability growth testing is given on the basis of amsaa - bise model

    再次，基於amsaa - bise模型給出了恆定應力下加速可靠性增長試驗的試驗方法。
  2. Test method for viscosity of drive line lubricants in a constant shear stress viscometer

    恆定剪切應力粘度計傳動線路潤滑劑粘度測定方法
  3. Standard test method for low temperature viscosity of drive line lubricants in a constant shear stress viscometer

    恆定剪切應力粘度計中傳動線路潤滑劑的低溫粘度的標準試驗方法
  4. Standard test method for performing laboratory direct shear strength tests of rock specimens under constant normal force

    在恆定的常規應力下進行巖石樣品的實驗室直接剪切強度試驗的標準試驗方法
  5. So it is very important to understand the cyclic deformation behavior of zircaloy - 4. in this paper, bauschinger effect of zircaloy - 4 with different metallurgical state at room temperature and 400 ? is investigated in an incremental step test and cyclic deformation test under constant strain control. bauschinger effect during cyclic deformation is described by using back stress, which is mainly responsible for bauschinger effect ; back stress is attained by using kwl " s method

    本文採用單試樣逐級加載循環變形和恆應變幅循環變形試驗，研究了不同冶金狀態、溫度、氫以及固溶處理下的zr - 4合金的bauschinger效應現象；種種結果表明，影響bauschinger效應的主要因素是背應力；本文正是從背應力的角度來分析各種狀態下zr - 4合金的bauschinger效應現象；背應力的計算主要通過使用kwl方法而獲得。
  6. Also, the thesis calculate and analysis the transverse deflection of steel box girder deeply in multiple factors. firstly, the article introduced the calculative methods and theory of local stress and strain of bridge structure. then program software system of finite element method was introduced. after that, the influential factors to the calculatial result and their values were analysed and suggested

    本文首先介紹了橋梁結構局部應力應變計算理論和方法，對有限元計算程序進行了介紹，然後分析了縱橫隔板設置、梁高及梁寬變化等因素對鋼箱梁橋面板在恆載作用下的橫向撓度的影響，並將這些計算結果進行對照分析，從而找出了影響橋面板橫向撓度的主要影響因素，並得出了相應的數值可供工程實踐參考。
  7. Some key issues in the modeling of a long span composite cable - stayed bridge are discussed such as cable tension, dead load, large deflection, concrete deck stiffness, concrete deck - steel girder connection, and boundary condition. some conclusion can drawn from the thesis : 1. the initial equilibrium configuration of the bridge is clarified in the thesis

    本文深入討論大跨度結合梁斜拉橋"基準"有限元模型建立過程中的幾個關鍵問題並得到一些有意義的結論： 1 .明確斜拉橋在索初應力和恆載作用下的初始平衡構型? ?處于初始平衡狀態時的幾何位置，給出了其計算方法。
  8. Secondly, calculation theory of construction for suspension bridge is presented under the ideal condition of dead load design. linetype change stiffness of cable and slip stiffness of supporting points are deduced based on segmental catenary theory. then numerical analysis method through sgkz2000 software are introduced in detail about calculating design linetype for suspension bridge, unstressed length of cable, erection linetype of cable and pre - displacement of saddle without loads, erection linetype of wire strands, the fixed position for erecting cable band and linetype of lifting stiffening girders

    其次，根據懸索橋恆載設計理想狀態建立了懸索橋施工計算原理；以分段懸鏈線索理論為基礎，推導了懸索的線形變化剛度和懸索支點的滑移剛度；介紹了懸索橋成橋設計線形計算、吊索無應力長度計算、空纜線形與預偏量計算、絲股架設線形計算、索夾安裝位置計算和加勁梁吊裝線形計算的具體方法、數值演算法及軟體sgkz2000的計算模塊的實現。
  9. Standard test method for adhesion of pressure - sensitive tape to fiberboard at 90 angle and constant stress

    在90角度和恆定應力下纖維板上壓敏膠紙帶粘合性的標準試驗方法
  10. Two new methods have been put forward to estimate the reliability characteristic parameter. a software package has been developed to process the data obtained from reliability testing for electric apparatus. it consists of both the determination of failure distribution and the estimation of reliability characteristic parameter

    最後，設計出電器可靠性試驗數據處理軟體包，此軟體包含了產品失效分佈類型的確定和可靠性試驗結果為大子樣、小子樣、無失效數據時可靠性特徵量的估計方法，以及恆定應力加速壽命試驗數據下的可靠性特徵量的估計方法。
  11. We can obtain the trap density by measuring the change of gate voltage of mos capacitance under constant current stress and the change of high frequency c - v curve before and after the stress

    該方法根據電荷陷落的動態平衡方程，測量恆流應力下mos電容的柵電壓變化曲線和應力前後的高頻cn曲線變化求解陷階密度。
  12. Plastics. determination of environmental stress cracking. constant - tensile - stress method

    塑料製品.環境應力開裂測定.恆定抗拉應力法
  13. The optimization model of the cable tensile force is established, resolving the ideal finished state of considering syntheticly the requirement including the dead load, active load and presress of structure, meanwhile, providing a forward - calculating method for determining the rational construction state on the foundation of the optimization model. on the other hand how to determine and adjust the important parameter, the cable midst tensile forces and the main feam form setting levels in constructing cable - stayed bridge, has also been analyzed, besides, the corresponding calculation method is introduced and applied to the actual construction controlling of xian tao han jiang highway bridge well

    本文以仙桃漢江公路大橋為工程背景在斜拉橋設計計算方面進行了的研究，建立了斜拉橋索力優化模型，一方面解決了能綜合考慮結構恆載、活載及預應力等多方面因素的理想成橋狀態確定問題；另一方面在確定合理施工受力狀態問題上提出了一套以索力優化模型為基礎的正裝計演算法。同時對斜拉橋施工中關鍵參數斜拉索中間索力和主梁立模標高的確定和調整做了進一步的分析，提供了相應的計算方法，並應用於仙桃漢江公路大橋施工控制過程中，取得了良好的效果。
  14. Aimed at the practical performance of soft clay, the static equilibrium equations taking consideration of effect of mass change, with the introduction of soil configuration, soil convection formula and mass conservation theory in soil, are derived, which reveal the phenomenon of coupling of total stress and seepage in equilibrium equations. then, some advisable experimental means are explored to determine the effect of mass change during consolidation. objective stress and strain should be used in large strain analysis

    針對軟粘土大變形固結的實際性狀，文中引入了土體構形的概念，土體傳運公式和土體質量守恆定律，並由此導出了考慮變質量效應的大變形固結靜力平衡方程，揭示了平衡方程中存在的總應力與滲流相互耦合的效應，並考慮了固液兩相的可壓縮性，進一步探索了測試變質量效應的試驗方法。
  15. Ltd. a coupled vibration method on suspended free poles is employed to determine the initial young ' s modulus at elevated temperatures, also the thermal expansion coefficients of fire - resistant steel

    通過高溫下的恆溫加載拉伸試驗，得到不同溫度下耐火鋼的屈服強度、極限強度、延伸率、面縮率和應力應變關系，並測定高溫下耐火鋼的熱膨脹系數，採用懸絲耦合共振法測定高溫下耐火鋼的初始彈性模量。
  16. It elaborates on the function of main parts of the polishing machine and its realization, and design a new type of permanent pressure monitoring system to overcome the limitation of the narrow spacial size which it is impossible that the application of traditional hydraulic control devices to achieve permanent pressure grinding. the model of polishing machine has been completed by pro / engineer

    對拋光機結構、精度及相應的控制系統框架進行了設計;對各個主要部分的功能及其實現等進行了闡述;並設計了一種新型的類恆壓力拋光裝置，克服了空間尺寸狹小、無法應用傳統的液壓控制裝置實現恆壓力磨削的局限性。
  17. The transient heat transfer between the drum wall and cooling water rising up with steady rate was simulated numerically using fem, and the time history of the stress and strain fields were also acquired with indirect coupling method

    摘要利用有限元法模擬了焦炭塔進水冷焦階段恆速上升的介質與塔壁的動態傳熱過程，並用間接耦合法求得了應力、應變場的變化過程。
  18. Rubber, vulcanized or thermoplastics - determination of tension fatigue - constant strain method

    硫化橡膠或熱塑性塑料.張力疲勞測定.恆定應變法
  19. Standard test method for creep of rock core under constant stress and temperature

    在恆定應力和溫度下測定巖心蠕變的標準試驗方法
  20. By using moire method, three groups of pmma specimens with single edge crack were experimentally researched under constant stress, especially the strain field around crack - tip. through measure and analysis, we could see its time dependence clearly. we compared the actual strain distribution with the theoretical linear viscoelastic strain distribution

    利用雲紋法，對四組含邊裂紋的pmma試件在恆應力條件下的裂尖周圍的應變場進行了測定、分析，可以看出其明顯的時間相關性，並與基於線彈性假設的裂尖應變場進行了對比。
分享友人
分享到 Line

分享到臉書