恆溫狀態 的英文怎麼說

中文拼音 [héngwēnzhuàngtài]
恆溫狀態 英文
homothermy
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. So it is very important to understand the cyclic deformation behavior of zircaloy - 4. in this paper, bauschinger effect of zircaloy - 4 with different metallurgical state at room temperature and 400 ? is investigated in an incremental step test and cyclic deformation test under constant strain control. bauschinger effect during cyclic deformation is described by using back stress, which is mainly responsible for bauschinger effect ; back stress is attained by using kwl " s method

    本文採用單試樣逐級加載循環變形和恆應變幅循環變形試驗，研究了不同冶金狀態、溫度、氫以及固溶處理下的zr - 4合金的bauschinger效應現象；種種結果表明，影響bauschinger效應的主要因素是背應力；本文正是從背應力的角度來分析各種狀態下zr - 4合金的bauschinger效應現象；背應力的計算主要通過使用kwl方法而獲得。
  2. The main conclusions include : 1 ) among the non - biological factors, temperature is the most important factor that influence the development of the cochineal insect, the insect cannot finish life cycle under 15 associated conditions in spite of a few of egg can hatch, while at associated conditions of temperatures 20, 25, 30, the insect can finish life cycle, but comparing from the amount of eggs, generation tendency indexes and the sizes of the female adults, 25 associated conditions are the best

    得出的主要結論包括： 1 ）在胭脂蟲的生長發育過程中，溫度是影響胭脂蟲發育的最主要因子，在15的恆溫狀態下，盡管胭脂蟲卵有少量孵化，但不能完成世代，而在20 、 25 、 30的恆溫下胭脂蟲能正常發育並完成世代。從培育的胭脂蟲雌蟲體大小、懷卵量及世代傾向等方面比較， 25的溫度最有利於胭脂蟲的培育。
  3. They will short down the working life of air compressor because they are always started or stopped when we want to make the railway carriage stay in a fixed temperature. now, automatic and intelligent control systems are being applying in bus air - conditions control. in this way, computers control the work of air compressor, the turnaround speed of fan, the open degrees of wind controlled doors and so on

    我國大多數客車空調仍然採用簡單的壓縮機開關控制及循環離合控制系統，如：離合器?熱力膨脹閥系統（ cctxv ）和離合器?節流管系統（ ccot ） ，這些控制方式的精度低，當進行恆溫控制時壓縮機處于頻繁的開、停狀態，縮短了壓縮機的工作壽命。
  4. Because the photospheric temperature of carbon stars are less than 3000k and the temperature of rich - dust envelope formed by the mass loss is lower, and therefore most of the energy from carbon stars are radiated between 1 to 60um range, in which the vibrational and ro - vibrational bands of many molecules also lies, the study of infrared spectra in this wavelength range is very important to reveal chemical compositions, dust formation process, the atmospheric structure and evolutionary status of stars

    碳星光球的有效溫度不超過3000k ，同時較大的質量損失率形成了富碳的塵埃殼層，以致於它的輻射能量主要集中在1 ? 60 m的紅外波段上，並且許多分子的轉動振動能譜也集中在紅外，因此在紅外波段的研究對揭示碳星化學成份及其分佈、塵埃形成過程、恆星大氣結構和演化狀態都有十分重要的意義。
  5. Mould temperature is constant when no one is operating

    在無人操作的狀態下，模具溫度是恆定的。
  6. Because expansion valves are high precision processing components, factory in its internal adjustment of the body parts are processed in a state of complete thermostatic, the temperature of the gas filling kits are demanding more consistent not detect leaks, in the completion of the expansion valve assembly also undergo strict testing and fatigue resistance aging sampling, the construction expansion valves : 1 : indeed temperature temperature kits ; 2 : temperature gas or liquid filled with the expansion corrugated ; 3 : spherical valve seat ; 4 spherical valves ; 5 : spring ; 6 : overheating degrees adjustment screw spacer and screw ; 7 : internal and external ( h - type ) sealed pieces ; 8 : thrust poles and corrugated of spacer ; 9 : fati ; 10 : capillary, and so on

    因為膨脹閥是屬于超高精密加工的零件，在工廠對其內部調整機構零件的加工都在恆溫狀態下完成，其中的感溫包的氣體充填更是要求嚴格一致不允許一絲泄漏，在完成裝配的膨脹閥還要經過嚴格的測試和耐疲勞老化抽檢，膨脹閥的構造： 1 ：感知溫度的感溫包； 2 ：感溫氣體或者液體充填膨脹波紋腔； 3 ：球型閥座； 4球型閥； 5 ：彈簧； 6 ：過熱度調整螺絲墊片和螺絲； 7 ：內部和外部（ h型）密封件； 8 ：推力桿和波紋腔墊片； 9 ：閥體； 10 ：毛細管等等。
  7. The equations which are used in the radiation hydrodynamic model include the hydrodynamic equation of plasma, the absorption equation of laser, non - lte electron occupation probability equations, electron ion and photon energy equations ( three - temperature equations ), and the state equation of matter and so on

    考慮的方程有：等離子體流體力學方程組，激光吸收方程，非局域熱動平衡電離下電子占據概率的速率方程組，電子離子的能量守恆方程組和光子的能量輸運方程（三溫方程組） ，關于元素不透明度的方程，以及描述物質狀態的方程等。
  8. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  9. Oddly, the inferred elapsed time between ejection episodes, about 500 years, is too long to be explained by dynamic pulsations ( in which the star contracts and expands, in a gentle tussle between gravity and gas pressure ) and too short to represent thermal pulsations ( in which the star is driven out of equilibrium )

    奇怪的是，不連續噴發的間隔據推估大約是500年，但這段時間實在太長而不能以動力搏動（恆星因重力與氣體壓力間溫和的交互作用，而產生收縮與擴張的現象）來解釋，不過卻又短到無法用熱力搏動（恆星被驅向非平衡狀態）來描述。
  10. In order to increase the accuracy and the widely use of fire spreading model, the paper base on the change state of temperature of the calculus on fire area, use the law of energy conservation, it can give the change of the temperature field ' s mathematical model on the fire area

    摘要為了提高林火蔓延模型的準確性和通用性，文中把火場看作一個動態溫度場，並從火場上任一微元體任一時刻溫度變化狀態出發，應用能量守恆定律，建立火災區域溫度場動態變化模型。
  11. The variations of the surface state and environment conditions could change the procedure of exfoliation, therefore, the potentiometry and electric resistance methods in this paper are used to measure the exfoliation rate of aluminum alloys in a constant temperature, the experimental results show that relations of natural corrosion potential vs time have a resemblance to those of corrosion rate vs time, both relations are all at the different change rates in the front and back of 120 minutes

    超硬鋁合金表面狀態、環境條件的變化，均可能改變剝蝕的發展過程，為此，本文提出在恆溫條件下，用電位法、電阻法定量研究鋁合金的剝蝕性能。實驗結果顯示了lc4cs鋁合金的自腐蝕電位與時間的關系，和腐蝕速率與時間的關系有著十分相似的規律，兩者均在120分鐘前後有不同的變化。
  12. According to the patient ’ s condition, the physician can control the device such as connecting and installing the channels and disposing drugs by selecting the appropriate therapy mode menus on the touchscreen, and then he / she can adjust or set parameters for the control system and the thermostatic incubator by selecting the appropriate menus. then, the directives are given to run the control system and the thermostatic incubator, and the working status of the control system and the thermostatic incubator can be monitored by various sensors. the computer receives the feedbacks from sensors and compares the parameters with the set ones, and finally compensatory control is conducted or alarms sound

    醫師根據患者的病情，在計算機觸摸屏菜單上選取相應治療模式，根據觸摸屏上的圖示，進行管路連接安裝，藥物布置等處置，完畢后再根據計算機上菜單調整設定運行的控制系統、恆溫培養箱等相關參數，無誤后，確認輸出驅動指令，使相關控制系統、恆溫培養箱等在接到指令后進行工作，工作狀態可由各種傳感器連續測試並將所得參數信號反饋回計算機，計算機控制軟體將所得測試參數與設定參數比較后，自動進行補償控制或報警提示，使用者根據觸摸屏上所顯示的提示內容，進行修正。
  13. When a body is in homeostatic balance, various measures ? such as temperature, glucose level and so on ? are as close to “ ideal ” as possible

    當身體處于恆定的平衡狀態，包括體溫、血中葡萄糖濃度在內的各種測量值，都會盡可能接近理想。
  14. The relationships among stress, strain, resistance and temperature of niti memory - wire and superelastic wire, which are in constant temperature, constant stress and shape recovery, were measured and analyzed. the actuating property of cu - based spring in three basic conditions was investigated

    對niti記憶絲及超彈性絲在恆溫拉伸卸載、恆載變溫以及形狀回復過程中的應力-應變-電阻-溫度之間的關系進行了系統的測試和分析；對cu基螺旋彈簧在三種基本使用狀態下的驅動特性進行了研究。
  15. The content of this research mainly include : 1 ) with the increasing loss of tie bars ’ sections, variation laws of cable force, internal force and displacements in each monitoring spots are analyzed on work conditions of constant load, light rail, automobiles and temperature. on this basis, the evaluating indexes of safety state of tie bars are determined

    主要研究內容為: 1 ）分析了恆載、輕軌、汽車和溫度作用工況下，隨著系桿截面損失的增大，系桿索力和橋梁各監測點內力及位移的變化規律，確定了評估系桿安全狀態的評估指標。
分享友人
分享到 Line

分享到臉書