扁平度比 的英文怎麼說

中文拼音 [biǎnpíng]
扁平度比 英文
flatness ratio
  • : 扁形容詞[書面語]1. (形體小的) small2. (邊遠的) out-of-the-way
  • : Ⅰ形容詞1 (沒有高低凹凸 不頃斜) flat; level; even; smooth 2 (高度相同; 不相上下) on the same l...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • 扁平 : flat
  1. The precursors of lico0. 8ni0. 2o2 cathode material for lithium - ion batteries are prepared from lithium hydroxide, cobalt acetate, nickel acetate and oxalic acid by the method of low - heating solid - state reactioa the ucoagnioiqz samples are obtained by sintering the precursors at different temperatures for 12hr. their structures and morphologies are studied by the powder xrd and sem

    由於mil :的jalllieller效應使mhoj面體發生畸變,焙燒溫對樣品晶體棚及電化學性能的影響4肽,與同樣方法合成的li帥及eenaq相, d仙血o的晶胞形狀變得更加,晶胞體積增大。
  2. The simulation results show that the shaped degree is decreasing when the spinning temperature and intrinsic viscosity are increasing ; the spinning speed has little effect on the shaped degree when the pump mass throughput is constant ; the shaped degree is increasing with the increasing of pump mass throughput when the spinning speed is constant ; the cross air - blow conditions have much effect on the shaped degree ; the scope of shaped cegree is increasing when the aspect ratio of spinneret hole is increasing ; the shaped degree has obvious decreasing tendency in the small zone of spinning path and this decreasing became gently when the pump mass throughput is increasing

    模擬的結果表明:纖維的異形隨著紡絲溫及特性黏的升高而降低;泵供量一定時,紡速對異形的影響不大;紡絲速一定,異形隨著泵供量的增大而增大;吹風條件對異形的影響較大;隨著噴絲孔的長寬的增大,異形增加的幅也較大;異形在紡程上較小的區間內有明顯的下降趨勢,並隨著泵供量的增加其下降的趨勢變緩。
  3. The pores, most of which are flat in shape, are typical narrow void, high fractal dimension and high pore - throat ratio

    孔隙結構特徵表現為喉道小,分形維數高,孔喉徑大,彎曲大且大多呈形狀。
分享友人