振簧 的英文怎麼說

中文拼音 [zhènhuáng]
振簧 英文
vibrating reed
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 簧 : 名詞1. [音樂] （樂器里能發聲的薄片） reed2. （器物上有彈力的機件） spring
  1. A analysis of spring vibrator on a smooth bevel

    光滑斜面上的彈簧振子運動分析
  2. The instrument includes a weight suspended in a spring connected to a registering needle which notes the vibration on a strip of celluloid.

    這種儀器有一個重錘懸在與記錄針聯接的彈簧下面。記錄針在一條電影膠片上記錄振動。
  3. This article takes the lagrange equation as the principle, establishes mathematics modeling to the inertia brake vibration when it brakes, then simulates it with matlab. this paper educed the relation equations between, which are the inertia brake ' s friction coefficient of the brake ring and the friction disk, the mean radius, the braking force, rotation inertia of the driving top and the spline shaft, spiral climbing angle of the brake ' s concave - convex helicoid, the mean effort radius of the concave - convex helicoid, elasticity coefficient of the spring, quality of the driving top and the spline shaft, rotations inertia of the brake ' s rotation part besides the driving top and the spline shaft, suppresses sleeve. provides the theory basis for the inertia brake structure optimization

    本文以拉格朗日方程為理論基礎，對慣性制動器在制動時的振動進行數學建模，然後用matlab對其進行模擬，得出了慣性制動器在制動時振動角頻率分別與制動環和摩擦片之間的摩擦系數、制動力的平均半徑、主動頂和花鍵軸的轉動慣量、慣性制動器的凹凸螺旋面的螺旋升角、凹凸螺旋面平均作用力的半徑、彈簧的彈性系數、主動頂和花鍵軸的質量、慣性制動器除主動頂和花鍵軸外其他部分的轉動慣量和、頂壓套的質量等慣性制動器各零部件的物理參數之間的關系，為慣性制動器的結構優化提供了理論依據。
  4. An instrument of the second type makes use of a metal reed kept in vibration by an electromagnet.

    還有一種類似的裝置，由電磁鐵維持金屬簧片不斷振動。
  5. An instrument of the second type makes use of a mental reed kept in vibration by an electromagnet.

    還有一種類似的裝置，由電磁鐵維持金屬簧片不斷振動。
  6. Vibrating reed electrometer

    振簧式靜電計
  7. Therefore, a new design of the flexible joint is herein assumed by replacing the spring / damper system by a hydropneumatic system in which a horizontal hydraulic cylinder only is needed to be fitted between the two bell cranks and the rest of the hydro - pneumatic system which are the throttle valve and the accumulator can be suspended on the vehicle frame at any convenient place

    因而，此處採用新型撓性連接設計，用液壓氣動系統替代彈簧減振器裝置，液壓氣動系統兩曲柄間只需安裝一個臥式液壓缸，而其他部件（即減壓閥和蓄能器）可懸置於車架的適當位置。
  8. The dzmping spring vibration isolator for building

    建築用阻尼彈簧隔振器
  9. Heat transfer will worsen if structure parameters of the spring inserts are not fit. the paper think that the mechanism of heat transfer enhances of the spring inserts is the laminar flow lining is thinner because of librating of the spring inserts, accordingly the part of convection is enhanced. but the part of boil is not influenced

    通過彈簧插入物的各個參數對傳熱性能的影響分析，認為彈簧插入物對豎管降膜蒸發傳熱強化的機理主要是彈簧的振動加強了液膜的湍動，減薄了層流內層，從而強化了對流傳熱分量，但對沸騰傳熱分量沒有影響。
  10. Abstract : rased on practice conditions, both the dynamic characterization of motor vehicle under random forces exciting of the ground state and methods by using damping vibration control are investigated in this paper

    文摘:研究車輛行駛過程動力特性，結合實際條件，給出了車輛彈簧阻尼減振器減振效果的阻尼調置方法。
  11. Vibrating reed relay

    振簧式繼電器
  12. Iv ) revolute joint element, nonlinear spring - damper element, 3 - d 5 points contact element are applied to simulate the revolute restriction between two caterpillar boards, suspension nonlinear vibration, contact between wheels and caterpillar boards, and contact between caterpillar boards and ground are considered respectively. drucker - prager material is employed to simulate reinforced concrete

    4 、應用大幅度轉動約束單元、非線性彈簧阻尼單元、三維五節點接觸單元分別模擬自行火炮履帶板之間的轉動約束連接、懸掛非線性振動及負重輪與履帶板之間的接觸和履帶板與地面的接觸問題；根據材料非線性理論，提出利用drucker ? prager材料建立土壤的非線性有限元模型。
  13. Elastic damping leaf damper

    彈性阻尼簧片減振器
  14. Springs, with the subsequent axial and lateral vibration problems, are eliminat ed

    從而取消了彈簧部件並消除了彈簧部件所帶來的軸向和徑向振動問題。
  15. The objective of the test process was to examine how the signal - path loss varied after exposure to different levels of vibration, and if discontinuities could be forced through long - term fretting wear or by unbiasing the spring contact with excessive shock

    測試的目標是檢驗在施加不同程度的振動之後，信號路徑損失是如何變化的，以及是否會通過長期接觸磨損或通過用過度沖擊使彈簧不偏置而形成不連續性。
  16. Abstract : guiding accuracy of casting mould depends on structure and oscillation parameters, such as elastic deformation of guiding leaf - springs, play of bearings between linkages, stroke and frequency of mould oscillation, etc. in this paper, these factors are studied by means of kinetic and dynamic analysis of oscillating mechanism

    文摘:通過對連鑄機結晶器振動機構的運動學和動力學分析，研究了導向板彈簧的彈性變形、連桿軸承間隙等結構參數及振幅、振動頻率等運動參數對結晶器仿弧誤差的影響。
  17. Vibrating reed rectifier

    振簧式整流器
  18. Vibrating reed instrument

    振簧式儀表
  19. Vibrating reed frequency sensor

    振簧式頻率傳感器
  20. Vibrating reed frequency meter

    振簧式頻率計
分享友人
分享到 Line

分享到臉書