排量 的英文怎麼說

中文拼音 [bèiliáng]
排量 英文
aerodynamic volume displacement
  • 排 : 排構詞成分。
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  1. Suitable match different piston displacement and different wheel diameter of atv

    適配不同排量不同輪徑的沙灘車
  2. Derated coefficient of discharge

    額定排量系數
  3. By the statistic analysis of the structural parameters of 419 fastback saloon cars in accordance with engine emission volume, the technological mainstream, average and highest levels of fastback saloon cars were proposed in this paper

    摘要對全球419個溜背型轎車的結構參數按發動機排量進行了統計分析，指出了當代溜背型轎車的技術主流及其達到的平均水平和最高水平。
  4. The once - poor world is scouring the earth for mineral rights, trying to buy californian oil firms, accounting for ever more carbon emissions and making its weight felt in international negotiations on everything from trade to proliferation to the secretary - generalship of the united nations

    這個一度貧窮的國家如今正在滿世界地尋找開采礦產資源的權利、想方設法購買美國加州的石油公司、不斷增加碳的排量並且努力使包括貿易洽談、防止武器擴散直至聯合國秘書長之爭在內的一切國際性談判事務都能夠感覺到它的存在。
  5. Does the amount of greenhouse gas reduction can survey

    項目溫室氣體減排量可測嗎？
  6. Oilhydraulic ; hydraulic pumps and hydraulic engines, geometrical displacement - volume, rates

    液壓流體力學.液壓泵和液壓馬達幾何排量-容量流
  7. Aerospace. constant displacement hydraulic motors. general specifications

    航空和航天.恆排量液壓馬達.通用規范
  8. Keep the flow rate at 3000 lpm

    保持排量3000升分
  9. Piston stroke measurements in variable displacement compressors

    變排量壓縮機活塞行程測量方法及應用
  10. Eg. the new engine has a 4. 3l capacity and a power output of 153 kilowatts at 4400 revolutions per minute

    這臺新發動機的排量為4 . 3升，轉速為每分鐘4400轉，輸出功率是153千瓦。
  11. In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore

    利用由作者提出的井內流動和傳熱的三維數值模型計算所得的大量數據，文章對影響井內溫度的諸多因素進行了較系統的敏感性分析，研究表明：鉆井液和地層等的熱物理參數以及鉆井液的入口溫度、循環排量等對井內溫度有較大影響，因此，準確掌握所鉆地區地層和井內鉆井液的熱物理參數值，考慮溫度壓力對熱物理參數的影響，準確測量鉆井液的入口溫度、排量等參數值，對于井內溫度的準確模擬至關重要。
  12. This thesis analyze the effects of its mechanism dimension to the working properties with many of date, and the flux curve of principal and subordinate piston mortar pump, and the effects of the transition working area of the compensatory cylinder to the working properties, and find the differences between the actual properties and the theoretical model, proposes the measures for the improvements, as well as gives the guiding instructions for the mortar pump design

    數據分析了主從活塞式砂漿泵機構尺寸參數變化對泵工作性能的影響，分析了主從活塞式砂漿泵的排量曲線，以及補償缸工作的過渡區間對泵工作性能的影響，找到了泵實際工作性能與理論模型的差別並提出改善措施，對該砂漿泵的設計提出指導性建議。
  13. Fit carrying mitsubishi 2. 0 displacement of 4 g94 engine, with 89 kilowatt / 5500 transfer and 168 newton ? m / 4500 transfer of power output and torque output

    飛騰搭載了三菱2 . 0排量的4g94發動機，擁有89千瓦/ 5500轉及168牛頓?米/ 4500轉的功率輸出和扭矩輸出。
  14. The model of variability of submergence depth is established based on the law of volume balance, and the changing trends of parameters like submergence depth etc are analyzed. according to the principle of supply and discharge balance, the method to predict oil yield is presented. subject to different objective functions, the corresponding optimum combinations of suction parameters are analyzed, and the importance of choosing objective function to optimum combination of suction parameters is emphasized

    本文研究了油井流入動態關系，根據井筒內液量平衡原理，建立了沉沒度變化的數學模型，分析了沉沒度等參數變化規律；根據油井供、排平衡原則，得出了抽油泵排量系數相對穩定狀態下產量預測的關系；分析了不同目標函數下，油井抽汲參數的組合效果，指出了目標函數選取對參數合理組合的重要性。
  15. Foreign manufacturers have used multiple carburetors extensively to increase performance and efficiency of small-displacement.

    國外汽車製造廠家也廣泛地使用多重化油器，以提高小排量發動機使用性能和經濟效益。
  16. Make a record of pump pressure at one third of normal rate

    做好正常排量三分之一的泵壓記錄。
  17. Hydraulic fluid power - pumps and motors - geometric displacements

    液壓泵及馬達公稱排量系列
  18. Standard specification for rotary positive displacement distillate fuel pumps

    旋轉式正排量蒸餾燃油泵標準規范
  19. Designation for rotation and discharge of centrifugal fans

    離心式風扇的轉向和排量標識
  20. Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps, other characteristics, such as fluctuation rate, maximum pressure angle and velocity fluctuation rate etc, are much better. the methods to cut gears are proposed in the theory for the practical produce in the future

    雖然，在體積相等的條件下，優化出來的外圓弧包絡線內嚙合齒輪泵的排量略小於tatsuno組合泵的排量，但其它性能（如：流量脈動率、最大壓力角、速度波動量）都更優。
分享友人
分享到 Line

分享到臉書