探針測量 的英文怎麼說

中文拼音 [tànzhēncèliáng]
探針測量 英文
probe measurement
  • 探 : Ⅰ動詞1 （試圖發現） try to find out; explore; sound 2 （看望） call on; visit; see 3 （向前伸出）...
  • 針 : Ⅰ名詞1 （縫衣物用的工具） needle 2 （細長像針的東西） needle like things 3 （針劑） injection; sh...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 探針 : probe; sound; filling fork; feeler; explorer; probing pin; touch needle; wire probe
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. The main work and achierement are as following : ( 1 ) by using shock impedance matching technique and electric probe method, 5 shots of impact experiments were conducted to measure the hugoniot equation of state for enstatite ( mg0. 92, fe0. 08 ) sio3 with the average initial density 3. 05g / m3 from shock pressure 50 gpa to 115gpa, using two stage light gas gun

    本文研究取得的認識主要有以下幾點： （ 1 ）用阻抗匹配法和電探針技術在80 115gpa壓力范圍內對平均初始密度為3 . 05g / cm ~ 3的頑火輝石樣品進行了5發hugoniot狀態實驗測量。
  2. Method of quantitative electron probe microanalysis on gold products

    黃金製品的電子探針定量測定方法
  3. Mechanical microprobe and its application in study of mechanical properties of thin films

    力學探針及其在薄膜力學性能測量上的應用
  4. Volumetric distribution feature of measuring coordinate errors integrating with nonrigid errors

    三坐標測量機探針校準的誤差分析
  5. In addition, their new anti - vibration technology prevents degradation of test quality that can affect yield, while simultaneously increasing prober throughput

    此外，其新穎的防振技術避免了測試質量的降低或影響產出，且增加了探針臺產量。
  6. The seven - hole probe ( shp ) is a device which can simultaneously measure the pressure and velocities of the steady flow, especially at large angles

    作為一種可以同時獲得流動速度的大小、方向、以及總壓和靜壓的氣動測量裝置，七孔探針能夠被廣泛應用於各種大角度的流動測量。
  7. Specification for calibration of stylus instruments

    表面結構測量用探針式儀器規范
  8. The four - probe method to measure the conductivity of metal thin board

    金屬薄板電導率的四探針測量法
  9. The two experiments on the shp calibration and the flow field measure of parachute are be finished with the use of the two kinds of shp measure system separately in wind tunnel. the analysis of the experimental process and data help a lot to both of the improvement of shp measure system and the shp experimental techniques

    七孔探針校準實驗和降落傘流場測量實驗分別使用了上述兩套測試系統，通過對實驗結果進行分析，本文提出了在七孔探針校準和七孔探針測量時需要注意的若干問題，對這些問題的深入分析有利於七孔探針測試系統和七孔探針實驗技術的完善。
  10. The result of fluorescence show that the fluorescence intensity of the surface of the treated glass slide connect with the probe immobile ratio of oligonucleotide. the more oligonucleotide probes have been linked with active group, the stronger fluorescence intensity is. for the strongest fluorescence, the technical conditions is : treatment of 2 % aminosilane of 20 minutes, treatment of 5 % aldehyde of 24 minutes, uv crosslinking of 150mj and washing of 5 minutes at 20

    兩種檢測方法表明，當活性基團呈柱狀、分佈均勻且尺寸比較大（ 200nm ）時，有利於寡核苷酸探針的連接，且連接探針數量多，玻片表面熒光強度強，固定率高；當活性基團呈錐狀、分佈及尺寸不均勻（ 150nm （ 300nm ）時，連接的寡核苷酸探針數量少，玻片表面熒光強度弱，固定率低。
  11. In order to execute this research, the experimental equipment that can fulfill the requirements of the regions of reynolds numbers in mte was built. two new measurement techniques, mini - size static pressure hole and mini - type pressure probe were presented

    本文針對微型渦輪發動機流動問題研究的需要，發展了壁面微靜壓孔和微型單管總壓探針測量技術。
  12. Standard test method for determining relative humidity on the surface of concrete floor slabs using relative humidity probe measurement and insulated hood

    用相對濕度探針測量法和絕緣蓋測定混凝土地板表面相對濕度的標準試驗方法
  13. Out of the concept of virtual instruments, another shp measure system is developed in labview. the system can detect and get the fluid characters of the measure point very quickly just as an instrument which can be used very conveniently

    基於虛擬儀器思想，本文又開發了基於labview技術的七孔探針測試系統，該測試系統能迅速進行位置點的七孔探針測量，並直接進行測量結果顯示，使七孔探針使用方便快捷。
  14. Good agreement is obtained between present cfd predictions and published experimental data of solari and bell [ 77 ]. the maximum standard error of the result is 18. 9 %. the results can reflect the phenomena of different circulation area along the height of liquid layer and above the inlet baffle

    在1 . 2米塔徑的冷模篩板塔上，提出使用熱膜流速儀通過在平面內旋轉探針測量三維流速的新方法，與計算結果的對比有力地說明了該方法是正確的。
  15. In order to understand the origin of lead in air, proton microprobe was used to measure pm10 environmental monitoring samples of wusong district, shanghai city, and lead pollution origin of this district was studied with micro - pixe spectrum " fingerprint " combined with pattern recognition technique

    摘要為?解空氣中鉛的來源，用質子微探針測量了上海市吳淞地區空氣pm10環境監測樣品，用微束質子激發單顆粒x射線能譜「指紋」結合模式識別技術研究了該地區鉛污染的來源。
  16. Abstract : with an optical probe based on the principle of multi - wavelength light extinction, size and concentration of droplet were measured in a transonic wind tunnel. this paper presents the measurement results

    文摘:應用基於多波長消光法原理發展的光學探針，測量了跨聲速風洞中不同馬赫數濕空氣流自發凝結形成的水滴尺寸及濃度，並給出了實驗結果。
  17. Four - point probe - test equipment used to test resistivity of wafers

    四探針-測量半導體晶的阻電面表片設備。
  18. The quantitative determination of protein and dna is a common analysis contents in biology chemistry and life science. so it is very important to find fluorescence probe with high sensitivity and low detection limit

    對蛋白質和dna進行定量測定是生物化學和生命科學中經常涉及的分析內容，建立高靈敏度、低檢測限的熒光探針定量測定的方法仍具有重要意義。
  19. At the same time, according to the decision drawn by experiment process, chose the representative product from middle - frequency device and high - frequency device to do the experiment during practice production, then do batches of production, cheek the consistency. the result proved that both acceptance ratio tested by probe and frequency

    同時，依據實驗過程中的結論，在實際生產中在中頻器件和高頻器件中選代表產品實驗進行批量生產，檢測其一致性，結果表明，光刻探針測試成品率以及片與片之間的頻率一致性均有大的提高。
  20. At present, the problem in testing sheet resistance for micro - areas is that probes must be set up at the suitable locations by handwork. in order to know the wafer ' s impurity distributing, we need test many times, so will waste a lot of time. if the wafer ' s diameter would be 300mm, this problem will be more serious. in this paper, image analysis is introduced, through pre - processing and edge picking - up, the probe tips are recognized. then probe tips will be aligned respectively in two perpendicular directions through driving stepper motors. thus the distribution of sheet resistance for whole wafer is got by automatic testing and it offers information for detecting the impurity distribution and the diffusion uniformity

    這樣，完成200mm （ 8時）圓片雜質的擴散分佈需要對許多圖形進行測試，需要花費很長的時間，當測試300mm矽片時問題就更為突出。本文將圖象與視覺測量系統引入四探針測試系統中，對採集到的原始探針圖像進行預處理、邊緣提取等操作，以便實現探針針尖的識別，然後由電機控制實現探針的自動定位。這樣測試系統可以自動獲得全片的薄層電阻分佈，為超大規模集成電路檢測雜質分佈和擴散的均勻性提供信息。
分享友人
分享到 Line

分享到臉書