接地連接板 的英文怎麼說

中文拼音 [jiēdeliánjiēbǎn]
接地連接板 英文
earth lug
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 接地 : [電學] landing; body; ground connection; electrical grounding; grounding; earthing; earth; ground...
  • 連接 : connect; fit together; link; marry; mate; joint; association trail; linkage; concatenate; concate...
  1. 4 the connecting among straight step, baluster and ground should follow the next requirements besides the common requirements

    4踏板墊木與水泥地面連接除達到正常要求外，還應達到以下要求：
  2. 1 demarcating on the floor 2 assembling the floor, pedestal, and corner cover

    2地板支架角底板裝配連接
  3. The latest members of the extreme pressure gauge line - up available from tecsis are two new gauges with connections at the rear. thus, no longer is there any obstacle to troublefree integration of pressure gauges in control panels, with the option edge front rear also in the extreme pressure range

    Tecsis極高壓力表的最新成員是兩個在尾端帶有連接裝置的壓力表，因此，它們可以方便地和控制板連為一體，而不會有任何障礙。
  4. 9, between the floor, and between the floor and the plank does not allow connecting with the ordinary glue water

    9地板與地板之間，及地板與木板之間不允許用普通膠水連接。
  5. The pedal angle can be changed as desired by adjusting the length of the link rod

    調節連接桿的長度，踏板的傾斜角度可以自動地變化。
  6. For example, the temperature standards, the project adopted a geothermal heating to link with municipal heating networks. the designs of energy - saving insulation wall : extruded ceramic plastic plate, three - window design aluminum - plastics which meet energy requirements, and also to improve the insulation quotiety i

    如溫度標準，小區採取了地熱供暖方式，與市政供熱管網連接，採取節能保溫墻面體設計：陶粒加擠塑板，窗戶採用三玻鋁塑窗設計，即達到節能要求，又提高了保溫系數。
  7. Steel moment - resisting frames with welded beam - to - column connections were traditionally regarded as having excellent performance, and widely adopted in steel constructions, but this opinion changed after the 1994 northrige earthquake and the 1995 hyogoken - nanbu earthquake. these earthquakes also arouse engineers to resurvey the behavior of end - plate connections

    傳統觀點認為，樑柱焊接剛性連接具有較好的抗震性能，因此在工程中得到了廣泛地應用，但1994年的northrige地震和1995年的阪神地震改變了這種傳統觀點，這兩次地震也引起了工程技術人員對端板連接的再審視。
  8. Iv ) revolute joint element, nonlinear spring - damper element, 3 - d 5 points contact element are applied to simulate the revolute restriction between two caterpillar boards, suspension nonlinear vibration, contact between wheels and caterpillar boards, and contact between caterpillar boards and ground are considered respectively. drucker - prager material is employed to simulate reinforced concrete

    4 、應用大幅度轉動約束單元、非線性彈簧阻尼單元、三維五節點接觸單元分別模擬自行火炮履帶板之間的轉動約束連接、懸掛非線性振動及負重輪與履帶板之間的接觸和履帶板與地面的接觸問題；根據材料非線性理論，提出利用drucker ? prager材料建立土壤的非線性有限元模型。
  9. 2. pseudo - static force testing of twelve full - scale connections, including top - seat angle connections, two web flange and top - seat connections, extended - end - plate connections, slit - t steel connections and dog - bone connections are carried out for the first time in our country

    2首次在國內大規模地進行了頂底角鋼連接、帶雙腹板頂底角鋼連接、外伸端板連接以及短t型鋼連接等半剛性連接以及狗骨式剛性連接這五種連接類型共十二個原型試件的擬靜力試驗。
  10. The present findings of semi - rigid connections, the method for design of beam - to - column connections in the codes from china and other countries, and the character about semi - rigid connections, were briefly introduced in this paper. the simulated method of the m - r relation curve of semi - rigid connections, the computing equations about the initial stiffness and moment capacities of two kinds of top - seat angle connections, with and without double web - angle, were discussed

    本文簡要地介紹了半剛性節點的研究現狀、各國規范樑柱連接的設計計算內容和方法、樑柱連接的類型和半剛性連接的特性，探討了頂、底角鋼、頂、底角鋼帶雙腹板角鋼兩種半剛性連接的m - _ r特徵曲線及其擬合方法，頂底角鋼連接、帶雙腹板頂底角鋼連接初始剛度以及彎矩承載力的計算公式。
  11. One rail is joined to the next by means of a metal, plate ; space is left between them to allow for expansion

    用鐵板把鐵軌一根一根連接起來，它們中間留出空隙，作為膨脹的餘地。
  12. So, developing expander board for simulation become important the function of expander board is joint between the data bus of pc and the data bus of aviatic electronic system, and operation aviatic electronic system under the control of pc instruction. pc could simulate aviatic electronic device on the ground

    擴展板的重要任務是將專用航電系統的數據總線與pc機的數據總線連接起來，並且依據pc機的指令而操作總線上的子系統，這樣pc機就可在地面上模擬飛機上的慣導系統，火控系統等等。
  13. On the other hand, boundary - scan technique intelligent fault diagnostic method was applied to practice. for most digital system, devices with boundary - scan architecture are broadly used. only using four line or five line to connect pc parallel port with cut tap ( test access port ), all the ptvs can be loaded to cut and all homologous prvs can be taken back to intelligent fault diagnosis system

    至於本文採用邊界掃描測試故障診斷技術，是考慮到本系統的通用性和簡潔性，因為對于大多數數字系統而言，具有邊界掃描結構的器件己廣泛應用，本文只需4條或5條信號線就能將pc機和被測邊界掃描電路連接起來，由此極大地簡化了智能故障診斷系統中為實現ptvs加載和prvs獲取而專門設計的介面板電路。
  14. Secondly, this paper made some theoretic researches on its engineering classfication and applicable scope for this technology ; then combining with project example, this paper carried out scheme design for this technology, and compared some different kinds of underpinning scheme and node and structure design, and put forward the method of " reinforcce steel bar through column " to build pile cap beam, " resistant bend and shear anchored reinforce steel bar " to strengthen column consolidation effect, and the method of " steel plate hoop " to build reinforcing bar connection of the foundation beam, etc. in the process of the consturction scheme research and implement, this paper synthetically elaborated the organizaton for project construction, put forward the construction technical measure of specific aim on the artificial pile, and pile cap beam, and underground adding layer and structure stabilization, and overall structure stabilization and so on. for this project, adopt reinforcing bar concrete to brace hole wall to ensure the safety of engineering in the artificial pile construction, use flexible connection catch to make the cage hoisting easier to simplify the construction process, use the method of earthwork statified symmetrical balance in the process of underground adding layer excavation

    本文首先對于基礎托換與結構加固技術的目的和意義、國內外發展狀況進行了綜合闡述；其次對該項技術工程分類及適應范圍進行了理論上的分析研究；然後結合工程實例對該項技術進行了方案設計，對比幾種不同的托換方案和節點及構造設計，提出了「通筋穿柱法」做承臺梁， 「抗彎抗剪錨筋法」強化柱加固效果， 「鋼板箍法」做地基梁鋼筋連接點等多項技術；在施工方案的研究和實施過程中，對于工程施工組織進行綜合闡述，並就人工挖孔樁、承臺梁、地下加層及結構加固、整體結構穩定等專項施工方案提出有針對性的施工技術措施，人工挖孔樁施工採用鋼筋砼護壁確保挖孔樁的安全成型，使用柔性連接鉤進行鋼筋籠吊裝簡化施工工序；承臺梁施工採用梁主筋橫穿柱身化學膠錨固等；地下加層綜合施工技術採用土方分層對稱平衡開挖，分段挖土做筏基結構自穩等；最後對于該工程實施后的效果分析，說明該項綜合施工技術的可行性。
  15. The programme can solve two - dimensional stresses, strains and axial symmetry problems with different yield criteria. a satisfying solution has been put forward to the contact boundary between reinforcements and soil. the special problem of two contact plane elements at the joint between plate and strip has been solved

    該程序能同時考慮平面應力、平面應變和軸對稱問題，並能運用不同的屈服準則，使其更具有通用性和適用性，成功地解決了筋材與土介質界面的接觸問題，較好地解決了墻面板與筋帶連接處出現兩個接觸面單元的特殊問題。
  16. Elevated ( heavy ) rail and underground rail puzzle pieces now have more options, such as 45 turns and diagonals

    架空鐵路（非輕軌）和地下鐵路（非地鐵）板塊現在有了更多的選項，比如45彎和對角線連接。
  17. People who like to tinker with their computers know that when they open up their machines, they should “ ground ” themselves ? perhaps by touching the metal radiator panel or attaching a wire from their fingers to a metal fixture

    喜歡玩電腦的人都知道，當他們打開電腦時，自己應該要先接地? ?也許是碰一下金屬散熱板，或者用一條電線把手指連到金屬物體。
  18. This paper take the junction panel of the front reinforced beam in the back automobile floor for the example, introduces the drawing die design process, which proves this method simplified the design process, enhanced the rated capacity

    本文以汽車后地板前加強梁左右連接板為例介紹了汽車覆蓋件拉延模具設計，經過實踐應用，證明該方法簡化了設計過程，提高了設計效率。
  19. Construction of male sterility expression vector by integration of artificial sense and antisense cdnas of hsp70 into puc18 and puc19 respectively, we can obtain psc and pac. tapertal specific expression promoter ta29 and terminator nos are connected directionally with sense and antisense cdnas of hsp70 extrected and purified from psc and pac., then integrated into puc18 and puc19, by which we can build sense and antisense cdna nos ( respectively named plasmid 650 and plasmid 651 ) of ta29 - hsp70. for the sake of better screening and examination of transformed gene, we cut plasmid 650, plasmid 651 and 3301 ( containing gusgene bar screening marker gene ) with hindiii and ecor i enzymes, then connect purified fragments of 650and 651 with plasmid 3301 to construct the vector 3301 + 650 and 3301 + 651. corroboration of whether sense and antisense cdna - nos is integrated into plasmid3301 can be made by plate screening and enzye - cutting analysis

    分別將從psc 、 pac回收純化的hsp70正、反義cdna與絨氈層特異表達啟動子ta29及nos終止子定向連接，然後插入到puc18 、 puc19中，構建成花藥特異表達的ta29 - hsp70sensecdna - nos和ta29 - hsp70antisensecdna - nos ，分別稱作650和651質粒。為了更好地對轉化子進行篩選和檢測，用hind和ecor分別對650 、 651及3301質粒（含gus報告基因和bar篩選標記基因）進行酶切，將從650和651回收純化的目的片段與3301質粒進行連接，再對重組子進行平板篩選和酶切分析確定ta29 - hsp70sensecdna - nos和ta29 - hsp70antisensecdna - nos插入到3301質粒中，構建成3301 + 650和3301 + 651表達載體。
  20. Plastic piping systems for warm water floor heating systems and radiator connecting - polyethylene of raised temperature resistance

    地板熱水供熱系統和散熱器連接用塑料管道系統.高耐溫
分享友人
分享到 Line

分享到臉書