接觸反射 的英文怎麼說

中文拼音 [jiēchùfǎnshè]
接觸反射 英文
contact reflex
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  1. A new method for measuring the vibration of shadow mask without touch by detecting the light density with reflection type optical fiber sensor is presented. the measurement system based on the new method is designed to make the vibration measurement easier working, faster calculating, and get more precise results. it is an important measurement and analysis tool to improve the performance of shadow mask and display quality of cpt

    本文提出了基於單光纖光強度反射法的非接觸式微振動測量系統的原理，並設計製造了該測試系統，探索出了簡單方便可靠的測量方法，能夠準確客觀地反映蔭罩振動的各項參數（各振動模的振動頻率、振幅、衰減時間） ，實現了測試裝置的簡便化和測試過程的自動化，為cpt張緊式蔭罩系統的性能改進與顯示質量的提高提供了有效的測試分析手段。
  2. The reverse side of the mirror should be in continuous contact with air without needing ventilation.

    反射鏡的背面應經常與空氣接觸但無需通風。
  3. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  4. The technique of producing metal matrix composite include powder metallurgy, casting ( including stirring casting process, in situ contact reaction process, liquid - phase metal infiltration process, co - spray deposition forming process ), reaction mechanic alloying process

    制備金屬基復合材料的工藝分為粉末冶金法、鑄造法（鑄造法細分為攪拌鑄造法、原位接觸反應法、液相浸滲法、共噴射沉積法） 、反應機械合金化技術。
  5. For the sake of the best reflectivity, the optimized zno : al film thickness of 1000a was achieved by theories calculation and exprimental analysis. the n - c - si, which could endure the grain bombard, was used as n - layer of the solar cell with znoral / al back reflector well

    與背電極緊密接觸的n ? si中， n ? c ? si的耐轟擊能力較強，與背反射電極的匹配較好，所以在非晶硅電池上應用n ? c ? si可以提高背反射電極的增反效果。
  6. Results : 47 enterprises were using n - hexane and 554 workers exposure to n - hexane ; the concentration of n - hexane in 3 enterprises were exceeded the occupational exposure limit ; achilles ' s tendon reflex of 3 workers were disappeared ; and most of enterprises lacked of occupational health management and protection measures

    結果：崑山市共有47家企業使用正已烷，接觸人數共554人；有3家企業正已烷濃度超標；職業性健康檢查人數共54人，其中有3人腱反射減退或消失；多數企業職業衛生管理和防護措施落實不到位。
  7. Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity. the limit ratio of short - circuit current increment for anti - reflection coating utilization on solar cells was obtained. the crystalline silicon solar cell spectral response, contact resistance and minority carrier lifetime measurement systems were established

    鈍化機理研究獲得了表面復合對不同表面摻雜濃度晶體硅太陽電池性能的影響、表面和界面復合速度的理論表達式；研究得到了減反射膜對太陽電池短路電流增量比的極限；建立了太陽電池光譜響應、柵線電極接觸電阻和少子壽命等測試系統。
  8. In the srlois, a sphere reflector taking the place of the traditional lens is taken as the scanning optical system, the measuring range of the system is extended, and the problem of laser non - contqct measurement of larger diameter for workpiece

    本系統用球面反射鏡代替傳統透鏡作為掃描光學系統，擴大了系統的測量范圍，解決了工件較大徑向尺寸（直徑）的激光非接觸檢測問題。
  9. The results of attenuated total reflectance - fourier transform infrared ( atr - ftir ), x - ray photoelectron spectroscopy ( xps ) and contact angle measurement showed that the amphiphilic copolymer could self - segregate on the hydrophobic pdl - la surface

    利用衰減全反射傅立葉轉換紅外光譜（ atr - ftir ） 、 x -射線光電子能譜（ xps ）分析以及接觸角測定對改性聚乳酸材料表面進行了表徵。
  10. Fvisar ( fiber velocity interferometer system for any reflector ) which is made up of fiber can measure the velocity for any reflector without touching. it is widely used in the velocity measurement, especially in the field of material impact characteristics researching

    全光纖速度干涉系統（ fibervelocityinterferometersystemforanyreflector : fvisar ）是一種以光纖為框架、非接觸測量任意漫反射面速度的干涉儀。
  11. Reflection and refraction of elastic waves at a unilateral contact interface between two generally anisotropic media

    一般各向異性單側接觸界面上波的反射和折射
  12. Standard test method for measurement of ultrasonic attenuation coefficients of advanced ceramics by pulse - echo contact technique

    用脈沖反射接觸技術測量高級陶瓷超聲衰減系數的標準試驗方法
  13. This topic focused on the radiation effect on the uhmwpe fiber with electron beam ( eb ) radiation. and instron, sem, atr - ir, xps, epr, xrd et al were used to characterize the structure and properties of uhmwpe fiber before and after radiation treatmentand on this condition we probed into the grafting modification with eb radiation technology

    本課題研究uhmwpe纖維的電子束輻照效應，運用電子強力機、掃描電鏡（ sem ） 、全反射紅外（ atr ? ir ）光譜、 x射線光電子能譜（ xps ） 、電子順磁共振儀（ epr ） 、 x射線衍射儀（ xrd ） 、接觸角和交聯度測定等方法對uhmwpe纖維在電子束輻照作用下的主要結構與性能變化規律進行了表徵和分析，在此基礎上對運用電子束輻照技術進行uhmwpe纖維的表面接枝改性進行了探討。
  14. But if a substance with a higher index of refraction ? such as skin ? is pressed against the window, the light will be absorbed at the points of contact, a phenomenon called frustrated total internal reflection

    但是如果有個折射率比較高的物質（例如皮膚）壓住窗口，位於接觸點的光就會被吸收，這個現象稱為受抑內全反射。
  15. The main work includes four contents as follow : 1 ) the electrodes annealed in various temperatures were studied. with x - ray diffraction spectroscopy ( xrd ) and sims, the interfacial reaction is analyzed and a new two - step annealing method is suggested

    研究了al單層電極及ti al雙層電極與藍寶石基gan在不同退火條件下的歐姆接觸情況，並用x射線衍射譜（ xrd ） ，二次離子質譜（ sims ）對界面固相反應進行了分析。
  16. The main work in this thesis includes two contents as follow : 1 we have investigated the properties of ohmic contact between metal electrode ( al and ti / al electrode ) and n - gan dealed under different annealing conditions. by using xrd sims analytic methods and i - v measuremnet, we analysed the interface between metals and gan, and suggested that it is effect to decrease the value of the ohmic contact

    主要工作如下： 1 、研究了al單層及ti al雙層電極與n型si基gan和al _ 2o _ 3基gan在不同退火條件下的歐姆接觸情況，並用x射線衍射譜（ xrd ） ，二次離子質譜（ sims ）對界面固相反應進行了分析。
分享友人
分享到 Line

分享到臉書