接觸故障 的英文怎麼說

中文拼音 [jiēchùgùzhàng]
接觸故障 英文
contact fault
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 故 : Ⅰ名詞1 （事故） event; incident; happening; accident 2 （原因） cause; reason 3 （朋友; 友情） fr...
  • 障 : Ⅰ動詞（阻隔; 遮擋） block; hinder; obstruct Ⅱ名詞（遮擋物） barrier; block; obstacle
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  1. Based on researching the function of every kind of eliminating arc loop, new concept was brought up in this paper, and the protective device for eliminating arc and overvoltage was researched and manufactured. when the arc light connecting the ground emerges, the chip synthesizing controller control the vacuum contacter which can be operated with dividing phase and make its fault phase earthed so that the arc light can be dissolved thoroughly

    本文在研究各種消弧線圈的基礎上，提出全新的概念，研製出了消弧及過電壓保護裝置，該裝置在出現弧光接地時，通過單片機綜合控制器控制一組可以分相操作的真空接觸器，使故障相接地，達到徹底消除弧光的目的。
  2. Although the possibility is remote3, diode failure4 might eventually cause a small section of bare wire to contact the metal cabinet

    雖然這種可能性很小，但二極體故障可能最終導致一小部分裸線與金屬盒接觸。
  3. It was found that some of these rcbos may not trip on earth leakage fault due to the non - conforming specification of a component. this may pose a risk of electric shock hazard to users

    調查發現，部份漏電斷路器可能會由於其一不符合規格的部件而在發生接地漏電故障時不能自動脫扣，對人構成潛在觸電危險。
  4. Furthermore, the article calculated cyclic times when the inner and outer circles of bearing 6202 meet and the failure frequency when the inner and outer circles and steel balls make simplex deficiency

    本文計算了6202軸承內外圈接觸循環次數和內外圈、鋼球產生單一缺陷時的故障頻率的大小。
  5. The research about the non - invasive inspection of pcb that is based on ir image is introduced. the detection principle, the components of hardware and software are introduced in this paper. some key technical problems and the project of software are presented in detail : graphics of user interface ( gui ) of the projection, gray scale transformation ( gst ), image contour extraction through edge detection algorithm based on the approaching contour optimization, image registration based on corner detection, the position of hidden trouble pcb through add - minus algorithm image

    本文介紹了利用紅外圖像對印製電路板進行不接觸式故障檢測的系統研究，主要介紹了本系統的檢測原理，硬體組成及軟體的製作，其中詳細地介紹了軟體的製作過程以及其中的幾個關鍵部分：本系統的人機交互界面；圖像的灰度轉換；基於最優輪廓逼近的邊緣提取演算法進行輪廓提取；基於角點檢測的圖像配準；用差影法得到故障電路板的故障隱患或故障部位。
  6. For current misoperation cause of microcomputer relay protection, the paper introduces the technology of scattered arrangement protection to improve anti - inteferance ability, the usage of computer digital communication technology to enhance fault diagnostic function of micro computer protection device and outside circuit and decrease bad contact of contactor and terminal which may cause ralay misoperation, establishment of electrical protection remote management network to realize maintenance under condition

    針對目前微機保護不正確動作的原因，提出了採用保護分散布置技術，提高抗干擾能力；應用計算機數字通信技術，增強微機保護裝置及外聯迴路的故障診斷功能及減少接點和端子接觸不良引起的保護不正確動作因素；建立電網保護管理遠程網路，實現「狀態維修」 。
  7. Secondly, been generalized the failure data of electrical connectors from working and testing environment, electric contact failure, insulation failure, mechanical connection failure and other failure are four mainly failure modes of connectors, moreover, built the faulty - tree to analyze their reliability level. however, contact fault failure was the most prevalent mode of electrical connectors. under natural working and reserving conditions, the contact stress decreasing, fretting and surface film growing are mainly reasons to make electrical connector failure

    其次，通過對現場、試驗場電連接器的失效情況進行統計和分析，總結出電連接器的四種主要失效模式：電接觸失效、絕緣失效、機械連接失效和其他失效，並對電連接器進行了故障樹分析，指出電接觸失效是電連接器失效的主要形式，而在正常的工作條件下，造成電接觸失效，即決定電連接器工作壽命的主要原因是氧化膜層的生長、接觸對磨損以及磨損腐蝕物的堆積，而影響氧化膜層的生長、接觸對磨損以及磨損腐蝕物堆積的主要因素是環境振動和溫度應力，為電連接器進行失效機理分析奠定了基礎。
  8. Applying the theory of polygon expanding and shrinking, a new critical area calculation method for soft and hard faults is given. a total formula is presented by dividing vlsi interconnects into two parts, contacting and conducting path, to calculate its critical area. finally the effect of hard and soft fault of different size defect on circuits is given by calculating soft fault area of a 4x4 shift register

    本文基於多邊形膨脹收縮理論給出了一種新的軟、硬故障關鍵面積計算方法，該方法首先將vlsi中的互連線分成導電通道和接觸區兩部分，然後分別計算其軟、硬故障關鍵面積，最後將這兩部分相加起來得到總的軟硬故障關鍵面積。
  9. How to give the correct schemes of trouble hunting of catenary within short time is a problem that has been needed to solve urgently all the time

    如何在短時間內給出正確的接觸網故障檢修方案是一直以來迫切需要解決的問題。
  10. If there are high voltage cables running anywhere near the data cables, the potential for a fault condition exists as a result of insulation failures or inadvertent contact by an installer

    如果數據電纜附近有高壓電纜經過，在諸如絕緣失效、意外接觸設備，則會存在故障電勢。
  11. Make sure to connect all of the following leads. otherwise there is a risk of electric shock, damage to the equipment, or malfunction

    務必連接下列所有導線。否則，可能導致觸電、設備損壞或故障。
  12. While diagnosis of electronic circtuitry using infrared thermography has been proven to be an attracting, rapid and non - contact method, the new technology does not conform to traditional guidelines for automatic test equipment

    作為一種新興的電路板故障診斷技術，熱圖像處理診斷以其非接觸、快速和勿需相關維修資料的獨特優勢，受到了越來越多的關注。
  13. The air - powered machine of chopper because of having structure in brief, maintenance convenient, the cost was low and otherwise advantages to get an extensive application, but often took place breakdown on control circuit of air providing in actually running, causing the contact point of relay to glue together and burning it to bad, the air pressure getting unusually state and the like other serious obstacle

    高壓斷路器氣動機構由於具有結構簡單，維護方便，成本低等優點得到了廣泛的應用，但在實際運行中常發生氣體打壓控制迴路故障，導致接觸器接點粘連燒壞，氣體壓力異常等嚴重障礙。
  14. In this thesis the development of noncontact monitoring blade vibration in china and other countries is summarized, the mathematical model of measuring blade vibration is presented, the monitoring system of blade vibration parameters in steam turbine is manufactured, and the theory of fuzzy diagnosis and the technology of multi - scale analysis are used to research fault blade

    本文綜合國內外葉片振動非接觸測量技術的發展，給出了葉片動態測量的數學模型，研製了汽輪機葉片振動狀態監測系統，用模糊診斷理論和多解析度小波分析技術對葉片故障機理進行了研究。
分享友人
分享到 Line

分享到臉書