接觸電離 的英文怎麼說

中文拼音 [jiēchùdiàn]
接觸電離 英文
contact ionization
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  • 觸電 : get an electric shock; electric shock
  1. As to the high speed of electric spindle system, the angle - contact bearings are usually applied to supporting the shafts. because the supporting stiffness of rolling bearing is non - linear, especially under the circumstances of high speed and ultrahigh speed, the internal working status is so complicated that it is not regarded as routine linear support and ordinary non - linear support. centrifugal effect of the rolling bearing increase the factors of influencing the supporting stiffness

    高速主軸系統的轉速很高,通常都採用角球軸承作為支承,由於滾動軸承的支承剛度呈非線性形式,特別在高速和超高速情況下,滾動軸承內部的動力學狀態十分復雜,由於滾動體運動所產生的心力作用,使得影響其支承剛度的因素增多,不能作為常規的線性支承和普通的非線性支承處理。
  2. Degradation of p - chloronitrobenzene in aqueous solution by contact glow discharge electrolysis

    輝光放子體降解水體中的對氯硝基苯
  3. Sren combines the advantages of daqo and siemens, providing railway electrification products ( ocs clamps & fittings, vcb, disconnector switch, power - supply switchgear etc ) with advanced technology and on - time considerate service

    南京賽彤鐵路氣化有限公司集大全和西門子的優勢為一體,在提供鐵路氣化產品(網零件,斷路器和隔開關,供配系統等)的同時也帶給用戶先進的技術,及時周到的服務。
  4. After the construct of the motion simulation model, genetic algorithm is used to do the adjustment of pid parameters of the control system of the joint motors, integral separation pid control and angle error analysis is finished, and three force / torque sensors, touch sensors, distance sensors and photoelectric switches are calibrated and installed

    在建立了機器人關節控制系統模型后,使用遺傳演算法對其關節機控制系統進行pid參數整定,進行機器人關節的積分分的pid控制策略和轉角誤差的理論分析,並進行了機器人三維力/力矩傳感器、傳感器、測距傳感器和光開關的標定與安裝。
  5. To achieve accurate detection of surface potential, the measurement of the contact potential difference of the zno / si step was also carried out. polarization - related surface properties of ferroelectric thin films were investigated by kelvin probe force microscopy ( kpfm ), leading to the discovery of asymmetric charge writing on the surface of pb ( zr _ ( 0. 55 ) ti _ ( 0. 45 ) ) o _ 3 ( pzt ) thin film

    為了優化儀器的檢測靈敏度和穩定性,選用氧化鋅薄膜上的zno / si臺階作為測試對象,檢測了zno / si的勢差;通過改變儀器系統參數,發現針尖-樣品距和掃描速度對勢差的檢測結果影響顯著。
  6. In this thesis, based on racah method of two - electron atom and non - relativistic energy structure for helium - like atoms, the relativistic corrections and the fine structure of helium - like atoms, including the relativistic mass correction, the darwin correction terms, the electron - electron contact terms, the orbit - orbit interaction, the spin - orbit interaction, the spin - other - orbit interaction and the spin - spin interaction, are studied systemically using irreducible tensor. concretely, the main works of this thesis are as follows

    本文以雙子原子結構的拉卡理論和類氦子的非相對論原子結構的計算結果為基礎,利用不可約張量理論,較為系統地研究了類氦子的相對論效應和精細結構,包括相對論質量修正、達爾文修正、子與子之間相互作用、軌道-軌道相互作用、自旋-自旋相互作用、自旋-其它軌道相互作用以及自旋-軌道相互作用。
  7. The chief results and conclusion thus arrived at are as folloes : ( 1 ) the morphology and electrical properties of indium - tin - oxide ( ito ) films which were treated respectively by ethanol, naoh, sulfuric and oxygen plasma, were studied from microscopic view by atomic force microscopy, x - ray photoelectron spectroscopy and goniometer

    ( 1 )利用原子力顯微鏡、角測試儀、紫外分光光度計從微觀角度研究了乙醇、氫氧化鈉、濃硫酸、氧等子體處理對ito薄膜的表面性能和光性能的影響。
  8. To explore the effect of bamboo stick contacting time with serum sample on serum potassium ion concentration, we have systematically measured serum potassium ion concentration of bamboo stick contacting with serum sample at different times using ion selective electrode method and analyzed their potassium ion concentrations using matching t test

    摘要為探討竹簽血清樣品時間對鉀子濃度影響的程度,採用子選擇極法分別對竹簽在血清中浸泡不同時間的樣品鉀子濃度進行測定,並以配對t檢驗對不同浸泡時間的血清鉀子濃度進行對比。
  9. Report any electrical accident or damage or interference to an overhead line to the relevant parties, including the electricity suppliers. remove everyone from the immediate area of the damageinterference but do not attempt to remove any objects, retract mobile cranes or to touch the injured person if heshe is still in contact with the overhead line conductor, because the line may still be live

    如發生任何力意外或架空纜遭受任何損壞或干擾,必須向有關方面包括供商報告,並須將所有人撤受損壞干擾影響的地方,但不得企圖移走任何物件、駛任何流動起重機,或及架空纜導體而受傷的人,因為纜可能仍然帶
  10. Rolling bearings - double - row angular contact ball bearings for electromagnetic clutch of car air - conditioner

    滾動軸承.汽車空調合器用雙列角球軸承
  11. All diodes have large reverse leak current density, which maybe caused by some reasons such as many ions are brought in course of evaporating metal on silicon surface of 6h - sic, chemical etch brings disfigurements such as burrs and dentate erodes as well as the rinse on surface of samples is not drastically accomplished

    兩個肖特基二極體反向漏流較大,估計原因為正面蒸發金屬時引入大量子、光刻引入毛刺和鉆蝕等缺陷、金屬與樣品粘附能力差及樣品背面歐姆制備好后正面清洗不充分等。
  12. In the laboratory experiment part, human peripheral blood, cultured cells and icr mice were study objects. the changes of mitotic chromosome numbers were measured by human metaphase chromosome counts and statistic analyzed used x2 - test. the changes of meiotic chromosome numbers were measured by mice one - cell zygote chromosome counts and statistic analyzed usedx2 - test. the effects of low dose ionizing radiation on the expression of topoisomerase ii were measured by immunocytochemistry, western blot and rt - pcr

    流行病學結果顯示長期小劑量輻射與染色體不分呈正相關,為進一步在細胞遺傳學和分子生物學方面研究小劑量輻射與染色體不分關系及其機制,本課題第二部分以外周血、培養細胞、 icr小鼠為研究對象,用外周血染色體計數和單細胞受精卵染色體計數的方法研究小劑量輻射和拓撲異構酶復旦大學2000級博士生學位論文11a抑制劑及其二者的協同效應對有絲分裂和減數分裂染色體不分的影響,用免疫細胞化學染色、 westernblot 、 rt pcr等方法研究了輻射引起拓撲異構酶a表達變化。
  13. Can we completely avoid being exposed to ionising radiation

    我們可以完全避免接觸電離輻射嗎?
  14. Air - conditioner is one of the important auxiliary equipments in automobile application. the structure and functions of double row angular contact ball bearings for electromagnetic clutch in air - conditioner will directly influence the performance of the compressor

    汽車空調器是汽車上的重要輔助設備之一,汽車空調合器用雙列角球軸承結構與性能的好壞,直影響汽車空調壓縮機的性能。
  15. Integration of isolator, circuit breaker, contactor, thermal overload relay and function module into just one device, which itself can fulfill all the d. o. l starting and control functions

    集隔器、斷路器、器、熱繼器、功能模塊與一體,只需單體設備即可完成動機直起動-控制全部功能;
  16. This paper begins with the calculation of the stator ' s resonance frequency, deals with the design and manufacture of motor, and puts forward dual nut structure of traveling wave revolving ultrasonic motor, and presents the analysis of the contract between rotor and stator in the manufacturing process, relation between the amplitude of voltage - ceremic chip and drive sources. the conclusion is that amplitude is affected by deviation of resonance frequency

    同時分析了動機的加工工藝,對超聲波動機製造過程中功率與角和振幅與驅動源的關系進行了討論,得到了角與輸出功率的關系曲線,以及超聲波動機的振幅主要受壓和激振頻率偏定子環第2n階諧振頻率的偏量確定。
  17. Ultrasonic distance measurement belongs to the category of uncontact measurement. in the condition it has advantage which contact measure does n ' t has contrasting with uncontact measurement. ultrasonic measure is not influenced by rays of light in the range, and has simple struture, and cost cheaply cotrasting to other uncontract measurement such as laser measurement, rared ray easurement, radio measurement

    超聲波測距屬于非檢測的范疇,它在許多場合有測量不可比擬的優越性,同時與激光、紅外、無線等其它非性檢測相比,超聲檢測在一定距范圍內不受光線影響、結構簡單、成本低等特點。
  18. A bulk micromachined relay with lateral contact and isolation structure

    具有隔結構的橫向式體硅微機械繼
  19. This kind of alarming device makes use of heat - releasing infrared transducer, which can discern the special infrared rays of the human body and transform them to electrical signals, then send the signals to single chip

    利用熱釋紅外傳感器作為探頭,進行非式遠距檢測,將感測到的紅外信息轉換成壓信號,經過單片機處理,完成數碼顯示和語音報警功能,從而實現了防盜報警功能,達到了安全防護的目的。
  20. Connectors for electronic equipment - part 4 - 107 : printed board connectors with assessed quality ; detail specification for shielded two - part connectors having a basic grid of 2, 0 mm, fixed part with solder and press - in terminations for printed boards, free part with non - accessible insulation displacement and crimp terminations

    子設備用連器.第4 - 107部分:經質量評定的印製板連器.基本網格為2 . 0mm有屏蔽的兩件式連器詳細規范,固定件帶有焊和壓入端,活動件帶有不可的隔位移和壓
分享友人