接頭連接劑 的英文怎麼說
中文拼音 [jiētóuliánjiējì]
接頭連接劑
英文
connecting cement- 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
- 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
- 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
- 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
- 連接 : connect; fit together; link; marry; mate; joint; association trail; linkage; concatenate; concate...
-
Plastics piping systems - injection - moulded socket fittings for solvent - cemented joints for pressure piping - test method for resistance to a short - term internal hydrostatic pressure
塑料管道系統.壓力管道溶劑膠粘接頭的注射模塑承口連接管件.短期內部液壓壓力的試驗方法Sealing materials for metallic threaded joints in contact with 1st, 2nd and 3rd family gases and hot water - anaerobic jointing compounds
與第1 ， 2 ， 3類家庭用燃氣和熱水裝置連接的金屬螺紋接頭的密封材料.厭氧密封劑Sealing materials for metallic threaded joints in contact with 1st, 2nd and 3rd family gases and hot water - non - hardening jointing compounds
與第1 ， 2 ， 3類家庭用燃氣和熱水裝置連接的金屬螺紋接頭的密封材料.非硬化密封劑It was found that the interfacial bonding of 93w - ofc was both the joining action of ofc / w grains and that of ofc / ni - fe binders, whereas the joining of ofc to tc4 could be seen as the mutual intense diffusion effect between ofc / tc4 and as a result cu - ti intermetallic compounds were formed at the joint. the joining of tc4 - a1 and a1 - mb2 were also attributed to the result of diffusion between elements ti - al and al - mg respectively. on the other hand, residual thermal stress and stress - induced distortion were produced at the joint simultaneously due to the difference in thermal expansion coefficient of different welding " materials
研究表明， 93w與ofc的界面連接是ofc與93w中w晶粒的連接以及ofc與93w中ni - fe粘接劑的連接共同作用的結果； ofc與tc _ 4連接界面的形成是由於ofc與tc _ 4之間發生反應擴散，並由此在二者接頭處生成了cu - ti金屬間化合物的中間相； tc _ 4 - al的連接與al - mb _ 2的連接則分別是其基體元素ti 、 al之間和al 、 mg之間元素互擴散的結果，另外，由於熱膨脹系數的差異，擴散焊接后在不同焊件的接頭處存在殘余熱應力並由此引起接頭的形變。The numerical modeling results show that the smaller the elastic modulus of adhesive in fillet, the higher the peak stress in adhesive layer at the adjacent point to the fillet when hi - adhesives used to form the fillet and bondline respectively and is higher than that of the joint made of single adhesive
結果表明，當膠瘤採用不同於膠層的膠粘劑時，隨著膠瘤彈性模量的減小，在膠層與膠瘤的連接處膠層中應力峰值顯著提高，且均高於由單一膠所形成接頭的應力峰值。分享友人