損耗角正切 的英文怎麼說

中文拼音 [sǔnhàojiǎozhēngqiē]
損耗角正切 英文
loss tangent
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 切 : 切Ⅰ動詞1 （合; 符合） correspond to; be close to 2 （用在反切后頭 表示前兩個字是注音用的反切）見 ...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. Low dissipation factor, high ripple current

    低損耗角正切，高紋波電流。
  2. Test method for dielectric tangent of loss angle of pyroelectric material

    熱釋電材料介質損耗角正切tan的測試方法
  3. Method for verifying accuracy of tan delta measurements applicable to capacitors

    校驗電容器損耗角正切測量準確度的方法
  4. Method for verifying accurancy of tan delta measurements applicable to capacitors

    校驗電容器損耗角正切測量準確度的方法
  5. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  6. Vulcanized rubber - determination of dielectric constant and dielectric loss angular tangent value

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  7. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent value

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  8. Test method for dielectric loss angle tangent and dielectric canstant of organic film for use in capacitors

    電容器用有機薄膜介質損耗角正切值和介電常數試驗方法
  9. Vulcanized rubber - determination for industrial frequency dielectric constant and dielectric loss angular tangent

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  10. Recommendations for the presentation of plastics design data - electrical properties - loss tangent

    塑料設計數據表示方法推薦標準.第2部分:電氣特性.第2節:損耗角正切
  11. The paper focuses on the processing technique of wood flour - recycle polystyrene composite, and assesses the effects of wood flour contents, coupling agent contents and the rotate speeds of extruder on water uptake, tension strength, bending strength and dynamic mechanical properties. the results can be shown as follows : with the increasing of wood flour, composites gain higher water uptake but lower dynamic mechanical properties, the storage moduli ( e " ) and glass transition temperature ( tg ) decrease

    較系統地研究了木粉含量、偶聯劑添加量和雙螺桿擠出機的螺桿轉速等主要擠出工藝參數對復合材料的吸水性能、拉伸強度、彎曲強度、動態機械性質（存儲模量e和損耗正切角tan ）的影響規律，初步確定了適宜工藝條件，主要結論是： 1 ）木粉含量的增加使得復合材料的吸水性能增加，動態機械性質下降。
  12. Of a dielectric, the product of dielectric constant and the tangent of its dielectric loss angle ; a measure of the heating effect which occurs in dielectrics

    對于電介質來說，它是介電常數和介質損耗角的正切的乘積，這是對出現在電介質中的熱效應的量度。
  13. The product is characteristic of low dielectric largent at high frequency and is self fluxing it ' s suitable to be used as elements and coils of high frequency equipment

    該產品具有在高頻下漆膜的介質損耗角正切小的特性，並且有直焊性，適應高頻電器儀表繞圈和元件。
  14. Rlc elemental meter is a kind of intelligent instrument used to measure elemental parameter such as resistance, inductance, capacity, quality and so on

    Rlc測量儀是一種以微處理器為基礎的自動測量電阻r 、電感l 、電容c 、品質因數q 、損耗角正切值d等參數的智能元件參數測量儀器。
  15. Under the condition of rated voltage and 20, the tangent of the loss angle of film - paper capacitor is less than 0. 0008, and that of film dielectric capacitor is less than 0. 0005

    5 .在額定電壓下，溫度20時電容器的損耗角正切值，膜紙復合介質tg0 . 0008全膜介質tg0 . 0005 。
  16. The dielectric constants of silica - rich, alumina - rich, and stoichiometric mullite ceramics are 5. 5, 6. 0 and 6. 3 respectively. the dielectric constant of mullite - si / c / n composites is related with the sintering parameters. with the increase of the sintering temperature and dwelling time, the " " and tg of mullite - si / c / n composites are decreased, this phenomenon is related with the change of the microstructure and phase composition of nano si / c / n powders

    莫來石- si c n復合材料的介電常數與熱壓燒結工藝有很大的關系，隨熱壓燒結溫度（ 1450 1600之間）的升高，燒結時間（燒結溫度為1550 ）的增長，莫來石- si c n復合材料的介電常數實部、虛部及介電損耗角正切均明顯下降，這與吸收劑的性質隨溫度和時間的變化有關。
  17. Method for determination of loss tangent and permittivity of electrical insulating materials in sheet form lynch method

    薄型電絕緣材料損耗角正切值和介電常數的測定方法
  18. Test methods for properties of structure ceramic used in electronic components - test method for dielectric loss angle tangent value

    電子元器件結構陶瓷材料性能測試方法介質損耗角正切值的測試方法
  19. Based on detailed analysis about dielectric loss measuring methods, the spectrum analysis method is selected

    在對介質損耗角正切值多種在線監測方法進行詳細分析的基礎上，選中頻域分析法。
分享友人
分享到 Line

分享到臉書