撓曲軸 的英文怎麼說
中文拼音 [náoqūzhóu]
撓曲軸
英文
curved axis-
However, under heavy load the shaft may deflect excessively.
但是，在重載作用下，軸會發生過度撓曲。And results are : ( 1 ) analyze the force and distortion on pipeline under collapse and gulch in theory. on the base of beam deformation, analyze the bending moment and deformation of pipeline with frusta and without frusta. calculate a true problem, contrast the differences between pipeline with frusta and one without frusta, draw some conclusions
得到的主要結果為： （ 1 ）基於彈性地基理論和彈性梁的撓曲線理論，給出了管道在固定墩（相當跨越河溝情況）和無固定墩（相當坍塌和沖溝情況）的變形微分方程，並分析了當量軸力為拉力或壓力時管道的變形和受力情況。Standard test method for flexibility determination of supported adhesive films by mandrel bend
用芯軸彎曲試驗法測定承托粘結膜撓曲度的標準試驗方法As regards to the spheric thin shell structure under external hydro static pressure, basing on flat - plate theory and by using basic von karman equations for large deflection, the equilibrium problem of axisymmetric bending of the spheric shell under uniform external pressure is simplified to an equilibrium problem of bending of elastic basic flat - plate and further converted into an equilibrium problem of beam on elastic fundation taking into consideration of the deformation characteristics
對球形薄殼結構隨靜水外壓的情況，應用平板理論中的vonkarman大撓度基本方程，將球形薄殼在均勻外壓下的軸對稱彎曲平衡問題簡化為彈性基礎平板的彎曲平衡問題，進而再根據變形特點將其轉化為彈性基礎梁的復雜彎曲平衡問題。( 2 ) with f varying, there exists a number fr which is about - 1 ( curvature, torsion and dean number have little influence on fr ), when f > fr, the maximum of the axial velocity is near the outside bent and the friction factor ratio increases with f increasing ; when f < fr, the maximum is near the inner side bent and the ratio increases with f decreasing ; when f = fr, the distributions of the axial velocity are similar to those of poiseuille flow and the friction ratio is about 1
（ 2 ）當f變化時，存在確定的數值fr （ fr在- 1左右。曲率、撓率和dean數對fr的影響很小） ，當f fr時，軸向速度最大值偏向外側，摩擦系數比隨f增大而增大；當f fr時，軸向速度最大值偏向內側，摩擦系數比隨f減小而增大；當f = fr時，軸向速度的分佈和poiseuille流近似相同，摩擦系數比約為1 。In the small deflection theory, by buckling analysis, the classical buckling critical load of integrative braid composite cylindrical shells under axial compression is get. according to the experience and the results of fem, a revised formula for calculating buckling critical load is presented
在小撓度理論中，通過前屈曲分析得到了完善的編織復合材料圓柱殼在軸壓情況下的經典屈曲臨界載荷，根據經驗及有限元計算結果，提出了計算屈曲臨界荷載的修正公式。But method based on large deflection theory was proposed in this paper. accordingly, output force and displacement of each sma actuator under anticipative attitude was obtained as well as accurate coordinate of the center of the joint and deflection curve equation of the axis of the active catheter
基於大撓度理論對主動導管做了力學和運動學分析，相應獲得了預期姿態下各個sma驅動器上的輸出力和輸出位移，以及精確的關節中心位置坐標和導管軸線撓度曲線的具體形式。Observing the mechanics and effect of the new strengthening method with test and finite element method is supposed to offer a guide for technology and become valuable in theory and practice. both compression test, including four reinforced and three control specimens, and shear - compression test, including nineteen reinforced and four control specimens are being studied in this paper. the research on the curves of load - strain, load - deflection and hysteretic shows that the transverse translation of the reinforced columns is well controlled with an upgrading of both ductility and ultimate bearing capacity ( ubc )
本文對4根鋼絲網外噴高強砂漿加固鋼筋混凝土柱和3根對比鋼筋混凝土柱進行了軸壓試驗研究，並對19根加固鋼筋混凝土柱和4根對比鋼筋混凝土柱進行了剪壓試驗研究；通過對試件荷載-應變曲線、荷載-撓度曲線和滯回曲線等的研究表明，採用該加固方法能有效的約束柱子橫向變形，並對提高鋼筋混凝土柱的極限承載力和延性有明顯的效果；同時根據理論及加固機理分析提出了適應於此加固方法的軸壓極限承載力計算公式。Bending and vibration of the shaft of the charging pump used for mud pump occur owing to the pump " s special working conditions, resulting in the leakage of the shaft sealing system
由於鉆井泵用灌注泵的特殊工作條件，工作時泵軸產生較大撓曲和振動，從而造成軸封泄漏。Abstract : bending and vibration of the shaft of the charging pump used for mud pump occur owing to the pump " s special working conditions, resulting in the leakage of the shaft sealing system
文摘:由於鉆井泵用灌注泵的特殊工作條件，工作時泵軸產生較大撓曲和振動，從而造成軸封泄漏。分享友人