撞碎機 的英文怎麼說

中文拼音 [zhuàngsuì]
撞碎機 英文
percu ion-grinder
  • : 動詞1 (猛然碰上) collide; strike; knock; bump against; run into 2 (碰見) bump into; run into;...
  • : 動詞[書面語] (觸; 撞) strike; bump
  • : machineengine
  1. Based on the principle of mechano - chemistry, the strong shock and crashing mechanical force produced by ls - 250 pulverizer can act to the surface of superfine carbon and white carbon particles during the process. the result of the experiment indicated that distortion and amorphism change occur to the surface crystal lattice of carbon particles, and the phenomena are prick up as the action time of mechano - chemical force

    依據械化學原理利用ls一250型流能粉高速旋轉的動齒工作過程中產生的強烈沖擊、碰械力,使其作用於超細石墨及白碳黑顆粒表面,檢測表明,石墨粒子表面晶格發生畸變及無定形化,且隨著械力作用時間的延長而加劇。
  2. As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn

    理論工作方面,首先描述了針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質,然後結合針型高壓小孔徑離心式噴嘴的結構特點,將其霧化加濕過程分三個階段進行理上的研究,這三個階段依次為液膜形成、液膜初次破及二次霧化、水與空氣的熱濕交換。
  3. The single - stage hammer crusher are suitable used to crushing ordinary fragile ores of the compressive strength no more than 200mpa, such as limestone, gypsum, coal, marl, sand - shale etc. this series product features of high crushing ratio, even product graininess, simple construction, reliable operation, easily maintenance, economical running cost etc., so are widely used. hammer crusher models hammer crusher max

    錘破系經高速轉動的錘體與物料碰面破物料,錘式破具有結構簡單,破比大,生產效率高等特點,錘式破可作干濕兩種形式破,錘式破適用於礦山水泥煤炭冶金建材公路燃化等部門對中等硬度及脆性物料進行細
  4. Production, sale, rental or use of a handheld percussive breaker

    製造、經銷、出租或使用手提擊式破
  5. Hammer - flake grinder uses the energy that the high - speed rotary, hammer - flake schleps to hit the raw materials, and makes them luther grinde when gear plate and sieve plate hit together

    錘片粉利用高速旋轉的錘片所攜帶的能兩擊物料,使物料破並能高速與齒板碰后進一步破,此過程反復進行,直到物料小於篩板孔徑后穿過篩板排出外。
  6. At first in the condition of low - velocity impact it is discussed with the formation of ceramic smash cone angle on the base of quasi - statistic hertz and 3 a 6 y a c - theory. then using spherical stress wave reflection and transmission theory under the state of medium - high velocity the formation of spot in the ceramic back. finally the damage mechanism of ceramic suffered by the high impact is simply discussed

    首先,在低速擊的條件下,基於準靜態hertz的理論與薩布斯基理論,分析了陶瓷破錐角的形成;其次,在中高速擊條件下,利用球面應力波反射迭加理論,分析了陶瓷背面的層裂的形成;最後,簡單討論了高速擊下陶瓷的破理。
  7. The series equipment versatillty, its performance had achieved the international advanced level, is at present is most effective, the practical reliable crushed stone machine, is suitable specially for the manufacture grinding compound, fireproof the matreial, the cement, the quartz sand, the emery, the stove are cut broken glass the power, the copper ore, the concrete aggregate and so on many kinds of, the crisp materials on the control granulated substance machine energy conserva tion 50 %, is in the present world system qranulated substance equipment

    物料由器上部垂直落入高速旋轉的葉輪內,在高速離心力的作用下,與另一部分以傘狀形式分流在葉輪四周的物料產生高速擊與粉,物料在互相擊后,又會在葉輪和殼之間以物料形成渦流多次的互相擊、摩擦而粉,從下部直通排出,形成閉路多次循環,由篩分設備控制達到所要求的成品粒度。
  8. The critical velocity at which the bird body impacts the glass at middle point to result in break of the glass is 570 - 580km / h

    圓弧風擋玻璃的中點時風擋玻璃發生破的臨界速度約為570 ? 580km h 。
  9. Material is ejected into the crushing chamber by means of high speed ejection flow formed by high - pressure air through charging ejector, and the crushing nozzles outside ejects high - speed airflow into the crushing chamber at certain direction, making the materials severely collided and fractionated, and thus crushed

    是靠高壓氣體通過加料噴射器所形成的高速射流,使粉原料被射入料室,粉室外圍的粉噴嘴,有方向性的向粉室噴射高速氣流,使物料間產生激烈的碰,磨擦而獲得粉
  10. The optimum design of the beat back - impact crusher is proposed, which aims at the highest efficiency of the machine work. the optimum designed mathematics model of the main structural dimension of the crusher ( m, xc, s, w 2 > ir ) is built with restraining conditions such as force condition, energy condition, hammer steady condition, no moving interference, strength of spin axle and bearing condition, upper limit and lower limit of the design variant condition etc. finally, an example is give to illustrate the efficiently of the method proposed

    在綜合考慮影響破效率的各因素的情況下,提出了滿足以力,能量,錘頭穩定性,幾何條件,不發生運動干涉,轉子軸和滾動軸承的強度等約束條件,建立了包含破關鍵參數(錘頭質量m ,軸心o到銷軸錘頭接觸距離r ' ,四川大學碩士學位論文錘頭質心到銷軸與錘頭接觸點的距離拙,錘頭與巖石碰到銷軸與錘頭接觸點的距離s ,轉子的速度。
  11. Aiming at the fact that more debris collision risks are to the low earth orbit spacecraft in the getting worse debris environment, this paper gives a set of feasible debris early warning method and maneuver strategy, by means of which spacecraft can adopt orbit maneuver, evade dangerous objects so as to improve viability under the control of ground command and control center

    本論文的研究是應對日益惡化的空間片環境對近地航天器造成的碰風險,提出一套可行的片預警方法和規避策略,使航天器在必要時刻,通過地面的指控,採取主動的軌道動,躲避危險物體,從而提高生存能力。
  12. The deep impact flyby spacecraft carries two cameras and an infrared device to analyze spectral data, while the impactor carried a camera that sent back dramatic images of the comet until three seconds before the collision

    深沖擊飛行由航天器運載二臺照相和一個紅外設備分析數據,當"錘"運載了退還彗星的劇烈的圖象直到三秒在碰之前的一臺照相
  13. Noise control hand held percussive breakers amendment regulation 2000

    2000年噪音管制手提擊式破修訂規例
  14. Noise control hand held percussive breakers fee revision regulation 2005

    2005年噪音管制手提擊式破費用調整規例
  15. 400 1988 ; noise control hand held percussive breakers regulations 1991 ; noise control air compressors regulations 1991

    1991年噪音管制手提擊式破規例1991年噪音管制空氣壓縮規例
  16. Noise emission labels the noise control ordinance also provides for the control of noise from hand - held percussive breakers and air compressors

    手提擊式破及空氣壓縮發出的噪音同樣受《噪音管制條例》規管。
  17. Noise emission labels are issued for air compressors and hand - held percussive breakers to make sure that they comply with stringent noise control standards

    手提擊式破及空氣壓縮,均須獲簽發噪音標簽方可使用,以確保它們符合嚴格的噪音標準。
  18. At present, the noise control hand held percussive breakers regulations and the noise control air compressors regulations stipulate that only the handheld breakers and air compressors complying with the noise emission standards shall be allowed to be imported, manufactured or supplied for use in hong kong and be attached with a noise emission label before its usage

    現時,噪音管制手提擊式破規例及噪音管制空氣壓縮規例訂明,只有符合噪音標準的設備,方可獲準輸入製造或供應給本港使用。此外,有關設備在使用前必須貼上噪音標簽。
  19. Controls the import, manufacture, supply and use of hand held percussive breakers and portable air compressors. requires such noisy construction equipment to comply with a stringent noise emission standard and be fitted with a noise emission label issued by the director of environmental protection before use

    管制進口製造供應及使用手提擊式破和手提空氣壓縮,規定這類高噪音建築設備必須符合嚴格的噪音標準,並須貼上環境保護署署長簽發的噪音標簽方可使用。
  20. Breakers that weigh more than 10 kilograms and air compressors that can supply compressed air at 500 kilopascals or above must be fitted with noise emission labels when being used for construction work

    重量超過10千克的手提擊式破及壓力不少於500千帕斯卡的空氣壓縮,必須符合法定的噪音標準,並須貼上噪音標簽,方可使用於建築工程上。
分享友人