擬對比的 的英文怎麼說

中文拼音 [duìde]
擬對比的 英文
pseudoreduced
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • : Ⅰ動詞1 (回答) answer; reply 2 (對待; 對付) treat; cope with; counter 3 (朝; 向; 面對) be tr...
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • : 4次方是 The fourth power of 2 is direction
  1. It is approved that the proposed method has higher antinoise and signal - to - noise ratio than the direct correlation method

    能過數字模表明,該方法優于直接相關定位法,具有較強抗噪聲能力,提高了信噪
  2. At last, two types mode ( ccm and dcm ) of the synthetic circuit is emulated. the results of emulation meet the function requirement

    最後還晶元不同外圍電路下兩種工作模式(有補償電路和無補償電路)做了模
  3. For the wave - guide of sch - sqw 940nm quantum well laser, we used this way to simulate and compare, got the far - field corner 35. 8 when the al percent was 25 % and wave - guide ' s thickness was 150nm. compare with the results former, this value was improved much

    于本文中採用分別限制單量子阱發光波長940nm半導體激光器波導結構,利用該理論方法進行模后,得到當波導層al組分為0 . 25寬度為150nm時遠場發散角為35 . 8 ,較以往有很大改善。
  4. On the base of studying in arithmetic of predictive control, different math models are used to approach the control system. general water level control, pid control and predictive control using in sewage pumping station are compared. by simulating the different models using in control system, the conclusion that the aim of saving power and preventing pollution in sewage pumping station can be achieved by using predictive control is got

    在預測控制演算法研究基礎上,分析了用不同數學模型逼近污水泵站排放系統,較了採用常規水位控制、 pid控制和預測控制污水泵站排放系統控制效果,在模結果基礎上,得到了採用預測控制可以更好解決節能無污控制目標結論。
  5. This project intends to construct a parameterized function banks about the internal properties of wavelets aimed at a extensive kind of multi - wavelets and some categories of relatively specific non - separable wavelets with significant practical background, and disclose the essential characters of non - separable wavelets. through optimizing the bases of wavelets, it will build a problems oriented system of self - adaptive wavelets neural network and apply it to the relative problems of signal processing

    本課題較廣泛一類多小波及相特殊但具有十分強烈應用背景幾類非分離小波建立關于小波各種內在性質參數化函數庫,並試圖揭示非分離小波本質特徵;通過最優化小波元和小波基函數,建立面向問題自適應小波神經網路系統,並應用於相關信號處理問題。
  6. Afterwards, in order to decrease the contradiction between the more complex and mass remote sensing image data and relatively slow speed of information extraction, an improved sfim image fusion method is proposed. this modified algorithm is on the base of sfim fusion technique, combines ihs method and sfim method and then replaces the former mean filter by an adaptive weighted mean filter. compared with the results of several common fusion techniques through a set of simulation tests between multispectral images and panchromatic images, it is proved that the new method can get an excellent result for the aim of improving spatial resolution while preserving the spectral information of multispectral images

    論文主要工作和成果包括:在像素層,論文研究了多傳感器數據融合理論及遙感圖像預處理過程和步驟,歸納了多源遙感圖像像素層融合常用演算法,並針目前遙感數據呈海量化、復雜化這一發展趨勢同遙感信息提取能力和效率滯后這一矛盾,在sfim演算法基礎上,將ihs變換與sfim相結合,將原演算法中均值濾波器改進為自適應加權均值濾波器,提出了一種改進sfim演算法,通過一組多光譜圖像和全色圖像雙傳感器融合模試驗,證明了該演算法在保持原多光譜圖像光譜信息同時,能夠有效提高融合圖像空間分辨能力。
  7. When using the adjoint - model assimilation system, the experiment adding cdw can directly improve the wind forecast, but comparing the one not adding cdw it has little advantage over other elements forecast

    根據同化試驗結果,此次暴雨動力場模分析后認為,同化雲導風后可改善動力場配置,提高暴雨模精度。
  8. The terrain effect force wind ' s speed reducing and wind ' s direction turning to left with contrasting the experiments of numerical simulation the text analyses the structure and microcosmic character of sea wind in zhoushan maritime space and consanguineous connection between sea wind and action of dynamical and thermodynamic. the task gets the result of case a by using t213 datum of weather center and contrasts it with the actual sea wind. the task establish a foundation in order to use this mode in the environmental forecasting

    通過數值模試驗,分析了舟山海域海面風結構和微觀特徵,以及海面風與動力作用(復雜地形)和熱力作用(海陸熱力差異)之間密切關系。進一步利用國家氣象中心提供t213高解析度預報場檢驗海面風風場數值預報效果,最後將其結果與實際觀測作較,為將該模式投入環境(海流,海浪,風暴潮等)動力預報奠定基礎。
  9. Two kinds of common used snubber circuits are studied through simulation and experiment. it is pointed out that the rcd snubber has less power loss. increasing the turn ratio of transformer is helpful for the energy, which is stored in the primary side of transformer, to be transferred to the secondary side

    通過實驗和模研究了電路中周波變換器兩種常用緩沖電路,指出採用rcd緩沖電路損耗更小;提高變壓器匝有利於減小鐵芯儲能回饋,提高逆變器變換效率,但它同時也增加了副邊功率管電壓應力,必須綜合兩方面確定合理
  10. As an example, the parallel machine scheduling problem is mapped on a non - constrained matrix construction graph, and a aco algorithm is proposed to solve the parallel machine scheduling problem. comparison with other best - performing algorithm, the algorithm we proposed is very effective. the finite deterministic markov decision process corresponding to the solution construction procedure of aco algorithm is illustrated in the terminology of reinforcement learning ( rl ) theory

    本章最後提出了解決并行機調度問題蟻群演算法,該演算法把并行機調度問題映射為無約束矩陣解構造圖,並在演算法信息素更新過程中應用了無約束矩陣解構造圖局部歸一化螞蟻種子信息素更新規則,與其他幾個高性能演算法試驗證明這種方法是非常有效
  11. The following important work has been done : ( 1 ) some special problems of rate - bias laser gyro were analysed. the problems include modulation and demodulation of the output and algorithm of the attitude updates ; ( 2 ) the integrated navigation system with the fault tolerance property which equipped with many navigation equipments as sins, gps, dvs, ads, mg, vg is designed, and compared with that of ckf via simulations ; ( 3 ) the theories and methods of system level fault detection apply to federated filtering is investigated ; ( 4 ) the problem about using the fused information of sins based on rate - bias laser gyroscope / dynamical tune gyroscope to realize the component level hard fault interactions detection through a back - propagation neural network is discussed

    主要研究工作有:研究了速率偏頻激光捷聯慣導陀螺測量信號解調演算法;設計了在速率偏頻激光捷聯慣導、 gps 、多普勒雷達、大氣數據系統、磁航向儀及垂直陀螺配備條件下聯邦濾波組合導航系統,聯邦濾波器和集中濾波器性能做了模分析;研究了適用於聯邦濾波器系統級故障理論和方法;探討了利用速率偏頻激光捷聯慣導撓性捷聯慣導陀螺混合測量信息,通過神經網路實現硬故障交互檢測方法。
  12. Using commercial finite element software ansys, the numerical simulations of the forming processes of decorated rib and handle, which are key positions in the door outer are conducted and investigated the differences of vpf and tradition forming. by using numerical simulation that investigates the effects of viscous injection flow rate on plank ’ s vpf formability and based on those investigated four - aluminum alloy ’ s vpf. the die has been designed for the door outer ’ s viscous pressure forming

    首先採用商用有限元分析軟體ansys車門成形中關鍵部位裝飾筋和把手成形進行了數值模分析了粘性介質壓力成形與剛性模成形特點;分析了粘性介質壓力成形過程中,粘性介質注入速率成形試件壁厚分佈影響,在此基礎上四種常用6000系列鋁合金板材粘性介質壓力成形進行了有限元數值模
  13. A simulated comparative study of significance t - test and meta - analysis

    檢驗與元分析方法
  14. This paper contrasts performance of current controlled two - state modulation inverter with one based on voltage mean value and instantaneous value feedback by simulation

    在此基礎上,電流控制兩態調制逆變器和電壓平均值電壓瞬時值反饋spwm逆變器性能進行了模
  15. And the fractionally spaced equalizers ( fse ' s ) are also presented in this thesis through comparing the performances of fse ' s and the common baud spaced equalizers. the computer simulations show that the fse ' s are especially suitable to the underwater acoustic channel with low snrs

    文章通過計算機模了分數間隔均衡器和普通波特間隔均衡器性能特點,並且發現當水聲通道噪聲較強時,特別適合於採用分數間隔均衡器。
  16. Finally, this paper analyses how to building up the mathematic models of the motor and discusses the detailed parts of pso - pid ’ s parameters obtaining, pso - pid ’ s adaptive function. by the compare of the system response speed, system stability, system robust which are achieved by use of matlab emluator of the traditional pid controller and pso _ pid controller, this paper draws the conclusion : the pso - pid controller is more flexibly, stably, adaptive, precise, robust

    通過傳統pid控制與pso - pid控制方法在系統響應快速性、系統穩定性、系統魯棒性三個方面,得出如下結論: pso - pid控制方法靈活性大、穩定性好、適應性強、準確度高、魯棒性優。
  17. Using matlab, the step response characteristics of the valve in the elevator system is simulated, comparing the effect of its performance with different structure parameters of the pipe rupture valve, such as hydraulic resistance, diameter of the valve, and spring rigidity, and comparing the valve ' s dynamic performance under different operating conditions, such as environment temperatures, number of passengers, and emergencies of the hydraulic system, so the paper offers a general and systematic analysis for the pipe rupture valve of the elevator system

    另外,在液壓電梯不同工況下,該閥動態性能進行了模研究,如不同環境溫度、不同乘客人數、不同液壓系統意外,以及不同油液體積彈性模量,較全面系統分析了限速切斷閥在電梯系統中性能,根據這些模結果,可以分析該閥正常工作工況要求和環境要求。
  18. The paper puts emphasis on three - dimensional numerical simulation research for the b7517e conical roller bearing in automotive transmission by comparing computer numerical simulation with classical result

    本文著重採用計算機數值模和經驗解析解分析方法,汽車后橋傳動用b7517e圓錐滾子軸承進行三維數值模研究。
  19. The oriented capability of between the new type bogie with the optimum schemes of longitudinal rigidity arrangement in the primary suspension and traditional bogie is analyzed and compared based on literature [ 2 ]

    在文獻[ 2 ]基礎上最佳一系縱向剛度布置新型轉向架和傳統轉向架車輛曲線性能進行了模
  20. The change of the characteristic sections of temperature process lines is analyzed and the coefficients obtained from analysis are used for comparison of the numerical simulation

    分析了特徵斷面溫度過程線變化特點,得到參數可供數值模使用。
分享友人