擬連續性原理 的英文怎麼說

中文拼音 [nǐliánxùxìngyuánlǐ]
擬連續性原理 英文
quasi-continuity principle
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 連續性 : continuity; solidity; sequence; continuance
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  2. Moke and fmr studies were performed on single crystalline fe ultathin films epitaxially grown on iii - v semiconductor gaas substrate with thickness 4. 1 - 33 monolayer ( ml ). a theoretical mode for fitting fmr experimental data was established. the results demonstrated the structures and reproduced the evolution of the magnetic properties of ultrathin films with various thickness from the state of superparamagnetic nano - cluster through coexistence of two magnetic phases to continuous film, especially the change of magnetic crystalline anisotropy from unixial to cubic

    1 - 33原子層厚度（ monolayer ，簡稱ml ）的fe單晶超薄膜進行了鐵磁共振（ fmr ）和磁光研究，建立了理論模型對鐵磁共振實驗結果進行了模擬，重現了不同厚度的超薄膜，從納米團簇到兩相共存的過度階段直至連續薄膜結構與磁性的變化，特別是磁各向異性從單軸各向異性向立方各向異性轉變的演化過程。
  3. The macro model of drift region resistance was established based on the solution of poisson ’ s equations and continuity equations. by the combination of spice mos ( level = 3 ) and the macro model, the complete dddmos model was then obtained, which accords well with simulated data. by simulating and comparing different devices of different process parameters, the model is applicable for different bias regions and can be useful in the power integrated circuit research in future

    首先介紹了器件建模的基本原理及相關模擬技術，然後利用工藝模擬軟體生成器件基本結構，並對其基本特性進行了分析;分析了業內和學術界比較通用的高壓器件建模的方法，隨后在模擬實驗的基礎上著重分析了dddmos的物理特性，在求解泊松方程、連續性方程等基本方程的基礎上，建立有物理意義的漂移區電阻的宏模型;隨后結合spicemos （ level = 3 ）模型而得到完整的dddmos模型，此模型與模擬數據符合得比較好，通過對不同工藝參數的器件進行模擬比較，該模型能夠覆蓋不同的工作偏壓范圍，具有較明確的物理意義，對今後的功率集成電路的研發有一定的參考意義。
  4. When the author sets up the mathematics model with describing the process of two - dimensional debris flow, he develops the continuity equation by the law of conservation of mass and establishes the momentum equations by the law of conservation of momentum. the author makes full use of the advanced computer technologies, establishes the finite difference equation of numerical simulation by the differential operator fission method, and writes programs for computers which contact friendly with the other programs. the parameters are directly input on the keyboard

    在泥石流堆積數值模擬方面，作者以前人工作成果為基礎，在建立數學模型時，根據質量守恆原理，推導建立了泥石流連續性方程，根據動量守恆原理，推導建立了泥石流運動方程;在數值解法上，充分利用高速發展的計算機技術，採用運算元分裂法建立數學模型的差分格式，開放式編製程序，人機對話方式設置參數，計算機程序具有通用性、可擴展性和易維護性。
  5. By simulating mathematically on frequency and on space, we can find the average speed of space field and the average speed of frequency field that is weighted by amplitude, and analyse their relation, and analyse the meaning of space speed variance x and frequency speed variance v. in the fourth part, how to ensure the height of cloud is introduced, and basing on the theory of wind field continuity, the height updating quality controlling is introduced. in the fifth part, the system of cloud wind is introduced, we tracked cloud - motion of consecutive satellite images with one - minute interval by the 1 - d fourier analysis technique and the two - dim fourier analysis technique and the fft analysis technique, and dispose them with quality controlling. in the sixth part, we summarized our research and put up with shortages of this article

    模擬模塊內各點的速度線性變化時，得到空間域平均速度以及頻率域以振幅為權重的平均速度，分析了空間域平均速度和頻率域以振幅為權重的平均速度的關系，並揭示空間域的平均速度的標準差_ x和頻率域的振幅為權重的平均速度的標準差_ v的意義，以及它們之間的關系；第四章介紹了雲跡風系統的高度指定以及風矢高度的劃分，並根據風場連續性原理，介紹了高度調整法的質量控制；第五章介紹導風系統的流程，選擇了三個時刻的ir雲圖，分別用一維傅立葉相位法、二維傅立葉相位法和快速傅立葉演算法計算一個風場個例，並對所得風場進行質量控制，並給出風場圖；第六章進行研究總結，指出不足和有待于進一步研究之處。
  6. At the meantime, the rock mass may alternate between loading and unloading and it exists in certain kind of liquid, such as surface water, unconfined water, confined water etc for its intrinsic crannies. the practical rock mass concerned project must solve the key stability pr oblem after the understanding of the complicated mechanical characteristic and the deformation trends to guide the following project design and construction for the demand of security, economy, feasibility and validity. however, the intrinsic nonlinearness and complexity of the engineering rock mass become the main difficulty to predict the stability and deformation, the corresponding structure design must ensure enough safety with all the determinate or random force combination, so a model without the geometry distortion and constitutive equation warp is necessary to be built for the quantificational analysis of practical structure ' s stress, for the simulation of the real process and for the determinate evaluation system and optimization

    由於實際工程巖體其固有的非線性和復雜性，使得求解對應的諸如其穩定性、變形等問題面臨較大的困難，而有關的工程結構的設計必須保證該結構在外來因素的作用下具有足夠的安全度、經濟性和合理性，這必然要求對巖體及其工程結構的受力與變形有一套量化評判體系和優化技術，抓住實際工程問題的本質特徵並建立可行的符合幾何模擬、本構模擬、受力模擬、過程模擬四原則的求解模型，通過該模型的數值模擬成果來指導巖體工程的設計、施工及運營、管理；而巖體結構面的存在使得基於傳統連續介質力學理論的理論分析和數值模擬面臨巨大的挑戰，物理模擬的試驗周期和成本也大大增加，而巖土體工程問題則成為典型的數據有限、了解程度有限類問題，這類問題的解決需要綜合應用理論分析、經驗判斷、物理模擬和數值模擬等方法，數值模擬可以完成目前許多技術手段無法完成的實驗，如參數控制，復雜條件下的邊界條件的處理，同時數值模擬具有高可重復性，且數值模擬的成本和人力開銷等遠低於物理模擬，因此研究巖土體工程問題的流形元數值模擬方法是一項具有理論和實際工程應用價值的重要課題。
  7. The paper focuses on the cause and current state of interior materials in guangdong province. based on the theories of organizational behavior, organizational media, organizational management and construction of enterprises, the paper attempts to make a detailed analysis of the reasons of their existence, their functions and the issues which they are faced with. it also makes a theoretical analysis of the normalized management o f the continuous interior materials of publication administrative departments in recent years

    本論文採取調查研究、個案訪談、定量分析與定性分析相結合等研究方法，擬從廣東省內部資料的由來談起，分析其現狀，並試圖從組織行為學、組織傳播學、管理學及企業文化建設等方面深入探討連續性內部資料存在的原因，闡明其主要功能，分析其面臨問題，並對廣東省出版行政部門近年來對連續性內部資料的規范化管理做一個理論闡述，相信對實際工作也有較強的指導作用。
  8. Base on the basic principle of continuum mechanics, 2 - d contact type model are derived using circular plate element. mohr - coulomb type failure criteria and failure coefficients related with stress ratio are used in this model to simulate the failure process. the wave propagation in an orthotropic plane under impact loadings was numerically simulated, by using this algorithm

    從連續介質力學的基本原理出發，推導基於圓盤單元的正交各向異性二維連結型離散元計算模型，在模型中採用了mohr - coulomb型破壞準則和與應變率有關的材料破壞系數用以模擬材料的動態損傷和破壞過程。
分享友人
分享到 Line

分享到臉書