收縮寬度 的英文怎麼說

中文拼音 [shōusuōkuān]
收縮寬度 英文
contracted weir
  • : Ⅰ動詞1 (把攤開的或分散的事物聚集、合攏) put away; take in 2 (收取) collect 3 (收割) harvest...
  • : 縮構詞成分。
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 收縮 : 1 (由大變小; 由長變短) contract; shrink 2 (緊縮) concentrate one s forces; draw back 3 take u...
  1. The strength of convergent shock was enhanced in cylindrical and spherical geometries than in planar geometry. the bubble became more wide and big and the spike became more narrow and long. it showed in spherical implosion that the spike close to the symmetrical axis grew faster than the ring one away from the symmetrical axis

    第四,利用lared一s程序模擬柱和球幾何內爆過程中rt不穩定性增長,表明幾何效應對內爆過程中不穩定性的增長有重要影響,柱和球幾何中聚心沖擊波的強大於平面情況,氣泡變得更加而大,而尖頂變得更加細而長。
  2. Radar emits wide pulse to ensure the distance, and gets narrow pulse by using corresponding pulse compression method when receiving. this is pulse compression

    脈沖壓是指雷達通過發射脈沖,保證足夠的最大作用距離,而接時,採用相應的脈沖壓法獲得窄脈沖以提高距離解析的過程。
  3. Standard test method for open channel flow measurement of water indirectly by using width contractions

    使用收縮寬度法迂迴測量明渠水流流量的標準試驗方法
  4. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現:二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中,煅燒去除有機模板后微球表面變粗糙,而粒徑沒有明顯變化; ph值較小時,復合微球中聚合物含量較大,而ph值較大時,得到復合微球結構鬆散,因此熱處理后的二氧化硅微球孔容及平均孔徑都較大,而在ph = 0 . 8時,得到最小值;武漢理工大學碩士學位論文隨著熱處理溫的變化,小於160時,空分佈較窄,而比表面積較小,在350時,由於有機模板的去除,微球孔結構發生突變,比表面積明顯增大,而孔徑分佈變,溫繼續升高時,二氧化硅網路發生,平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態,分佈沒有太大變化。
  5. For the first current plateau , two kinds of sequential resonant tunneling of - process and - x process are observed in the wide barrier gaas / alas superlattice under various pressures for p < 2kbar , the high field domain is formed by - process , while for p > 2kbar , the high field domain is formed by - x process when the barrier width was decreased to 2nm, we found that ground - state -

    對于壘( > 3 . 5nm )的gaaa / alas超晶格,當流體靜壓力超過臨界壓力2kbar后,平臺隨壓力的升高而。對于窄壘( 2nm ) gaaa / alas超晶格, u - i曲線上的平臺將不隨壓力變窄。
  6. Magnesium silicate temperature preservation dope is kind of ropypaste, it features with well spread, small shringking after dry, the temperacially used in the temperature reservation project fo abnormity equipment andunderground pipes

    硅酸鹽(鎂)保溫材料為稠膏體,塗敷性好,乾燥小,使用溫范圍,防水效果好,適用性強,特別適合二異形設備和地下管道的保溫。
  7. First, according to the demand of vimp for resin system, the reaction kinetics and rheological of up resin are investigated and the optimal content of low additive profile ( lpa ) is determined. then vimp based on a high - permeable medium and grooves are studied by visual experiments, through which the appropriate high - permeable mediums are selected and the parameters of width, depth and spacing for flow grooves and spacing for supply grooves are optimized. furthermore, various factors affecting the mold filling process are discussed and the whole vacuum infusion procedures are described taking examples of the manufacture of a model boat and a sandwich panel in one infusion

    文中首先根據vimp對樹脂體系的要求,對vimp用不飽和聚酯樹脂體系的動力學和流變學性能進行了研究,確定了最佳低添加劑的含量;對高滲透介質型和溝槽型vimp開展了實驗研究,通過可視化實驗優選出較好的高滲透介質,確定了引流槽的、深和槽間距及主槽的槽間距等工藝參數並進行了優化;對影響充模過程的各種因素進行了詳細的討論,並以模型船和夾芯面板的製作為實例描述了兩種vimp的成型過程;在實驗的基礎上,建立了二維滲漏模型,採用控制體有限元法對高滲透介質型vimp進行了成型過程的計算機模擬計算,通過充模時間和流動前峰的計算值與實驗結果的比較,驗證本文所採用的數學模型和數值方法的正確性,其結果對實際生產具有一定的理論指導意義。
  8. 4. to decrease the usage of network resources by network management systems even more, combined with the fact that the performance of network management is affected by the scheme to collect management information, a new algorithm - gpa ( group - prefetching algorithm ) has been put forward used for retrieving management information from the element level in heterogeneous wan ( wide area network ). gpa can adjust many little retrieving objects into one prefetching group to access by using the schemes of group prefetching, objects of group changed self - adaptively, fault tolerance etc., and thus can decrease the frequency of retrieval, use fewer network resources and decrease the network overhead without alteration of iiop, snmp or cmip too

    4 .為進一步減少網路管理系統對網路帶的佔用,結合被管對象信息的集策略直接影響網管系統性能的特點,針對異構大型網路環境下多管理對象的信息集問題,提出了一種提取多管理對象信息的新演算法?組預取演算法gpa ( group一prefetehingalgorithim ) ,該演算法同樣能在不改變管理協議,如iiop 、 snmp或cmip的情況下,採用組預取策略、組對象自適應擴充策略、組對象自適應策略、容錯策略等,將多個分散的、處于相同或不同被管設備上的、在未來一段時間內的管理對象的訪問組合在一個預取組中進行訪問,減少對管理對象的訪問頻,從而可以較少佔用網路資源,減小整個網路開銷。
  9. According to the rheological properties of melted abs filament during extrusion from fdm ' s nozzle, on the basis of research on extruded filament section shape, the compensation model of ideal contour line is established, and a new technique for compensating inner or outer contour line of workpiece is put forward, which should depend on the real width of extruded filament ( instead of nozzle radius ) and the real dimensional shrinkage of workpiece

    根據abs絲從噴頭擠出過程中的流變性能,在研究fdm工藝噴頭擠出絲截面形狀的基礎上,建立了理想輪廓線的補償模型,並提出了根據擠出絲實際(而非噴嘴孔直徑)和零件尺寸實際量補償零件內、外輪廓的新方法,驗證試驗結果表明該補償模型和補償方法正確可行。
分享友人