放電振蕩 的英文怎麼說
中文拼音 [fàngdiànzhèndàng]
放電振蕩
英文
oscillation due to discharge- 放 : releaseset freelet go
- 電 : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
- 振 : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
- 蕩 : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
- 放電 : [物理學] (electric) discharge; electro-discharge; discharging
-
Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit
延遲線振蕩器由寬帶放大器、可調衰減器和聲表面波質量傳感器件構成。延遲線振蕩器輸出信號經濾波后與109mhz的本機晶體振蕩器輸出信號相混頻,通過低通濾波取其差頻,並經整形後由數字信號處理電路處理。When both oscillatory stretch and the pace maker discharge occur at approximately the same rate, they synchronize.
當振蕩式牽張和起搏點放電的頻率大體一致時,它們就同步化。2. hi some of the neurons with spontaneous activities, veratridine can transform isi series to oscillation type
在有自發放電的神經元,栗蘆堿可使部分神經元的isi序列轉變為振蕩形式。Compound pattern ( 6. 4 % ), its scatter map of isi series displayed two or more oscillation patterns. 4. after the bath in 1. 8 - 3 u mol / l veratridine, touch or pressure on the l5 receptive fields could trigger some primary silent drg neurons to produce high - frequency firing, termed triggered oscillation, whose interspike intervals ( isi ) showed u - type or other types of oscillations
在部分靜息神經元lsdrg浸浴壹蘆堿后,觸壓該神經元的皮膚感受野,可以觸發產生持續數秒至數十秒的高頻放電,在散點圖上,其isi序列形成u字形或彌散形等型式的振蕩,稱之為觸發振蕩。This isi series oscillation has following characters : ( 1 ) long term cycle duration, whose duration of most oscillations ranged from 3 0 - 120ms, so we called it slow wave oscillation ; ( 2 ) large amplitude of oscillation, the minimum isi is about 2ms while the maximum is beyond 40ms, which suggested that the firing frequency vary from several tens to hundred hz ; ( 3 ) abrupt turn always occurs during the continuous change in isi, this turn is called inflexion temporarily
該振蕩波有下述特徵: ( 1 )振蕩周期較長,多數在30 ? 120s范圍,故稱慢波振蕩; ( 2 )振蕩幅度較大,其isi振蕩最小值在zms左右,最大值可達40ms ,表明放電頻率可在幾十到幾百k范圍內變動; ( 3 )在isi連續變化過程中往往出現突然轉折,暫稱其為拐點。The numerical method based on the coupling of the finite difference method in time domain with the discrete fast fourier transform is applied to calculate the first four eigenfrequencies and eigenfunctions of the six - cavity with open boundary. the absorbing boundary condition for tem wave is tested numerically, and it is applied to writing the code. the cold testing of the cavity is done and the results are good agreement with the numerical results
計算x波段六腔開放腔前四個模式的場分佈;根據第二章公式分別計算x波段六腔開放腔前四個模式的電子負載電導並總結了這四種工作模式渡越效應的規律,基於這種小信號理論分析了x波段渡越輻射振蕩器,得到了工作模式及可能產生的模式競爭。Used in hi - fi per - amplifiers and tv oscillation loop circuits
適用於高保真前置放大及電視振蕩迴路。The current source plays an important part in the performance of the oscillator. with the help of the voltage reference, we design a constant current source which does not vary with the temperature 、 the voltage source and the process
由於充放電電流對弛張振蕩器的性能有很大的影響,因此本文把基準電壓源結合在一起設計出一個受溫度、電源電壓、工藝條件影響很小的基準電流參考源。In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little
此電路利用系統內部基準源產生的電流信號來對電容進行充放電,然後經過控制電路作用后,產生的輸出振蕩波形的上升時間和下降時間非常小,更接近理想矩形波形;通過調節基準源電流信號或者電容值大小,可調節振蕩波形的頻率和占空比,同時溫度和電壓的變化對振蕩器輸出波形頻率穩定度的影響很小。Applying the criterion of the work state of operational amplifier, the stable operating condition of voltage - controlled voltage source filter 2 is proved in detail and the condition that the filter can be used as the sinusoidal oscillator is given
摘要利用運放工作狀態的判據,系統地證明? 4種二階壓控電壓源型濾濾器穩定工作的條件,同時給出了用作正弦波振蕩器的條件。In the meantime, the all sub - circuits are also designed and emulated carefully including inverter, rs type flip - flop, voltage reference circuit, error amplifier, voltage comparator, sawtooth - wave generator, pwm comparator, soft activation circuit and so on. as a result, all of the sub - circuits answer the requirements. this chip has taped out with the 0. 5um mix - signal process of csmc
本文利用cadenceeda集成電路設計工具、 spectres模擬工具,對集成電路內的各個模塊包括反相器、基本rs觸發器、基準電壓電路、誤差放大電路、電壓比較電路、鋸齒波振蕩發生電路、 pwm比較電路、軟啟動電路、驅動電路等進行了具體的設計和模擬,且達到了預先設定的指標。Input to the inverting oscillator amplifier and input to the internal clock operating circuit
反向振蕩放大器和內部時鐘工作電路的輸入。And then, based on the above theories, the circuit design and simulation means have been concretely applied in the internal modules of voltage reference, bias circuit, oscillator, error amplifier and drive circuit of the chip and so on. the relevant design indexes are successfully achieved. at last, the whole circuit simulation and layout design are completed
在此理論基礎上對該電源晶元內部的各個模塊,如電壓基準源、偏置電路、振蕩器、誤差放大電路和驅動電路等模塊進行了具體的電路設計和分析模擬,且達到了相應地設計指標,最後,完成了整體電路模擬和版圖設計。Consequently, an integrate switch mode power supply with high efficiency and good reliability can be realized by the controller with very few external parts. the fundamental principle of monolithic voltage - mode switching regulator is firstly introduced in this thesis, which is followed by a comparison between voltage - mode and current - mode converters where the pros and cons of both converters are discussed in detail ; next, the global system architecture is proposed upon the design requirements and sub - block circuits are also introduced that focuses on several essential sub - blocks such as amp, wave, pwm control, psc, osc and vref. finally, all sub - circuits and the whole chip circuit are simulated by hspice whose results indicate that the circuit function and performance have perfectly satisfied the design requirements
在論文中,首先闡述了電壓控制模式pwm開關電源的基本原理,對比了電流控制模式和電壓控制模式,分析了各自的優缺點;隨后根據設計要求進行了電路的總體設計,完成了各個子電路的原理分析,電路設計和模擬驗證,重點闡述了誤差放大電路、三角波發生電路、 pwm控制電路、節能控制電路、振蕩電路和基準源電路的分析、設計和驗證過程;最後,利用eda軟體hspice對整體電路進行了功能模擬驗證,模擬結果表明,本文完成了設計工作,達到設計要求。Subcircuit models are designed and simulated, which includes bias current source, voltage reference, error amplifier, pwm comparator, driver circuit, protection circuits for over - temperature, over - current. at last, combined with periphery component, the circuit is simulated, and the result meets the anticipant requirement
並對集成電路內的各個模塊包括電流偏置電路、基準電壓電路、誤差放大電路、三角波振蕩發生電路、 pwm比較電路、驅動電路、過熱保護電路和過流保護等進行了具體的設計和模擬,並對整體應用電路進行了模擬,結果均達到了預先設定的指標。In the thesis, some of the most important functional modules of the pwm power control ics are designed and simulated, including error amplifier, voltage reference, voltage regulator, comparator, and oscillator. the topologies, schematics and layouts of some circuits are introduced and developed
本畢業設計研究和提出了構成pwm電源控制晶元的主要功能模塊,設計了其中主要模塊ip核的多種結構電路並進行了模擬,完成了部分電路的版圖設計? ?包括誤差放大器,基準電壓源,電壓調節器,比較器,振蕩器等。At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db
本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素( ql值)超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器,頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器,精心設計電路,優化設計布置印製電路板,用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件,製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。The sounds and images are converted into electrical signals by a microphone ( sounds ) or video camera ( images ), amplified, and used to modulate a carrier wave that has been generated by an oscillator circuit in a transmitter
聲音合圖像由話筒(聲音)或攝像機(圖像)轉換為電子信號,經過放大后,用來調制發射器中一個振蕩器產生的負載電波。The frequency of the pulse is the same as that of the crystal oscillator. the pulses sampled the output of the vco and generate the error signal. the error signal is amplified,
誤差電壓經放大後送入環路濾波器進行濾波和再放大,然後去改變變容管偏置電壓,控制振蕩器輸出頻率,達到穩頻的目的。Secondly, we present the set of nonlinear partial differential equations that describes the wave - particle interaction, by analyzing the output power spectrum, the limit cycle and chaotic oscillation of the radiation field in the traveling wave tube ( twt ) amplifier and the magnetically insulated transmission line oscillator ( milo ) are studied numerically, respectively
接著,在論文的第三章和第四章我們從導出了一組用於描述場和電子相互作用的非線性偏微分耦合方程組開始,利用頻譜分析法,以行波管( twt )放大器和磁絕緣傳輸線振蕩器( milo )為例,數值研究了o型器件和m型器件中場的極限環振蕩和混沌行為。分享友人