放電真空計 的英文怎麼說

中文拼音 [fàngdiànzhēnkōngjì]
放電真空計 英文
discharge gauge
  • 放 : releaseset freelet go
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 真 : Ⅰ形容詞（真實） true; genuine; real Ⅱ副詞1 （的確; 實在） really; truly; indeed 2 （清楚確實） cl...
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 放電 : [物理學] （electric） discharge; electro-discharge; discharging
  • 真空 : [物理學] vacuum; empty space; vacuo
  1. Only when it takes humidity ratio h / ? as independent variable instead of absolute humidity h in researching and calculating the influence degree of the humidity on the discharge voltage, the emendation coefficients of relative air density and humidity can be independence, and can reflect the influence degree of atmospheric parameters on outer insulation discharge voltage actually

    當以比濕h代替絕對濕度h為自變量研究和計算濕度對放電電壓的影響程度時，相對空氣密度校正系數和濕度校正系數才能相互獨立，才能真實地反映大氣參數對電氣設備外絕緣放電電壓的影響程度。
  2. This project is focused on microbolometer fpa. this program includes the development design and simulation tools, material research, fabrication process development, and detector and readout circuitry design, fabrication and characterization. the work done in this paper is described as follows : the theory of microbolometer fpa is expounded

    課題的重點放在非致冷微測輻射熱計焦平面陣列，這種非致冷紅外產品的設計研製工作包括：設計和模擬工具的研究、材料選擇和器件製作工藝的研究、探測器和讀出電路的設計研究、真空封裝和性能表徵的研究等。
  3. First, the vacuum sensor suitable for vacuum degree on - line measurement in the vacuum interrupter is devised by the researches on panning discharge. then the vacuum sensor is calibrated, and also the corresponding curve which indicates that the vacuum degree respond to the current of the electric discharge is got

    首先，通過對潘寧放電原理的研究，設計了適用於真空滅弧室在線檢測真空度的真空傳感器，並對真空傳感器進行了校正，得到其真空度-離子流對應曲線。
  4. In this paper, firstly, monolithic materials cosb3 and bi2te3 were prepared by sparkle plasma sintering ( sps ) respectively, and at the same time the microstructure of cosb3 and bi2te3 were studied by sem ; the seebeck coefficients and electrical conductivities of monolithic materials were measured by standard - four - probe method ( ulvac zem - 700 ) in a he atmosphere simultaneously, and their thermal conductivities were investigated by laser flash method ( tc - 7000 ) in vacuum. secondly, the junction temperature of graded bi2te3 / cosb3 thermoelectric materials was optimized based on the thermoelectric transport properties of monolithic materials, also when graded materials were used in the temperature difference ranging from 300k to 800k, the length ratio of monolithic materials cosb3 and bi2te3 were optimized in theory. thirdly, graded bi2te3 / cosb3 thermoelectric materials were prepared by two - step sps sintering, and the relationship between its average seebeck coefficients and temperature were calculated by theory mo del

    均質材料cosb _ 3和bi _ 2te _ 3的電導率和seebeck系數採用標準四端子法于he氣氛下在zem - 1上同時進行測量；熱導率採用激光微擾法（ tc - 7000 ）于真空狀態下進行測量；其次，在對均質材料cosb _ 3和bi _ 2te _ 3熱電傳輸特性研究的基礎上，對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的界面溫度進行了優化；為了使結構梯度bi _ 2te _ 3 cosb _ 3熱電材料在300k至800k的溫度范圍內具有最佳的熱電性能，本研究同時對梯度結構熱電材料當中均質材料cosb _ 3和bi _ 2te _ 3材料的長度進行了優化設計；第三，通過兩步放電等離子燒結的方法制備出了結構梯度bi _ 2te _ 3 cosb _ 3熱電材料；採用理論計算的方法研究了梯度結構熱電材料平均seebeck系數和溫度的關系；同時為了驗證設計的結果，本論文對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的開路輸出電壓和熱端溫度之間的關系及梯度材料在300k至800k的溫度范圍內使用時的功率輸出進行了相應的研究。
  5. A ppt test set has been made, and a measurement system of ppt ' s electric properties ( voltage and discharge current ), isp and thrust has been established. measurement of electric properties of the ppt and its isp, thrust has been carried out

    通過大量的研究工作，製造了脈沖等離子體推力器樣機，設計並建立了地面真空環境下對于樣機的放電參數（電壓、電流變化）以及推力、比沖的測量環境，並對所研製的樣機進行了電參數和比沖及推力的測量。
分享友人
分享到 Line

分享到臉書