故障頻率特徵 的英文怎麼說

中文拼音 [gùzhàngbīnlǜtèzhǐ]
故障頻率特徵 英文
frequency characteristics of fault
  • 故 : Ⅰ名詞1 （事故） event; incident; happening; accident 2 （原因） cause; reason 3 （朋友; 友情） fr...
  • 障 : Ⅰ動詞（阻隔; 遮擋） block; hinder; obstruct Ⅱ名詞（遮擋物） barrier; block; obstacle
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 徵 : 名詞[音樂] （古代五音之一 相當于簡譜的「5」） a note of the ancient chinese five tone scale corre...
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  • 頻率 : frequency; rate
  • 特徵 : characteristic; feature; properties; aspect; trait
  1. Through analysising the characteristics of the power system with floating neutral point deeply, the paper puts forward a new plan of single - phase to ground fault line selection on the base of s ' s signal injecton method and gives the hardware and software design. in this design, the high speed sampling and data processing is carried out through using dsp processor ; the large electrice current is drived through the application of a high - performance audio power amplifier and transformer ; the communication between host computer and detectors is realized through rs485 bus technology ; the difference multilevel frequency - selected amplifier is designed and the feeble signal of space is sampled on the base of the theory of magnetic induction ; the interface between dsp and exterior chip and rs485 interface logical is designed through using fpga ; the using of lcd module and keyboard interfacing chip makes the interface between human and machine ; the programme of host computer and detectors is designed through using blocking design method

    在本設計中，採用高速的dsp處理器，實現了對故障特徵信息的高速採集與處理;採用大功率的功放晶元與變壓器配合的方法，實現了大電流信號的驅動輸出;採用485總線技術，組建了裝置主機與多探測器之間的主從式通訊網路，實現了多干擾條件下裝置主機與多探測器的可靠通訊;設計了差分式多級選頻放大電路，採用磁感應的方法實現了對空間微弱信號的接收;利用fpga技術，實現了控制器與多外設的介面及數字信號的串並轉換;採用了先進的lcd液晶顯示模塊及鍵盤介面晶元，設計了人機信息交互的介面;採用了模塊化的軟體設計方法，開發了裝置主機及探測器的軟體程序。
  2. What is mainly discussed in this dissertation is as follows : the fault mechanism and vibration frequency feature of hydroelectric vibration are analyzed, induced and reorganized. the select and placement of detecting positions of parameters such as vibration, swing and pressure pulsation are researched, and the corresponding sensors are selected to monitor

    本文主要進行了以下工作：分析、歸納和整理了水電機組振動的故障機理和振動頻率特徵，對機組的振動、擺度和壓力脈動測點進行了選擇和布置，並選用相應傳感器進行監測。
  3. The algorithm is also applied in the broken rotor bars detection in squirrel cage induction machines, which is dependent on detecting the twice slip frequency modulation due to the speed or torque in the stator current, and the rotor bar faults can be detected effectively without some preprocessing

    指出可以利用信號的小波脊線來提取頻率隨時間連續變換的信號的瞬時頻率，並將該瞬時頻率提取演算法成功地應用到異步電動機定子起動電流信號的分析中，有效地提取出了轉子斷條故障特徵。
  4. Third, whether the structure has fault can be determined through well - trained bp artificial neural network by taking structure frequency as the feature parameter

    （ 3 ）用結構的頻率作為特徵參數，用訓練好的bp人工神經網路進行診斷，能夠診斷結構是否有故障。
  5. The rcd has three failure modes the reject - operation, the wrong - operation and the malfunction of handle. the reliability check should consider this characteristic and these failure modes. the success ratio r and the failure ratio a are applied as reliability criterion of rcd

    首先，針對漏電保護器不頻繁動作的保護電器的工作特點以及發生拒動、誤動故障及操作故障三類故障的失效模式，採用保護成功率r和失效率作為可靠性特徵量，並給出了可靠性特徵量的估計方法。
  6. Firstly, the voltage sample signals from ac exciter stator coil were de - noised and filtered by means of decomposition of the wavelet function. secondly, the character frequency region of the rotating rectifier fault was selected clearly with wavelet package decomposition and reconstruction

    先對交流勵磁機定子磁極線圈電壓采樣信號進行消噪濾波，再通過小波包分解和重構進行特徵頻率提取，建立了表徵旋轉整流器故障的特徵向量。
  7. It can also determine the fault spot and reason. this technology has been used in some technological fields and proved efficient. it has promoted the revolution of maintance system and the historial protection is replaced by preventive maintenance. with this technology, we can improve the reliability of machine and decrease the maintance fee. recently, reserch has pick up a fervent pace in the area of fault diagnosis of electrical machines. the paper simply analyzes the fault reason of electrical machines, stressly describes and explores the methods of condition monitoring and fault diagnosis such as partial discharge, stator current, rotating speed, vibration etc. fault prognosis is now include diagnostic feature, reason, spot. prodigious improvement in signal processing hardware and software has made this possible. primarily, these techniques depend on locating specific harmonic components of the fault. these harmonic components are usually diffirent for diffirent types of faults. automated tools such as fuzzy logic based system is also simply presented in the paper

    本文從絕緣結構的故障機理入手，以絕緣結構故障的典型特徵? ?局部放電為研究對象，重點討論局部放電的在線監測方法、適用場合併比較它們的優缺點；在分析籠型異步電機轉子斷條在線監測的定子電流監測方法后，根據其缺陷，本文探討了溫升不平衡法、希爾伯特變換數字濾波、小波包分析法的原理及優點；以電機軸承、氣隙偏心等故障為研究對象，通過對電機振動和轉速頻率的檢測，診斷電機的故障類型；本文的重點工作是將人工智慧技術中的模糊技術應用於電機的狀態監測和故障診斷中，力求使電機故障診斷更接近人工智慧化；最後，本文對電機狀態監測和故障診斷系統進行了硬體和軟體初步設計，為實現預測維修提供了有效的技術手段。
  8. Fourth, the experiment of cantilevering beam and the digital calculation reveal that frequency is easy to get and can reflect the state of the cantilevering beam. under certain conditions, the feature parameter can be used to determine whether the cantilevering beam has fault, where the fault locates and the extent of impairment

    （ 4 ）懸臂梁試驗及數值計算表明，頻率易於提取，且反映了懸臂梁的狀態，以其為特徵參數，結合bp人工神經網路，在特定條件下，可以診斷懸臂梁是否有故障，故障的位置和損傷程度。
  9. The principle of the fault distance measurement for small current grounding system by injecting dual frequency signal are discussed from many aspects such as the method and the characteristic of the signal, the test of the signal, the method of the line select, the algorithm of the fault distance measurement, and the method of the fault location, etc. the task adopts this kind of principle, in which the signal injection is completed by the coupling between the power source and the pt

    在詳細地說明以上三種測距演算法的基本原理后，分析各種演算法的優缺點，從注入信號的方法、特徵，注入信號的檢測，接地選線的方法，故障測距的演算法，及故障定位的方法等多個方面，論述了本課題採用的應用於小電流接地系統的雙頻信號注入式測距原理。其中，信號的注入由功率源通過電壓互感器（ pt ）耦合來完成。
  10. A time - frequency analysis method is presented to solve paper machine press section bearing vibration signals of unstable and complication, applying wavelet function to the unstable signals for faulty bearing according to paper machine press section roll bearing characteristic, and process the vibration signals by means of decomposition and reconstruction, obtaining the vibration signals in different frequency bands, the statistic in frequency domain of relevant frequency bands is served as monitoring feature

    摘要針對紙機壓榨部滾動軸承尺寸大響應弱、運轉速度低、低頻信號容易淹沒、調制源多、振動信號非平穩性等特點而導致常規的傅立葉分析診斷故障效果不佳的情況，提出了一種應用小波變換的時頻分析方法，對振動信號進行分解和重構處理，獲得了振動信號在不同的頻段的分量，提取相應特徵頻段重構分量的功率譜的頻域統計值作為特徵參數，從而實現對軸承故障診斷。
  11. In large rotating machinery using filmatic bearing ( turbogenerator, air compressor, etc. ) there is a potential trouble from impefect installation or running conditions, a metals " contact between rotors and shells. the trouble is usully called rubbing. the advantage of ae technologe in the rubbing diagnosis and early detection is showed. instead of classical ae characteristic parameters ( counts, amplitude, energy, duration and the other ones ) a new feature extraction by frequency analysis of ae envelop signals is discussed. both research of ae process and field experements indicate that periodic components in the envelop spectrum related to rotational speed increase evidently at the beginning of rubbing production, hence are highly sensitive to the rubbing fault diagnosis. according to the new design an acoustic emission equipment for the rubbing diagnosis named buaa ae testing system is developed and described

    汽輪發電機、空氣壓縮機等採用油膜支撐的大型轉動機械，由於安裝或運行中的原因，在轉子旋轉過程中，可能和器壁發生輕微的摩擦和碰擊，簡稱碰摩.聲發射技術在碰摩發生特別是故障早期診斷上有優越性.本系統的特點是沒有沿用傳統的計數、幅度、能量和持續時間等聲發射特性參數，而是在聲發射包絡信號的頻率分析中進行特徵提取.聲發射發生的過程分析和現場試驗都表明這種方法對碰摩檢測很敏感，在碰摩發生的起始階段，包絡譜中與轉速同步的周期性分量顯著增加.根據這種新的設計思想自行研製了buaa碰摩聲發射檢測儀並對此作了介紹
  12. The integrated method of time and frequency domain analysis and rbfnn is given for bearing fault diagnosis. through selecting representative parameters, feature space vector is constructed so the input dimension is reduced and fault classification information retained

    通過時頻域分析提取了有代表性的特徵參數，構建了特徵空間向量，既降低了網路的輸入維數，提高了網路的學習效率，又保留了故障分類信息。
  13. On the aspect of extracting fault feature frequency, a method for monitoring abrasion fault of main bearing using noise and orthogonal wavelet transform is presented

    在故障特徵頻率提取方面，提出了採用基於噪聲和正交小波分析檢測主軸承磨損故障的一種新方法。
  14. After collecting the characteristics of this signal in frequency domain, the samples are learned to train the constructed wavelet neural network ( wnn ) for realizing the mapping relationship between the fault and the spectrum characteristic, this method can be used for diagnosis of the unit faults efficiently

    在對水電機組振動信號進行頻譜分析后，提取該信號在頻率域的特徵量，將頻譜特徵向量作為學習樣本，通過訓練，使構造的小波神經網路能夠反映頻譜特徵向量和故障類型之間的映射關系，從而達到故障診斷的目的。
分享友人
分享到 Line

分享到臉書