散熱器換能器 的英文怎麼說

中文拼音 [sǎnrèqìhuànnéngqì]
散熱器換能器 英文
sink
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 能 : 能名詞（姓氏） a surname
  • 散熱器 : radiator; radiation; cooler; heat sink
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  1. We can see than this kind of cpu thermal syphon cooling machine is the one with simple texture, easy working, low costs, reliable work and good performance

    由此可知此種cpu重力熱管散熱器是一種結構簡單、加工製造方便、成本低廉、工作可靠且傳熱性能優良的換熱設備。
  2. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  3. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  4. This idealized characteristics can be used for analyzing the converter topology but should not be used for the actual design, when, for example, heat sink requirements for the device are being estimated

    這個理想化的特性可以用來分析換流器的拓撲性質但是不能應用於實際設計，例如估計設備所需的散熱器。
  5. The main products includes various steam and electric heating reaction vessel, conduction oil, outer coil reaction vessel, polyester and resin completed equipments, vacuum reducing concentration tank, methanol and ethanol recovery tower, various corrugated stuffing, high effective membrane evaporator, new - type centrifugal drag membrane evaporator, vacuum rake dryer, condensing drum cut - off machine, shell - and - tube condenser,

    本廠主要產品有各類蒸氣電加熱反應鍋，導熱油外盤管反應鍋，聚脂樹脂全套設備，真空減壓濃縮罐，甲醇乙醇回收塔，各類波紋填料，高效薄膜蒸發器，新型離心刮板式薄膜蒸發器，真空耙式乾燥機，冷凝滾筒切片機，列管式冷凝器，螺旋板式換熱器，外循環蒸發器，鋁制槽車貯罐，乳化設備，高速剪切分散機，種子罐，發酵罐，多功能提取罐，並承接各類非標設備。
  6. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  7. Abstract : a mathematical model describing the effect of flow nonuniformityon the performance of compact heat exchanger is provided, which is based on that one side of heat exchanger is uniformly distributed but the other is of maldistribution. the model may be expressed in two different types, i. e., continuous model and discrete model. the former provides a method analyzing the performance deterioration of exchanger due to flow maldistribution, and the latter provides a reference to the improvement of experimental measurement. the analyzing method obtained can be used to compute the performance deterioration of compact heat exchanger due to flow maldistribution. the result is significant to the optimization of compact heat exchanger design

    文摘:以一側流體分配不均勻的換熱器模型為基礎，建立了物流分配不均勻性對換熱器效能影響的數學模型，通過理論分析和計算，為研究換熱器內部物流分配不均勻對其效能的影響提供了一種分析方法.該理論模型包括連續模型和離散模型2種形式，前者為研究物流分配不均勻引起換熱器效能的下降提供了一種分析計算方法，後者為控制實驗研究的精度提供了理論依據.研究結論對換熱器的優化設計具有重要意義
  8. Based on an actual project, tests and analyses the heat exchanging performances of the vertical u - shaped ground heat exchanger, and obtains the heat release in summer and the heat absorption in winter of ground heat exchanger for unit well depth and the optimal drilling depth

    摘要根據工程實際情況，對豎直u形地埋管換熱器的換熱性能進行了現場測試和分析，得出了單位井深地埋管的夏季散熱量、冬季取熱量及最佳地埋管鉆孔深度。
  9. Effect of heat transfer performance of heat pipe on heat rejection efficiency of the miniature heat pipe heat exchanger

    熱管傳熱性能對小型熱管換熱器散熱效能影響
分享友人
分享到 Line

分享到臉書