散熱器閥 的英文怎麼說

中文拼音 [sǎn]
散熱器閥 英文
radiator valve
  • : 散動詞1. (由聚集而分離) break up; disperse 2. (散布) distribute; disseminate; give out 3. (排除) dispel; let out
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • 散熱器 : radiator; radiation; cooler; heat sink
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  1. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝壓力表翅片壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針節流及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  2. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件:各種車用空調冷凝、蒸發、空調、調溫、加、中冷、空氣乾燥、冷卻風扇控制、內部交換、壓縮機、電動機、暖風機、暖風裝置、各種冷凝電子扇、貯液灌、力膨脹;各種車用空調管路、開關、離合、接頭、高低、換向及各種車用空調生產材料(車用鋁材、銅材等) 、生產設備、檢測設備等。
  3. On the above basis, the controlling methods suitable to all types of indoor heating systems for outdoor heating hydraulic system are discussed, and a guide principle of the designing for indoor heating system and outdoor heating hydraulic system is provided

    著重研究了室內採暖系統在安裝恆溫后,其運行工況下性能參數的變化,在此基礎上,研究了與各種室內採暖系統相適應的室外供管網水系統變水量運行策略,闡述了與我國住宅建築採暖計量收費所適應的室內採暖系統和室外供管網水系統的設計原則。
  4. Suzhou xinghe refrigeration parts limited company is a company which specializes in producing the parts such as electrical sink air - conditioners, refrigerators, instruments, capillaries used in instruments, one - way valve at a relative early time

    蘇州市星和製冷配件有限公司是華東地區一家較早專業生產電子用片空調、冰箱、儀、儀表用毛細管、單向等配件的企業。
  5. Analyses the application effect of thermostatic radiator valves via testing two same buildings dynamically in the same period

    摘要通過對兩棟相同建築物進行同期動態檢測,分析了恆溫控制的實際應用效果。
  6. The results indicate that thermostatic radiator valves can regulate and control indoor temperature effectively and save heating energy consumption, and that using thermostatic radiator valves can produce good economic benefit because the initial investment is lower and the payout period is shorter

    分析結果表明恆溫控制可以有效調控室內溫度和節約供暖能耗;恆溫控制初投資低和投資回收期短,在實際應用中可以產生良好的經濟效益。
  7. It can be used for water return of radiator, balance water flew and cut off system. available for : 3 / 4 ", 1 / 2 " / style : straight valve, angle valve

    回水節流,應用於回水口,可平衡系統流量,並可關斷系統。規格及型號: 3 / 4 」 、 1 / 2 」型式:直型、角型。
  8. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺,管的加方式為電加,工質為蒸餾水.在1 1模型上對分離式管管內凝結換特性、不凝性氣體對凝結換的影響及不凝性氣體的擴規律進行了試驗,得出分離式管有一最佳充液率,其值為45 %左右;凝結換系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式管的凝結換僅影響冷凝段下部較小部分,通過排氣排出不凝性氣體可有效地改善冷凝段下部的凝結換;隨著壓力的增加,不凝性氣體對分離式管冷凝段的影響減少.這些結論可用於分離式管換的工程設計和控制
  9. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺,管的加方式為電加,工質為蒸餾水.在1 1模型上對分離式管管內凝結換特性、不凝性氣體對凝結換的影響及不凝性氣體的擴規律進行了試驗,得出分離式管有一最佳充液率,其值為45 %左右;凝結換系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式管的凝結換僅影響冷凝段下部較小部分,通過排氣排出不凝性氣體可有效地改善冷凝段下部的凝結換;隨著壓力的增加,不凝性氣體對分離式管冷凝段的影響減少.這些結論可用於分離式管換的工程設計和控制
  10. This type of capacitor has an assembling full - sealed structure, and it is comprised of capacitor unit body, contain - er, insulation cooling impregnant, outlet ceramic bushing, pressure - releasing valve and temperature controller etc. the internal insulation cooling impregnant is isolated from external atmosphere so as to avoid aging of impregnant and ingress of moisture

    全密封集合式並聯電容主要由電容單元組成的身波紋油箱絕緣冷卻油出線套管支持絕緣子壓力釋放及溫度控制等部件構成。採用波紋油箱增大面積降低產品溫升。
  11. Guide to selection and use of thermostatic radiator valves

    恆溫散熱器閥的選擇和使用指南
  12. Thermostatic radiator valves - requirements and test methods

    恆溫散熱器閥.要求和試驗方法
  13. Thermostatic radiator valves - requirements and test methods ; german version en 215 : 2004 a1 : 2006

    恆溫散熱器閥.要求和試驗方法
  14. Manual operating hot water flow through the radiator to control the room temperature, its most economical of thermostatic radiator valve. available for : 3 / 4 ", 1 / 2 " / style : straight valve, angle valve

    手動調節,通過手動調節水流量,以達到控制室內環境溫度的目的,是最經濟的溫控。規格及型號: 3 / 4 」 、 1 / 2 」型式:直型、角型。
  15. Shanghai best & honest import & export corporation is a leading manufacturer and exporter of valves, fittings, sanitary wares, towel warmers and bathroom accessories in china

    上海博煌進出口有限公司是一家主要出口門、管件、潔具,和浴室配件的貿易公司。
分享友人