數字復接體系 的英文怎麼說

中文拼音 [shǔzìfùjiētǐxì]
數字復接體系 英文
digital multiplex hierarchy
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 字 : Ⅰ名詞1 （文字） character; word 2 （字音） pronunciation 3 （字體） form of a written or printed ...
  • 復 : Ⅰ形容詞1 （重復） repeated; double; duplicate 2 （繁復） complex; compound Ⅱ動詞1 （轉過去或轉過...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 體 : 體構詞成分。
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數字 : 1. （表示數目的文字; 表示數目的符號） figure; digit; numeral; character; numeric character 2. （數量） quantity; amount
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. High frequency radar is also a high frequency ground wave super resolution radar used on the seaside, and meantime it is one of projects of national 211 for building subject. this paper based on high frequency radar and modern signal processing describes the component of the high frequency radar on function and hardware. the signal that the radar system used mostly decides the capability and the complex of the radar

    雷達系統所用的信號體制、信號形式決定了在很大程度上決定了雷達的性能指標，雷達系統的復雜度，本文主要研究基於軟體高頻雷達的多體制信號的數字化產生與接收，目的在於產生一種或者多種能夠軟體高頻雷達所適用的信號，並且這種信號不會給小型化的系統處理帶來過高復雜性。
  3. In chapter 2, a general digital watermarking frame is presented, including the generation, embedding and detection of watermark. in chapter 3, the concept of watermarking channel is presented, the modes of watermarking channel and image dct coefficients is proposed, the capacity of watermarking channel is evaluated by embedding watermarks to selected still image dct coefficients in direct spread spectrum. in chapter 4, a watermarking algorithms based wavelet multi - resolution is presented, by conjunction with human visual model, it keeps invisibility of watermark in host image and need not original image during detection

    數字水印是一種新的數字媒體保護技術，它是將特定的信息（如版權信息、秘密消息等）嵌入到圖象、語音、視頻等各種數字媒體中，以達到版權保護等目的，同時，這種信息對宿主媒體的影響不足以引起人們的注意且有特定的恢復方法，此信息對非法接收者應該是不可見的，本文主要對數字水印的一般框架，靜止圖象dct系數的理論容量，圖象水印的嵌入和檢測，數字媒體防篡改以及數字水印的攻擊等問題進行了研究，提出了兩個新的水印算演算法。
  4. The relations between the mode frequency, static characteristic and the framework parameters are studied. a two dimension crossed symmetric cantilever flexure hinge is investigated using finite elements method. the simulation of the mode frequency and the study of the relation between the displacements and the stress indicate that this flexure hinge has good flexibility and linearity between the displacement and the maximum stress

    研究了二維復合式懸臂梁柔性鉸鏈模態頻率、靜態特性與鉸鏈結構參數之間的關系；建立了結構參數和力學特性西北工業大學博士論文之間的對應關系;研究了基於復合式懸臂梁柔性鉸鏈的二維十字對稱柔性鉸鏈結構，對其模態頻率以及位移應力特性進行模擬試驗;結果表明此種結構形式的運動對稱性很好;其驅動位移與結構體最大拉壓應力值之間接近線性關系，而且這種結構可以得到100林m以上的運動位移。
  5. Digital multiplex hierarchy

    數字復接體系
  6. The fourth chapter introduces the designing and im - plementing about the hardware of high speed bert, and gives some actual design cir - cuits. the fifth chapter introduces the designing and implementing about the software of high speed bert, and gives the simulation results of some program blocks and top block. the testing parameters are given in the sixth chapter

    本文第二章介紹數字通信及復接技術的有關理論;第三章介紹高速誤碼率測試儀發端子系統的設計方案;第四章介紹高速誤碼率測試儀的硬體設計及實現過程，並給出了一些實際設計電路;第五章介紹高速誤碼率測試儀發送端軟體設計及實現過程，並給出了各程序模塊及頂層模塊的模擬結果;第六章給出了高速誤碼率測試儀發送端的測試參數。
  7. The focus is about the char device driver design used in the dvb receiving card and the drive development process in user space ; analyzing the dvb receiving system working principle and process under linux and providing a method to load the linux dvb receive card device drive into the linux kernel ; analyzing and implementing the firmware design of saa7146 chipset working with linux kernel and working characteristic in vrious working mode ; analyzing and implementing the frontend drive programing of the digital tv receive system ; realized the qam demodulation and the mpeg stream filter, so that the output stream can be used to playing on pc better. and this article designs an event management mechanism based on the mhp, which improve the linux dvb software system

    重點研究了數字電視接收卡的字元設備驅動問題，闡述了用戶空間開發驅動程序的過程;分析了linux下數字電視接收系統的工作原理和驅動程序開發過程，給出了linuxdvbapi接收卡設備驅動程序加載到linux內核中的方法;研究實現了saa7146晶元配合linux內核共同工作的固件設計和不同工作模式下的工作特性;研究實現了dvb接收系統中前端驅動程序的編寫;設計實現了qam解調和mpeg流解復用，使輸出傳輸流較好地用於pc播放;同時，本文所設計的一種符合mhp規范的中間件事件管理機制，優化了linuxdvb軟體系統。
  8. Laser and photoelectric technology, digital image processing technology and exact measurement and control technology were used in the system. wheel set parameters could be measured by non - contacted and automatic way. the accuracy, stability and reliability of the system can meet the demand of wheel sets maintainingt

    該系統是綜合激光與光電技術、數字圖像處理技術、精密測控技術於一體的自動化設備，能非接觸自動測量輪對綜合參數，檢測精度較高、重復性好、維護量小，工作穩定可靠，現場使用達到段修使用要求的技術指標。
  9. It consists of two parts : channel modulator ' s controlling system and the receiver ' s controlling system, including the interface designing of the demultiplexer, the controlling of the channel demultiplexer, if modulator, tuner, the setting and transmitting of the system parameters, and the real - time monitoring of the whole system, etc. based on the descriptions of the scheme of bdb - t and the principles of controlling circuits, this paper presents the hardware and software designing methods of the controlling circuits, and realizes a powerful, multifunctional and reliable controlling system which can automatically record the operational states of the system and communicate with other personal computers through a rs - 232 serial interface

    控制系統是實現整個傳輸系統的關鍵部分，它分為通道調制器控制系統和接收機控制系統兩大部分，其中包括了通道解復用器用戶介面設計、對通道解復用器的控制、系統傳輸參數的設置與傳送、中頻調制器的配置、數字調諧器的配置，以及對整個系統的實時監控。本文在闡述了bdb - t方案及其各部分電路的控制原理的基礎上，詳細描述了控制系統的硬體電路設計和軟體實現方法，實現了一套功能完善、性能穩定且具有自動記憶功能的控制系統，同時該系統通過rs - 232串列介面可以實現與計算機的串口通信。
  10. In this paper, firstly the origin and research significance of the project were introduced, the general design of the rtmaad system wes introduced as follow. then, we discussed and analyzed in detail the rtmaad system " s key technologies such as digital signal processing and wave division multiplexing of optical fiber communication system, etc. lastly, engineering " s realization of the rtmaad system was introduced

    本文首先介紹了課題的來源及研究意義，接著介紹了rtmaad系統的總體設計，然後詳細分析和論述了本研究項目的關鍵技術：數字信號處理技術和光纖波分復用技術等，最後介紹了rtmaad系統的工程實現。
分享友人
分享到 Line

分享到臉書