數組下標 的英文怎麼說

中文拼音 [shǔzǔxiàbiāo]
數組下標 英文
array index
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  1. Avoid subscripting arrays or hashes within loops

    避免在循環中使用下標數組或散列。
  2. ( 5 ) according as different dispatching results under different parameters combination of aertashi reservoir, taking into account hydraulic, energy, investment index etc, the characteristic water level of aertashi reservoir are selected by applying fuzzy optimal selection theory and grey relation analysis theory, and the optimal parameter combination is recommended

    （ 5 ）根據阿爾塔什水庫不同參數組合情況下葉爾羌河流域水庫群調度結果，考慮水利、動能、投資等指標，運用模糊優選理論和灰色關聯分析理論對阿爾塔什水庫興利特徵水位進行了優選，推薦了最優參數組合。
  3. 2. the necessity and difficulty are discussed for the in - place calibration of inertial measurement unit being subjected to the vibration, shock and acceleration induced by the host vehicles. a new in - place calibration method based on the fixed axe rotation constraint is presented

    2 、討論了載體經受振動、沖擊和加速度的情況下，慣性測量組合參數現場標定的必要性和技術難點，提出了基於定軸轉動約束的現場標定演算法。
  4. Through drilling exploration for several years, the extra - low permeable reservoir of yanchang formation in pingbei area of ansai qilfield, has discovered the main oil reservoirs are chang4 + 5 ( subscript 2 ) layer, chang61 layer and chang6 ( subscript 2 ) layer, their pay thickness has reached over 20m, and the reservoir number, reservoir thickness, original oil in place and oil well production have been increased obviously

    摘要安塞油田坪北區延長組特低滲透儲層，通過這幾年鉆探發現主力油層為長4 + 5 （下標2 ）層、長6 （下標1 ）層和長6 （下標2 ）層，油層厚度達20餘米，油層層數、油層厚度、原始原油地質儲量和油井產量都有明顯增加。
  5. Which extends python with a full scientific array language complete with sophisticated indexing

    ，它用非常科學的數組語言以及成熟的建立下標方法擴展了python 。
  6. An aggregate that consists of data objects, with identical attributes, each of which may be uniquely referenced by subscripting

    程序設計語言中）由同一屬性的多個數據對象組成的聚集，每一數據對象可唯一地通過下標來引用。
  7. This makes rexx arrays a feature whose power extends far beyond the way tables are used in programming languages that support only numeric subscripting

    這使得rexx數組的威力遠遠超出了編程語言中表的威力，後者只支持數字下標。
  8. The feeder reconfiguration for loss minimization in distribution systems is realized by changing the status of sectionalizing and tie switches. however, there are many switches in a distribution system. so it is difficult to construct a mathematic model of the relationship between the loads and the switch states with the minimum losses directly

    在滿足各種運行約束條件下，以網損最小為目標的配電網重構問題是個典型的非線性整數組合優化問題，由於開關很多，很難用常規的數學模型直接建立負荷與網損最小時的開關狀態之間的關系。
  9. An array subscript is not valid because it falls outside the allowable range

    數組下標無效，因為它不在允許的范圍內。
  10. In fortran, a subscript quantity or a set of subscript quantities, enclosed in parentheses and used in conjunction with an array name to identify a particular array element

    Fortran語言中的一個括在括號內的下標量或一組下標量，用來與數組名一起標識一特定數組元素。
  11. Arrays in visual basic when you use arrays, you can refer to multiple values by the same name, using a number called an index

    使用數組時，可以用同一名稱引用多個值，並使用一個稱作索引或下標的數字將它們區分開來。
  12. An array allows you to refer to these related values by the same name and to use a number, called an index or

    數組允許您通過同一名稱來引用這些相關的值，並使用一個稱為「索引」或「下標」的數字來區分這些值。
  13. Returns the highest available subscript for the indicated dimension of an array

    返回可用於數組的指定維數的最大下標。
  14. Function to determine the highest available subscript for the indicated dimension of an array

    函數確定數組的指示維度的最大可用下標。
  15. Since array subscripts start at 0, the length of a dimension is greater by one than the highest available subscript for that dimension

    由於數組下標從0開始，因此維度的長度比該維度最大的可用下標大1 。
  16. In this thesis, we will review some traditional methods of detecting data dependence and analyze the relation between the data dependence and the mechanism of parallelism. based on path analysis and symbolic execution, we describe two methods, static analysis and dynamic analysis, for detecting data dependence of array variables in loops of sequential programs

    進而提出了基於路徑分析和符號執行的靜態測試和動態測試方法，來研究串列程序中循環內部數組變量的數據相關性，該方法對于下標表達式為線性表達式時有很好的效果，而且能夠處理一些復雜的數組下標表達式，比如數組下標表達式含有輸入變量和非線性下標表達式的情況。
  17. Since array subscripts start at 0, the lowest available subscript for every dimension is always 0

    由於數組下標從0開始，因此每一維度最小可用的下標總是為0 。
  18. Of course, in known contexts such as array subscripts, the compiler is free to optimize away the actual construction of sublists where that ' s unnecessary

    當然，在像數組下標這樣的已知上下文中，編譯器會優化掉實際不必要的子列表結構。
  19. If you regularly program in a language that uses array indices to access parts of a string and who doesn t, make a mental note that substr is your awk substitute

    如果您通常用於編程的語言使用數組下標訪問部分字元串（以及不使用這種語言的人） ，請記住substr （ ）是awk代替方法。
  20. We can deal with the programs that contain some input variables, the programs with control structures and unexecutable paths. with our method more information will be acquired and the accuracy of the analysis will be improved

    數據相關性的靜態測試可以精確處理數組下標表達式為線性表達式的情況，而且還可以精確求解數組下標中含有輸入變量的情況。
分享友人
分享到 Line

分享到臉書