斜梁 的英文怎麼說

中文拼音 [xiéliáng]
斜梁 英文
cant beam
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 梁 : 名詞1 （屋架中架在柱子上的長木） beam 2 （通常也指檁） purlin 3 （橋） bridge4 （物體中間條狀隆起...
  1. The thesis has summarized the development of the oblique - pull bridge, its construction technology and the importance of bridge construction control, then has introduced project general situation, and has narrated detailed regulation, organization construction, the major work and difficult part of this bridge construction control. the following is the key part of this thesis, firstly, it has introduced the experiment work of early stage, structural calculation and its theoretical result : the absolute altitude of each operating mode, the absolute altitude of building mould in each section and the absolute altitude after pouring concrete ; then, it has discussed the method and content of the line shape control of the main beam, actual absolute altitude of building mould is put forward, and it has described the method of structural stress monitoring, how to arrange measure point and collect data, and how to analyze data. it has also narrated the method of rope force detection and structural temperature inspection

    本論文在總結了斜拉橋的發展及其施工工藝，並指出了橋梁施工控制的重要性之後，簡要的介紹了工程概況，敘述了炳草崗金沙江大橋監控細則、組織機構及監控的主要工作和難點部分；論文的核心部分，在介紹了炳草崗金沙江大橋施工控制與監測工作的前期實驗工作和施工各工況標高、各節段支模標高、澆注混凝土后的標高的結構計算和其理論計算結果之後，詳細論述了主梁的標高線形控制方法和內容，實際支模標高的提出，結構應力監控的方法、布點、測讀及其對測讀數據的合理分析方法，索力檢測和結構溫度監測的方法。
  2. From the analysis, some suggestion about joint rigidity design is put forward : 1. joint initial rigidity can be enhanced within the limited range when to increase end - plate thickness ; 2. the rigidity and ultimate moment can be enhanced obviously when to adopt the beam with inclined section or to add axilla at the connections between beam and column ; 3. withm the permissive construction condition, exteriorly extended end - plate inclinedly placed is suggested to be applied firstly ; 4. when the rate of joint rigidity to beam rigidity, that is called, is less than 0. 1, the joints can be regarded as zero - rigidity joints ; on the other hand, if is more than 26, it is rigid connection joints

    採用斜截面梁並在樑柱交接處局部加腋能明顯提高節點剛度和梁的抗彎能力； 3在允許的施工條件下，應優先採用外伸式端板斜放節點，有利於提高節點剛度，進而提高節點的抗彎能力； 4節點剛度與其連接構件的剛度比值0 . 1時，可按鉸接節點設計； 26時，可按剛接節點設計。
  3. In single pylon cable stayed bridges, and cable stayed bridges without backstays, when the bottom of the tower bears the moment from the dead load, it is concluded that non - symmetric configuration of pile cluster corresponding to the upper structure is more practical than symmetric configuration of pile cluster

    當獨塔斜拉橋、無背索斜拉橋等橋梁塔底永久作用有彎矩時，與完全對稱的基礎形式相比較，和上部結構相協調的不對稱基礎形式更加適用。
  4. Sxm11p straight line beveling machine is the latest develop new style of beveling machine from suntech. it specialty adopt beveling wheel, it can whole progress and can lifting intergrally, it compare to traditional front beam or back beam s lifting, it have more pithiness structure. more better stability, higher grinding precision s characteristic. at present this technique was apply country patent. this machine have high automatizationg, set the grinding paramenter into the interface of the human - machine, the machine can automatic to adjust, realize the glass fine grinding, polishing can be automatic processing in one time

    Sxm11p直線斜邊機是億海公司最新開發研製的新型直線斜邊機，它的特點是採用了斜邊磨頭，即可整體進給，又可整體升降的新技術，與傳統的前梁或後梁升降技術相比，具有結構更簡單，穩定性更好，磨削精度更高的特點，目前該技術已申請國家專利，該機自動化程度高，只要在人機界面上設定有關的磨削參數，機器便可自動進行調整，實現對玻璃精磨拋光等的一次性自動加工。
  5. ; 1. the trend of the development of burden and light hanging basket in the cantalever construction of continuous rigid frame bridge has been prospected, the roof truss and cable - state composite hanging basket also has been designed by analyzing and comparing with other ones. 2

    對大跨度橋梁懸臂澆築施工的各種形式掛籃施工工藝進行了比較和總結，對連續剛構橋懸臂澆築掛籃施工中重載輕型的發展趨勢進行了展望，提出了一種用於解決重載輕型懸臂澆築施工的新型桁架斜拉式組合掛籃，並進行了可行性分析計算和設計。
  6. The linear elastic slope deflection equations of gable portal frames when occur the side - sway and non - sway buckling are derived. the equations considere the rafter slope and the vertical uniform loading subjected on the rafter. the established equations of non - sway buckling can consider the effect of snap change effect of gable frame

    推導了山形門式剛架有側移失穩和無側移失穩的線彈性位移方程，方程考慮了斜梁傾角和斜樑上豎向均布荷載的影響;建立了能考慮山形門式剛架跨變效應的無側移失穩位移方程。
  7. Generally, the skew bridge ' s calculation theories can be divided into three types : the category 1 is the plank theories method, such as the finite difference method, the finite element method and the finite strip method, etc ; the category 2 is the beam theories, such as the grid beam theories, the general grid theories, the rigid cross - beam method, the elastically - supported continuous beam method and the bar system analytical method, etc ; the category 3 is the practical method, such as the g - m revising method, the grid - beam simple method and ghali form coefficient method, etc

    目前關于斜梁橋的計算理論和方法概括起來，大致可以分為三類：第一類為板理論方法，如有限差分法、變分法、有限單元法、有限條法等；第二類為梁理論法，如格構梁理論、一般格構理論、剛性橫梁法、彈性支承連續法、桿件結構的分析方法；第三類為實用計演算法，荷載橫向分佈的計算方法如g ? m修正法、格構梁的簡易法、 ghali表格系數法等。
  8. Study of structure behavior of skew girder bridge

    斜梁橋結構行為研究
  9. A calculation method for transverse load distribution of skew bridge with parallel beams

    多梁式斜梁橋荷載橫向分佈計算的方法
  10. So author believes mechanical behaviors of skew girder bridge is obviously different from that of square beam bridge, and it is an important problem that many factors result in plane deformations of skew girder bridge

    從對斜梁橋的大量計算分析中可以認為，斜梁橋的受力行為與正梁橋的受力行為有明顯的不同，同時，多種因素導致斜梁橋產生平面變形是值得注意的重要問題。
  11. Through over - all stability analysis, the influence of height - span ratio, rafter slope to the stability and the effective factors of gable portal frames are also presented in this paper

    通過對門式剛架的整體穩定分析，研究了剛架的高跨比、斜梁坡度對結構的穩定和計算長度系數的影響。
  12. Author also stressly calculates plane deformations of skew girder bridge due to the actions of the subordinate phase dead load, temperature changes, shrinkage and creep of concrete and vehicle loads in different places, and thereby analyses the characteristics of plane movement for the skew girder bridge

    作者還著重對斜梁橋的二期恆載、混凝土收縮、徐變、溫度變化和不同位置汽車荷載作用下的平面變形進行計算分析，由此分析斜梁橋的爬移特點。
  13. Experiment showes that the skew beam has the mechanical characteristic of coupling of bending and torsion. the skew beam has little influence on bottom slab and lateral slab

    試驗表明斜梁具有彎扭耦合的力學特性，主梁的斜向布置對側壁和底板的影響較小。
  14. This paper primarily aims at the deficiency of conventional computation method of skew girder bridges, calculates and analyses skew girder bridge based on integrated finite element method

    本文主要針對斜梁橋傳統計算方法的不足，採用組合有限單元方法計算分析斜梁橋問題。
  15. Firstly, author calculates a test model of skew girder bridge with a span of 1 m, and compares with the test result, hence validate accuracy of integrated finite element method

    首先計算分析跨徑為1m的試驗模型斜梁橋，並將其計算結果與試驗結果進行比較，組合有限單元方法的準確性得到初步驗證。
  16. With the rapid development of high - grade road and city spatial transportation, skew girder bridges are extensively built. so it brings up lots of new problems for computation theory and method of skew girder bridges

    隨著高等級公路及城市立體交通的快速發展，斜梁橋建造數量也越來越多，因此對斜梁橋的計算理論和方法提出許多新的難題。
  17. In recent years, along with the complete development of the high grade highway and city stereoscopic transportation, the skew bridge has been extensively applicated in the high grade highway, the city road and the stereoscopic transportation hinge for the sake of the line form of the ameliorative road and the increment of the road transportation net1 s ability

    近年來，隨著高等級公路及城市立體交通的全面發展，為了改善道路的線形、提高道路交通網的通行能力，斜梁橋已被廣泛應用於高等級公路、城市道路和立交樞紐中。
  18. Steel structure of light - weight buildings with gabled frames is a widely used steel structural style in china at present. this paper starts with the deficiency of the specificaion in calculating the effective length factors of gable portal frames. when the gable portal frame subjected to the vertical uniform loading, it conducts the arch effect ? 1. rafter axial force is large when the slope of rafter is big

    門式剛架輕型房屋鋼結構體系是目前廣泛應用的一種結構形式，本文從規范中門式剛架柱的計算長度系數取值的不足出發，針對山形門式剛架在豎向均布荷載作用下產生的拱效應? ? 1 、斜梁傾角較大時產生較大的梁內軸力; 2 、產生跨變效應; 3 、高跨比較小的山形門式剛架會發生躍越失穩，採用整體分析的方法對山形門式剛架的穩定進行了分析。
  19. The calculation results of deformation and internal force have been obtained, with which the experimental results are compared. finally, based on the experimental study and theoretical analysis, with the reference of practical calculation method given by related code of concrete structure in time, the practical calculation method and the design suggestion of coal unloading chute with skew beam are brought forward. the method is both reasonable and simple, and the calculated results are in good agreement with that of the experiment

    最後，在試驗研究和有限元分析的基礎上，參考有關現行規范對同類結構的設計方法，提出了斜梁式淺埋箱形卸煤溝結構的簡化計算模型；針對卸煤溝的特點，提出了相應的構造措施及鋼筋配置方式要求；根據地下結構的動態反應特性、主要破壞特徵及震害分析，提出了卸煤溝避免地震破壞的措施。
  20. Secondly author calculates and analyses normal stress and shear stress of the girder for a assembling post - tensioned concrete skew girder bridge with a span of 40 m due to the actions of the dead load, temperature changes, shrinkage and creep of concrete and live loads, and calculates and analyses normal stress and shear stress of diaphragms due to the actions of the subordinate phase dead load, temperature changes, shrinkage and creep of concrete and live loads

    其次重點對跨徑為40m標準設計的裝配式后張預應力混凝土斜梁橋在恆載、溫度變化、混凝土收縮和徐變、活載作用下主梁的正應力、豎向變形和恆載、活載作用下主梁的剪應力進行計算分析。計算分析橫隔板在二期恆載、溫度變化、混凝土收縮、活載作用下的正應力、剪應力。
分享友人
分享到 Line

分享到臉書