斷裂晶體 的英文怎麼說

中文拼音 [duànlièjīngtǐ]
斷裂晶體 英文
fracture crystal
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 體 : 體構詞成分。
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  • 晶體 : [晶體學] crystal; vitrella; crystal body; crystalloid; x-tal
  1. In routine extracapsular cataract extraction ( ecce ), we occasionally may encounter a condition that the zonule around 12 o ' clock direction disrupted with prolapse of a small porion of vitreous during the nucleus being milked out and not delivered yet

    作者利用動物模式提出在囊外白內障手術中，晶體核擠出時，因輪部切口較小，以至尚未擠出晶體核，即發生十二點鐘方向品體?帶斷裂合併部分玻璃體膨出的情況下，如何在盡量減少玻璃體進一步傷害下順利擠出晶體核，並植入後房人工水晶體。
  2. It seems the ncz silicon has a higher bdt temperature compared with cz silicon ' s. it is suggested that the elastic effects and the electronic effects of nitrogen doped in silicon made the bdt temperature higher. the observation of fracture surface showed that it was curves at high temperature in brittle fracture, but smooth planes at room temperature

    當溫度升高達到硅材料的脆塑轉變時，材料的斷裂強度有個很大的提高，但是首次發現含氮硅單晶卻不明顯，而且摻氮的硅單晶脆塑轉變溫度比普通單晶高，可能是氮的摻入改變了硅材料的內部晶體結構及電子結構。
  3. There are a series of lead - zinc polymetallic deposits, such as fozichong, dongtao, xiashui, wenlongjing and jilongding distributed along the fault zone. these deposits have some similiar features : ? ll of them are bounded in the strata of lower palaeozoic group ; ? ain orebodies occur as stratiform or stratoid form with occurrence consistent with that of host strata ; ? tratiform skam or baritic rock are the direct country rock of orebodies ; ? ypical syngenetic sedimentary fabric preserved in the ore. these deposits may be included in the same metallogenic series

    佛子沖、東桃、下水、文龍徑、雞籠頂等一系列鉛鋅多金屬礦床沿該斷裂帶分佈，這些礦床雖然在成礦規模、賦礦層位和礦石礦物組成等方面存在一些差異，但均產于下古生界地層中；主要礦體呈層狀、似層狀產出，與地層產狀大體一致；直接賦礦圍巖為層狀綠色巖或重晶石巖；礦石中保留有典型的同生沉積組構。
  4. The grain boundary fracture behavior in ni - base bicrystals

    鎳基雙晶體晶界斷裂特性研究
  5. With carbon content increasing, the carbide network on the fertile grain boundary sprouting and propagating. the fracture mode has been changed from cleavage to along boundary and the intergranular corrosion induced by solution chromium decreasing

    隨碳含量提高，晶界上碳化物萌發、擴展呈網狀，鑄件脆斷由解理斷裂發展為沿晶斷裂，同時鐵素體不銹鋼晶間腐蝕傾向增大。
  6. Objective to investigate the etiology, manifestations and treatment of glaucoma secondary to chalasia and / or dialysis of the lens zonular fiber

    摘要目的探討晶狀體懸韌帶鬆弛及部分斷裂繼發青光眼的臨床特點及治療方法。
  7. Methods we studied 23 cases which suffered glaucoma secondary to chalasia and / or dialysis of the lens zonular fiber and received lens extraction retrospectively

    方法回顧性分析晶狀體懸韌帶鬆弛及部分斷裂繼發青光眼實施晶狀體摘除手術的患者23例23眼。
  8. Conclusions it is very important to differentiate the patients of glaucoma due to chalasia and / or dialysis of the lens zonular fiber from acute angle - closure glaucoma for they had similar signs

    結論晶狀體懸韌帶鬆弛及部分斷裂繼發青光眼患者的臨床表現與原發性急性閉角型青光眼極其相似，必須加以鑒別。
  9. Phaco emulsification cataract extraction or phaco emulsification cataract extraction combined with anterior vitrectomy as well as posterior chamber lenses implanted into the capsular bag or transsclerally sutured were performed in all cases according to the different instances of zonular fiber

    治療採用晶狀體超聲乳化術，部分患者聯合前部玻璃體切除術，根據晶狀體懸韌帶鬆弛及斷裂程度實施人工晶體囊袋內植入術或人工晶體懸吊術。
  10. The network carbide and acicular martensites that existed in the microstructure of the root grooves of the spline due to improper carburating and quenching process of the shafts, led to the initiation and propagation of the intergranular microcracks and were the main reason that caused the early fracture of the shafts

    由於滲碳淬火工藝不當，在二軸花鍵槽根部的組織中產生了網狀破化物和粗大的針狀馬氏體，在外力作用下形成沿晶顯微裂紋並擴展，是導致二軸疲勞斷裂的主要原因。
  11. A solid - state shear compounding technology based on pan - milling ( s3c ) has established, by which the graphite with weakly combined structure are exfoliated and then compounded with pp at nanoscale. the obtained pp / graphite nanocomposites have greatly enhanced electrical and thermal conductivity. their structures and properties were characterized by analysis of particle size and distribution, sem, tem, xrd, the electrical conductivity, the thermal conductivity and heat - decomposition temperature etc. by taking advantages of the layered inorganic fillers with a weak interaction between layers ( e. g

    磨盤碾磨剪切力場使pp分子鏈斷裂，相對分子質量減小，石墨的導熱和潤滑性能抑制pp的降解和粉碎，使pp / yep250 （膨脹石墨250倍）復合粉磨盤碾磨固相剪切復合技術及導電導熱pp /石墨納米復合材料的制備與性能體中， pp分子運動活性提高，結晶能力增強，為pp在熔融加工中進一步向己剝離的石墨片層間擴散，形成納米復合結構創造了條件。
  12. Crystal fracture type

    晶體裂斷狀
  13. Crystal rupture type

    晶體裂斷狀
  14. 3 the experiment showed that there is no copper deposition in the film using p ( an - mma ) as polymer matrix. but the copper deposition and gradient distributing appears in the film when using p ( an - ita ) and p ( an - mma - as ) as polymer matrix. the size and number of crystal increases as the concentration of ita in copolymer increase and the film is prone to be ruptured

    3實驗顯示p （ an - mma ）作為基體制備的pmgcf五金屬沉積，銅的沉積量為零； p （ an - mma - as ） ， p （ an - ita ）兩種共聚物為基體時均出現金屬銅的沉積，二者金屬沉積相均呈現一定程度的梯度分佈形態，但p （ an - ita ）為基體時得到的晶體比較粗大，且隨其中ita的含量的增多得到粗糙晶體的數目增大，所制的pmgcf脆而硬，受外力沖擊時容易斷裂。
  15. The width of stacking fault increased as partial dislocations move forward. in the fracture of 18 - 8 stainless steel, many dislocations were emitted from the crack tip during the early stage of crack propagation and moved forward, and then a dfz was formed between the crack tip and the pile - up dislocations. the dfz is an elastic zone

    不銹鋼斷裂時，裂尖首先發射位錯，並離開裂尖向前運動，裂尖前方留下無位錯區，位錯反塞積在無位錯區的端部，無位錯區是應變很高的異常彈性區，隨著裂紋的擴展，無位錯區逐漸發生晶體碎化和轉動。
  16. A novel cleavage s - c bond of 2, 5 - dimercapto - 1, 3, 4 - thiodiazole and its two - dimensional crystal structure with dibenzyltin

    碳鍵斷裂及其與二芐基錫的晶體結構研究
  17. Iron and steel. determination using fracture test pieces of the austenitic grain growth tendency and of the hardness depth in tool steels shepherd test

    鋼鐵.用斷裂試驗樣件對奧氏體晶粒增長傾向和對工具鋼硬化深度的測定
  18. Polarization microscope had observed that the size of sphere crystal of pp after adding organic rigid particles became smaller, the excellent compatibility of interphase between matrix and organic rigid particles in composite has been proved, and the organic rigid particles were drew out into cavities from matrix in the photograph of the impact breaking section by sem. the reason of enhanced toughness of the composite is that the material absorbed amount of energy at forming cavities, which is the mechanism of the pp composite toughened with the organic rigid particles

    偏光顯微鏡顯示加入有機剛性粒子可使pp的球晶尺寸減小， sem觀察到復合材料中基體材料和剛性粒子的界面相容性較好，在沖擊破壞的材料斷面上，剛性粒子明顯被拔出形成「空穴」 ，這些微小空穴較易產生而吸收能量，從而提高了材料的斷裂韌性，這是剛性粒子復合聚丙烯的增韌機理。
  19. The impact toughness of the magnets could be improve with appropriate alloying elements addition during ball milling while there was no visible changes to the fracture behaviour, and the coercivity of magnets with al and ti was significantly enhanced

    晶間單獨或復合添加適量合金元素對磁體沖擊韌性均有一定提高作用，但對斷裂模式沒有明顯影響，復合添加ti 、 al能顯著提高磁體矯頑力。
分享友人
分享到 Line

分享到臉書