方位線斜角 的英文怎麼說

中文拼音 [fāngwèixiànxiéjiǎo]
方位線斜角 英文
bearing inclination
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 方位 : position; bearing; direction; points of the compass; placement
  • 斜角 : [數學] [物理學] oblique angle; [機械工程] bevel angle斜角規 miter square; bevel; bevel square; sa...
  1. First, this method decide the skew angle of a business card image according to four border fitting lines of the business card, then a method based on block move is provided to correct image and black border is erased based on position of border near - line

    該方法先檢測出名片的四條邊緣擬合直線，由四條邊緣擬合直線的傾斜角度來確定名片圖像傾斜角度，然後採用逐段整塊搬移的方法來對圖像進行傾斜校正，再根據邊緣擬合直線位置去除黑邊。
  2. The linear elastic slope deflection equations of gable portal frames when occur the side - sway and non - sway buckling are derived. the equations considere the rafter slope and the vertical uniform loading subjected on the rafter. the established equations of non - sway buckling can consider the effect of snap change effect of gable frame

    推導了山形門式剛架有側移失穩和無側移失穩的線彈性位移方程，方程考慮了斜梁傾角和斜樑上豎向均布荷載的影響;建立了能考慮山形門式剛架跨變效應的無側移失穩位移方程。
  3. When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved

    分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。
  4. By computing the between two resolution units, we can estimate terrain azimuthal slopes and derive estimate of terrain elevation. the terrain contour is determined uniquely by ay / from azimuth slop on range gates. american began to study p - sar three - dimensional images technology in 1990s

    Schuler已經證明，對於一個均勻分佈場景， sar圖像上兩個相鄰分辨單元的極化橢圓方向角偏移量，與地形方位向坡度的對應關系是線性唯一的，地形方位向的傾斜度可以通過解唯一地被測定。
  5. The radiation patterns at different scan angle from - 20 to 20 degree are presented, and the angle difference between the maximum / minimum field points of their main beam shows the bse of the radome. at different frequencies, the radiation from the antenna has been discussed when azimuth scan angle ranges between - 20 degree and 20 degree. the relationship between

    200 ~ 200范圍內天線的和方向遠區場、方位差方向遠區場;得到方位瞄準誤差、瞄準誤差斜率和功率傳輸系數隨掃描角和入射波頻率的變化關系;並將所得數據與文獻數據進行比較，表明間接射線法簡單、有效且精度較高。
分享友人
分享到 Line

分享到臉書