旋渦出流 的英文怎麼說

中文拼音 [xuánguōchūliú]
旋渦出流 英文
outflow vortex
  • 旋 : 旋Ⅰ動詞1 （旋轉） whirl 2 （用車床切削或用刀子轉著圈地削） turn sth on a lathe; lathe; pare Ⅱ名詞...
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 旋渦 : vortex （pl vortices; vortexes）; whirlpool; vemous; eddy; vorticit; backset; swirl; [地質學] nuc...
  1. One of factors which activize the explosive development of cyclone exists strong convective instability in lower layers from the analysis of the barotropic potential vorticity

    由正壓位渦分析得出，氣旋爆發性發展的啟動因子之一為低層存在強對流性不穩定。
  2. In the most intensely turbulent flows, we can often discern a semblance of order through the disorder of the eddies.

    對大多數強烈湍流，往往可以透過旋渦的混亂看出一種井然有序的外表。
  3. Friction between the spinning glass and the liquid inside causes swirls of fluid to appear and disappear, displaying intricate flow patterns

    旋轉的玻璃與當中包含的液體互相摩擦，形成不斷生滅的旋渦，展現出錯綜復雜的流動形態。
  4. Friction between the spinning glass and the liquid inside causes swirls of fluid to appear and disappear, displaying intricate flow patterns. these patterns resemble the atmospheric storms on earth, jupiter, saturn, uranus, and neptune

    旋轉的玻璃與當中包含的液體互相摩擦，形成不斷生滅的旋渦，展現出錯綜復雜的流動形態。這些形態與地球、木星、土星、天王星及海王星上的大氣風暴相似。
  5. Its peculiarity is that the vortex pair formed on the ejection stroke can ? move far enough under the self - induced velocity, so the vortex pair is sucked into the cavity of the actuator during the suction stroke

    這種流動的特點是：在作動器的「吐出」行程，其出口產生的旋渦對還來不及向下游遷移便進入了作動器的「吸入」行程，重新進入作動器腔體。
  6. The topological characteristics graph of flow is derived by means of topological analysis method

    通過拓撲分析的方法，給出了橫流中有限寬窄縫射流旋渦近區流場的拓撲性質。
  7. In this work, a new dual triangulate bluff body vortex flowmeter was developed, the flux lower limit value of which lower by 50 % that of the old single bluff body vortex flowmeter. the linear correlation of the correlation between the velocity pressures of fluid disturbs wave and that of vortex precession in vortex precession flowmeter was brought to light, and a spectrum phase discrimination method based on fft to remove the effect of fluid pulsating interference on vortex precession flowmeter was advanced

    研製出比傳統單鈍體渦街流量計流量下限降低約50的新型雙鈍體渦街流量計；揭示出脈動流中旋進旋渦流量計流體振動特性，並在此基礎上提出基於fft相位判別的數字信號處理方法來消除流場脈動對旋進旋渦流量計的干擾的方法。
  8. In the second chapter, the fluid mechanics principle of vortex flowmeter at first was introduced. the classical theory about vortex flowmeter and the method of computational fluid dynamics about flow around body were expanded on, and the model of the single bluff body and the dual bluff body vortex flowmeter were constructed. and then, fvm - finite volume method - analysis software fluent was applied to analyze the flow phenomenon of flow over single bluff body or dual bluff body

    然後通過大量實驗和理論分析給出雙鈍體渦街流量計的設計準則：當管徑為d ，鈍體形狀為三角形，則鈍體設計參數為：銳邊寬度= 0 . 26d ，高度= 0 . 34d ，鈍體之間的距離= 1 . 2d （即當兩鈍體寬度相等且鈍體距離等於單鈍體兩列旋渦之間的距離） 。
  9. Based on detailed analyze on turbine engine and ramjet, a new conceptive internal - rotor burnt rotating ramjet ( irbrr ) with an rotating cylinder in the center of rotor in which the revolved stream can be ram - compressed and burnt has been proposed and some primary research have been done as below : the scheme of structure, principles, thermodynamic cycle and performances of the new conceptive engine has been studied in the paper

    本文通過對燃氣渦輪發動機和航空沖壓發動機的原理結構進行詳細分析並進行融合創新，提出了一種利用內置旋轉汽缸進行旋轉氣流沖壓壓縮和旋流燃燒的新概念內置燃燒室旋轉沖壓發動機，並進行了一些前期的基礎性探索研究，具體研究內容有:對旋轉沖壓發動機進行了總體方案設計、工作原理分析、氣動熱力循環和性能分析等概念性研究。
  10. After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise

    通過對水壓閥模型的cfd穩態和瞬態解析，可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈，據此定性分析流道結構（速度、壓力、流動的分離與再附壁，旋渦的產生與消失等）與能量損失、負壓分佈等的關系，從而為設計出高效率、低能耗、低噪聲的水壓閥提供理論依據。
  11. In this paper, simple reacting flow model in solid - propellant ducted rocket combustor based on eddy break - up model is established. the model is used to simulate the three - dimensional combustion flowfields in an experimental motor. some factors how to affect the combustion efficiency are discussed in the paper, including air intake and gas generator nozzle

    本文基於簡單反應的旋渦分裂模型，建立了固體火箭沖壓發動機補燃室內的湍流燃燒模型，並在該模型下對某實驗發動機進行了三維數值模擬，研究了補燃室設計參數包括進氣道出口設計參數和燃氣發生器噴管設計參數對燃燒效率的影響。
  12. The effects of the slipstream boundary are solved by the slipstream boundary condition met using the so - called vortex image method. based on these considerations, the change in the circulation around the wing is obtained, and the velocities induced by the original vortices and the imaged vortices at the wing are subsequently derived. the present research also gives an analytical expression of the drag change due to the slipstream interference

    對于滑流邊界的影響，用「鏡像法」來使滑流邊界條件得到滿足，導出了由於滑流影響機翼環量的改變，求得渦及其鏡像在機翼處的誘導，並首次導出了螺旋槳滑流對機翼阻力特性的影響的解析表達式。
  13. The causes of poor inlet conditions such as backflows and vortices were analyzed, and some measures were made to ameliorate flow patterns and improve pump performance

    通過模型試驗，分析了產生不利進水條件如迴流、旋渦的成因。由此提出了改善進水流態和改善機組運行性能的工程措施。
  14. Based on this discovery, a novel swirlmeter with a strong anti - jamming performance was developed

    基於這一結果，研製出抗干擾性能很強的新型旋渦進動流量計。
  15. With computations and analysis, the comprehension on the mixing and combustion process is increased, and some significative results are listed below : a ) there are three recirculation regions and one vortex region in the combustor, and these recirculation regions affect the combustion process deeply, b ) increasing side - arm angle and moving side - air inlet position toward the fuel inlet can improve mixing and combustion characteristics, and increase the combustion efficiency, c ) when the angle between two air - inlets equals to 180

    通過計算與分析，增進了對補燃室內摻混燃燒過程的理解，為固體火箭沖壓發動機補燃室設計提供了一些有意義的結果： 1補燃室內的流動十分復雜，存在三個迴流區和一個旋渦區，迴流區對摻混燃燒過程有重要影響； 2增大空氣入射角度、向前移動進氣道出口位置有利於增強頭部迴流區強度，增強摻混效果，燃燒效率上升； 3
  16. In the third chapter, the method and choosing principle of the test system component at first were brought out. the component of test device was introduced. and then, the characteristics, such as strouhal number, vortex street strength, vortex street stability and pressure drop coeffi

    縱觀全文，本文成功地將cfd技術和實驗流體力學方法應用於新型雙鈍體渦街流量計的研究，並對旋進旋渦流量計的流體振動特性和抗干擾方法進行系統研究，提出了旋進旋渦流量計抗干擾設計的新方法。
  17. By solving the 2 - d viscous navier - stocks equation, the flow field of the microjet was simulated. the results clearly reveal the features of microjet and the process of vortex pairs ? formation, advection, diffusion and entrainment effection on ambient fluid

    結果清晰的反映了作動器出口附近微射流場的形態，同時也再現了此區域內旋渦對的生成、遷移和擴散過程以及微射流對周圍流體的卷吸作用。
  18. Abstract : in order to improve the performance of a vortex classifier, a certain type of narrow plates are fitted in the passages between the blades in the rotor cage. this measure results in reduction in the cut size and increase in classifying precision. more significant effect is observed in the case of the rotor cage with fewer blades originally fitted. it is pointed out that the reason is due to the decrease in inertia counter vorticity

    文摘:在渦流分級機轉籠通道中心加裝窄葉片使產品分割粒徑減小，分級精度提高.轉籠徑向葉數較少時加裝效果明顯，徑向葉片數多時效果不明顯.分析指出，這是減小了轉籠徑向葉片間慣性反旋渦強度的緣故
  19. The assemble criterion of sensor for design was advanced. at last, a method of increasing signal - to - noise ratio and reducing flux lower limit value of vortex flowmeter was advanced. the experiment program was advanced

    針對旋進旋渦流量計的理論分析所存在的問題，論文應用fluent軟體對該流量計進行了直接流場模擬研究，分析模擬的結果和誤差，並提出了改善模擬精度的途徑。
  20. The literature about primary instrument and secondary instrument of vortex type fluid oscillatory flowmeter was summarized. and then, the recently new development of vortex type fluid oscillatory flowmeter and its limits were discussed

    介紹了旋渦型流體振動流量計在一次儀表和二次儀表方面研究的情況，指出該類流量計研究中所面臨的主要問題。
分享友人
分享到 Line

分享到臉書