時滯電路 的英文怎麼說

中文拼音 [shízhìdiànlù]
時滯電路 英文
time-lag network
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 滯 : Ⅰ動詞（使停滯; 使不流通） stagnate; block up Ⅱ形容詞（停滯; 不流通） sluggish; slow-moving; stagnant
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. A novel low mechanical hysteretic ceramic capacitive pressure transducer has been made, by using of ceramic sealing technology ; integrate circuit ( ic ) technology and thick film plane fixing circuit technology. this transducer is made of a deformable ceramic diaphragm and a ceramic base plate, between which has an air cavum. a coaxial gold electrode was fired onto the diaphragm and the base plate

    本文利用新型陶瓷技術、集成電路技術和厚膜平面安裝電路技術，採用零力學滯后的陶瓷和陶瓷密封材料進行設計製造了一種非充液乾式的電容式壓力傳感器，該壓力傳感器由較厚的陶瓷基體和較薄的陶瓷膜片構成，中間形成一空氣介質腔，在基座和膜片之間內置同軸的雙電極，組成兩個電容，當膜片承受壓力時發生位移，使電容量產生變化，經後置處理電路直接轉換為可輸出的直流電壓信號。
  2. Different power circuits and control strategy of the single phase inverter in parallel condition are first analyzed, and half - bridge inverter is selected as the power circuit and current hysteresis control is selected as the control strategy

    本文首先對單相逆變器的主電路結構和控制電路的結構在並聯條件下進行了比較分析，最後選用了半橋結構的主電路和內環為滯環控制的瞬時電壓電流雙閉環反饋控制方式。
  3. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  4. For the convenience of test, varied circuit chip defects caused by the production process are abstracted as all kinds of models. at present the commonly used fault models mainly consist of stuck - at fault, stuck - open fault, bridge fault, store fault, delay fault, etc. testing methods based on voltage testing mainly aim at stuck - at fault model and have also obtained satisfactory result in research for many years. bridge fault is tested easily by quiescent power supply current ( iddq ) testing method. in regard to stuck - open fault that is difficult to testd by quiescent power supply current ( iddq ) and voltage testing, it can is tested by the dynamic current ( iddt ) testing

    為了便於測試，我們將生產過程中集成電路出現的多種多樣的缺陷抽象為各種模型。目前常用的故障模型主要有:固定故障，開路故障，橋接故障，存儲故障，時滯故障等。電壓測試主要針對固定型故障模型，多年的研究也取得了令人滿意的結果; cmos電路中的橋接故障則宜用穩態電流測試方法（ iddq ）測試;對于電壓和穩態電流難以測試的開路故障，可以使用瞬態電流測試（ iddt ）的方法進行測試。
  5. The pulse neutron generator " s delaying time are measured by the time - amplitude converter and multichannel pulse amplitude analyzer. according to these times, the linear gate circuit " s opening time can be adjusted

    用它和多道脈沖幅度分析器配合測量脈沖中子發生器發射中子的滯后時間，據此調整線性門電路的開門時間。
  6. Owing to the delay in change of regulation of executing agency with respect to changes in realistic state, arc furnace is predicted the state in the next time, with nn predicting model, so that the current wins comparative stabilization and impact of trashy power is reduced

    本文首先針對電爐的執行機構的調節總是滯後於電弧爐實際狀態的變化，加上電弧爐神經網路預估模型，通過它預估出電弧爐下一時刻的狀態，使電弧電流能達到一種相對的極穩狀態，減少無功功率沖擊。
  7. The power - electrical impedance equivalent circuit of each separate module is analyzed and more concise designing rule is educed from it by connecting corresponding four - terminal network in series and taking the material and section area of the separate module as variable

    本文分析了各分離組件的力電阻抗等效電路，並將對應的四端網路相互串聯，以分離組件的材料和截面積為變量，經過分析得出具有分離組件的振動件不管材料是滯相同，設計時均可將多個分離口組件看為一個體的設計規律。
  8. In order to decrease the harmonics in mc ' s input and output current, the svm method and sinusoidal hysteretic band method are introduced into the mc hysteretic control respectively. secondly, based on the predictive current control fundamental principle, the particular 27 vectors predictive current control strategy and current trend predictive control strategy are proposed. the simulation indicates that all of the current methods can improve the mc ' s output current quality and speed its dynastic response

    提出了矩陣變換器的滯環電流控制策略，並針對滯環控制時輸入電流和輸出電流的諧波，分別提出了輸入電流空間矢量合成滯環控制方法和正弦環寬滯環控制方法；引入了矩陣變換器的預測電流控制新思路，在此基礎上，提出了矩陣變換器獨特的27矢量預測電流控制方法和趨勢型預測電流控制方法，模擬結果表明，各種電流控制方法提高了變換器的輸出電流品質，加快了變換器的動態響應性能。
  9. Time - delay circuit

    時間延滯電路
  10. However, only ideal inductors can be called when circuits are simulated, hysteresis phenomena of cores are often regardless of, which results in the evident difference of the simulations and the real, and the simulating results couldn ’ t guide real works at present

    由於進行電路模擬時只能調用軟體自帶的理想感性元件，忽略了磁芯感性元件的磁滯特性，因此，造成模擬結果與實際相差很遠而不能指導實際工作。
分享友人
分享到 Line

分享到臉書