時間響應 的英文怎麼說

中文拼音 [shíjiānxiǎngyīng]
時間響應 英文
temporal response
  • : shí]Ⅰ名1 (比較長的一段時間)time; times; days:當時at that time; in those days; 古時 ancient tim...
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. The causes resulting in thickness dependence of the optical properties of the films were discussed on the basis of the pl, optical transmission, and afm analyses. we understood that zno is an excellent material for uv detector by research on uv photoconduction

    綜合光致發光譜、光學透射譜和薄膜表面形貌,對導致光學性質隨膜厚變化的原因進行了討論;研究了厚膜zno的紫外光電導時間響應,得出zno材料具有很好的紫外探測性能結論。
  2. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝,側重研究了碳化、反室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影,研究結果表明:隨著碳化的增長,碳化層的晶粒尺寸隨之變大,表面粗糙度隨之降低,但當碳化到一定之後,碳化反減緩,碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反室氣壓的升高而變大,適中的反室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小,碳化層的晶粒尺寸隨氣體流量的變化不明顯,但當氣體流量增大到一定程度,碳化層的晶粒尺寸隨氣體流量的增大而明顯變大,同,適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低,碳化層的晶粒取向不明顯,隨著碳化溫度的升高,碳化層的晶粒尺寸明顯變大,且有微弱的單晶取向出現,但取向較差,同,適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ,以ch _ 4作為c源氣體得到的碳化層表面平整得多;比起si ( 100 ) ,選用si ( 111 )作為基片生長的碳化層的晶粒取向一致性明顯更好。
  3. Three porphyrin complexes of palladium were chosen as phosphorescence sensing molecules : palladium - meso - tetra ( trimethylaminophenyl ) porphyrin ( pd - tapp ), palladium - coporphyrin ( pdcp ) and palladium - meso - tetra ( p - sulfonicphenyl ) porphyrin ( pd - tspp ). they were bound to dowex resins, and made into oxygen sensor. we detected the characteristics such as sensitivities and response times combined with flow injection analysis ( fia ) technology

    選取了三種金屬鈀的卟啉配合物:四- (三甲氨基苯基)鈀卟啉( pd - tapp ) 、鈀糞卟啉( pd - cp ) 、四- (對磺酸基苯基)鈀卟啉( pd - tspp )作為磷光傳感分子,將其固定在dowex樹脂上,製成傳感器,並與流動注射分析技術( fia )結合起來,考察了其對氧的傳感靈敏性,時間響應特性等條件。
  4. The main works are shown as followings : in order to get best economic benefits and quickest time response, the advantages and shortages of existing methods for machining twin - screws are analyzed. in view of the production of co - rotating twin - screw is various and mostly in small batch, a new approach for forming cylinder helical surface with milling cutter is put forward. it presents the theoretical foundation for machining of twin - screw

    論文主要工作有如下幾點:針對同向雙螺桿產品零件的多品種、小批量的生產特點,為了取得最佳經濟效益和快速地時間響應,在查閱了雙螺桿加工有關的國內外文獻資料,研究分析了雙螺桿各種現有的加工方法的優缺點,提出了一種新的加工方法? ?用圓柱立銑刀成形加工雙螺桿螺旋面。
  5. Abstract : the synthetic method of pentaerythrito naphthenate by n on - acid catalyst sno was studied. the influences of mole ratio of ethanediol and naphthenic acid, a mount of catalyst, reation time, reation temperature etc. on est erification were discussed and the suitable processing conditions were found

    文摘:介紹了用氧化亞錫非酸性催化劑催化合成環烷酸季戊四醇脂的方法,通過討論醇酸摩爾比、催化劑用量、反、反溫度等因素對該脂化反的影,從而確定了適宜的工藝條件
  6. Then, it is possible to define a state - space representation of the fractional model, which permits to approximate the continuous - time response of an ideal system

    然後,可以定義非整數階模型的狀態方程實現,它允許近似理想非整數階系統的連續時間響應
  7. This thesis also have constructed mathematic model based on the analytic method, which used the load as input and the pressure as output, meanwhile, it have made theoretic analysis of time response. the theoretic analysis was highly agreed with the experimental result

    在對出口節流調速系統液壓缸兩腔壓力隨負載變化的動態特性的理論分析,用解析法建立了以負載為輸入,壓力為輸出的數學模型,進行時間響應分析,其理論分析結果與試驗結果相吻合。
  8. It really provides convenience to evaluate and optimize the design result. 3 ) vibration analysis has been fulfilled by calling some math libraries and graphic libraries in matlab to plot graphics such as velocity - time, displacement - velocity, step response, impulse response, gain - frequency and phase - frequency. we can know the capabilities of the spring system from the graphics

    3 、在matlab環境下調用相的數學函數庫和圖形庫對設計的彈簧進行分析,繪制彈簧加載后系統的速度-時間響應曲線、速度-位移曲線、階躍曲線、脈沖曲線、增益-頻率曲線和相角-頻率曲線,根據曲線來分析系統的各項性能。
  9. The phenomena originate from the same response to the same generation in the self - organized process of rivers in the process

    產生空演替現象的根源在於河流自調整作用在同一變源下空時間響應的一致性,是過程的相似。
  10. Optimum time response sequence for gm

    模型時間響應函數的最優化
  11. Optimum time response sequence for

    模型時間響應函數的最優化
  12. Nuclear power plants - time response design criteria for safety related operator actions

    核電站.有關安全操作人員行為的時間響應設計準則
  13. What happens when your web service request times - out, or takes a really long time to respond

    當web服務請求超侯,或者用了非常長的時間響應會發生什麼?
  14. Target and cloud ' s temporal profiles on detector are studied, and four temporal models are built

    分析了雲層背景下目標和雲層在探測器上的時間響應特性,建立了四種類型的像素點域模型。
  15. The light switches have the characteristics of fast response and could be used in the system requiring fast response

    這種結構的光開關時間響應極快,可以達到飛秒量級,可以用於要求時間響應極快的系統中。
  16. This kind of detector has many merits as follows : fast response time, large output current, fine linear response, high sensitivity to many particles including neutron, charged particle, x - ray, gamma - ray, visible light, and being able to work at indoor temperature

    這種探測器具有時間響應快,輸出電流大,對多種粒子如中子、帶電粒子、 x射線、射線、可見光都具有高靈敏度,而且的線性性好,可在室溫工作等特點。
  17. According to the actuality of the present research on ct, this paper introduces the measurement principle of rogowski coil and analyzes the factor that influence the precision of measurement, we bring forward a new design scheme based on the rogowski coil

    本文首先介紹了國內外電流互感器發展現狀,重點對rogowski線圈測量原理進行分析,研究了線圈的穩態測量誤差以及幅頻特性、相頻特性、暫態時間響應特性,論證了羅氏線圈作為傳感器單元所具有的優良特性。
  18. Error related to the model establishing and screen cover is studied in both theoretical and experimental way. according to the causation of the error, the adjustment part is adopted in the processing of signal. in addition, the characteristics between amplitude and frequency are also analyzed

    本文重點對影rogowski線圈測量的諸多因素進行分析,研究了線圈的穩態測量誤差以及幅頻特性、相頻特性、暫態時間響應特性,論證了羅氏線圈作為傳感器單元所具有的優良特性。
  19. In chapter five, on the basis of setting up a set of math models of four - dimensional pressure control system, and making use of copying tool - simulink supplied by matlab, the frequency and time field specific property has been analyzed, and several curves of frequency and time field specific property in the systemhas been obtained. as a result, some modelled conclusions have been acquired

    第五章在建立四維井底壓力控制系統數學模型的基礎上,採用matlab提供的模擬工具? simulink ,對系統頻域特性、域特性進行了分析,並獲得該系統的頻域特性曲線、階躍時間響應曲線等,最終給出模擬結論。
  20. Then, a mathematical model for this valve is established on this base. a linearized simulating model is set up with modern control theory and the digital simulation of the dynamic process is carried on by matlab. the results of the digital simulation are drawn in time process diagram of curves and the qualitative analysis is made

    在此基礎上,建立了同步系統的數學模型,同,運用現代控制理論建立了線性化的模擬模型,利用matlab進行動態過程的數值模擬,並繪製成時間響應曲線,對模擬結果作了定性分析。
分享友人