晶隙位置 的英文怎麼說

中文拼音 [jīngxìwèizhì]
晶隙位置 英文
interstitial site
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  1. Some impurities are entirely substitutional or interstitial in behavior, but others can exist in either lattice position.

    有些雜質是單純的替代位或單純的間隙位雜質，但也有的可以在任一晶格位置存在。
  2. Such control can be realized in case where a atom interact with photonic band gap matericals when the atom is placed in photonic crystals whose density of modes is dramatically different from that of free space vacuum. it was known that control could be achieved by varying the frequency ( which leads to the changes of the relative position of the upper levels from the forbidden gap ) or by varying the photonic density of modes ( dos ) or by varying the intial atomic state

    由於光子晶體具有不同於真空中的光子態密度，原子和光子帶隙材料便發生相互作用，這樣便可以控制原子的自發輻射。改變原子上能級與光子禁帶邊緣的相對位置、材料中的光子態密度或原子初態都可以控制原子的自發輻射。
  3. Slight displacements of atoms relative to their normal lattice positions, normally imposed by crystalline defects such as dislocations, and interstitial and impurity atoms

    原子相對於它們正常點陣位置的輕微位移，通常是由晶體的缺陷，如位錯、間隙原子、雜質原子存在引起的。
  4. This thesis work has researched the fabrication technics of photonic crystal defect waveguide with air - bridge structure and collecting waveguide ; suggested using uv - lithography and wet etching to fabricate traditional waveguide, after that, using eb - lithography and dry etching to fabricate photonic crystal holes, so can reduce the fabrication cost by a big range ; designed the moulding board, which can fabricate the air - bridge structure and is convenient for recognizing position in eb - lithography ; the structure consisted of traditional waveguides and etching grooves are fabricated on soi successfully, then an successful eb - lithography is realized on the structure, the defect waveguide collected with the traditional waveguide quite well ; used the etching grooves to do the sacrificial layer etching experiment, which grounded etching sacrificial layer by photonic crystal holes in next step

    提出採用紫外光刻工藝製作傳統波導結構之後，通過電子束曝光和干法刻蝕製作光子晶體小孔的工藝方案，大幅度減低了製作成本；設計出可形成空氣橋結構、並且適用於電子束曝光位置識別的光刻模板，在soi材料上成功製作出帶有空氣橋刻蝕預留槽以及接續光波導的結構，在該結構上成功實現了光子晶體帶隙波導的電子束曝光，帶隙波導與接續光波導位置接續良好；最後利用預留槽進行了刻蝕犧牲層的實驗，為下一步利用光子晶體小孔刻蝕犧牲層形成空氣橋結構打下了基礎。
  5. The lattice constants were refined using celref program. when implanted c / fe ions ratio is 0. 5 %, the p lattice is expanded, though c atom is much smaller han si. this is probably due to the solid solution in interstitial state

    單胞的間隙位置，形成間隙型固溶體，使晶格膨脹；當摻雜的碳離子含量增加到一定的程度時，趨向于形成置換固溶體，因為碳和硅屬同族元素價態相同，所以碳會置換p 。
  6. In order to adapt to different implementation, linux has been modified and refined to be a specific embeded system. the implement of an sdh adm control platform based on the embeded system, which is used to configure the adm and accomplish the timeslot configeration 、 overhead insertion 、 loopback configeration 、 mapmode configeration 、 mode selection and reset etc., is introduced in this dissertation

    論文介紹了一種基於嵌入式系統的「 sdh專用分接器控制平臺」實現方案，可通過網路在線配置sdh專用分接器，完成時隙配置、開銷插入配置、環回配置、映射模式配置、模式選擇、晶元復位控制等功能。
  7. In addition, the control of spontaneous emission of a three - level atom embedded in photonic crystals was investigated in this paper, because the model of two - level atom is siple. as it shows, the properties of spontaneous emission depend not only on the relative position of the resonant frequency from the edge of the photonic band gap and the photonic mode density but also on the intial atomic state

    二能級畢竟是最簡單的模型，故在最後，還對光子晶體中三能級原子的自發輻射特性進行了研究。結果表明，其自發輻射除了依賴于原子上能級與光子頻率帶隙邊緣的相對位置或光子態密度外，還依賴于原子的初始狀態。
  8. A diffusion mechanism whereby atomic motion is from interstitial site to interstitial site

    晶體擴散機制的一種。間隙原子由一個間隙位置遷移至鄰近的間隙位置所構成的擴散。
分享友人
分享到 Line

分享到臉書