晶體穩定頻率 的英文怎麼說

中文拼音 [jīngwěndìngbīn]
晶體穩定頻率 英文
crystal-controlled frequency
  • : Ⅰ形容詞(光亮) brilliant; glittering Ⅱ名詞1. (水晶) quartz; (rock) crystal 2. (晶體) any crystalline substance
  • : 體構詞成分。
  • : 形容詞1 (穩定; 穩當) steady; stable; firm 2 (穩重) steady; staid; sedate 3 (穩妥) sure; rel...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • 晶體 : [晶體學] crystal; vitrella; crystal body; crystalloid; x-tal
  • 穩定 : 1 (使穩定) stabilize; steady 2 (穩固安定) stable; steady 3 (物質的性能不易改變的作用) stabi...
  • 頻率 : frequency; rate
  1. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    電路的設計主要分三大部分來實現:激勵源電路部分,由分電路和合成電路組成,產生的激勵信號以確保檢測任務的正常進行;傳感器變換電路部分,由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成,主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號,易於后續電路處理;由dsp元構成的微處理系統,主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  2. The stability output second harmonic generation ( shg ) experiment results of single - longitudinal mode and multi - longitudinal mode with long cavity were explained reasonably with these rate equations. the high polarization of fundamental wave in the isotropic laser media nd : yag with type - i critical phase - matching lbo was studied with the rate equations including polarization of fundamental light. using the polarization function of lbo, a quartz full - wave plate was introduced into the cavity, a kind of birefringent filter by considering the combination of the polarization function of the type - i critical phase - matching doubling frequency crystal lbo and the quartz whole - wave plate was constructed

    將腔內多縱模倍方程推廣應用到準三能級藍光激光器中,分析了一個縱模、兩個縱模、多個縱模時的噪聲情況,合理地解釋了實驗中激光器單縱模運轉以及長腔多縱模運轉時輸出的實驗現象,同時利用該速方程分析了以各向同性激光nd : yag為工作物質,類臨界相位匹配lbo為倍的藍光激光器中基光偏振特性,合理利用類臨界相位匹配lbo倍的偏振特性與引入的石英全波片構成雙折射濾光片,通過選單來抑制噪聲,獲得了藍光低噪聲的輸出。
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光器的發展狀況、主要特性及其應用,從四能級速方程出發,推導了ld泵浦nd : yag激光器的閾值、輸出功和斜效的表達式,並簡述了激光器的工作原理、結構型式和倍方法;其次,以空間相關的速方程為基礎,提出了ld端面泵浦nd : yag激光器的設計方法,給出了一泵浦耦合方式下,振蕩光模尺寸、最佳輸出耦合、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據,以此為依據,設計了自聚焦透鏡耦合小功ld泵浦nd : yag激光器和透鏡組耦合高功ld泵浦nd : yag激光器,對激光器的輸出功和功性等特性進行了實驗研究;再次,在帶尾纖輸出的高功ld泵浦nd : yag激光腔內插入一隻空液盒,觀察到了激光器以單縱模運轉;最後,根據泵浦光焦斑端面位置對激光輸出功的影響規律,提出了ld端面泵浦nd : yag激光位移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時,激光輸出功的自然指數與泵浦光焦斑的縱向位置成高斯變化規律,測量范圍和靈敏度依賴于泵浦功,隨著泵浦功的增加,測量范圍擴大,靈敏度提高,當端面泵浦功為7 . 24w (最大輸出功為1 . 926w )時,激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. The common frequency synthesizers may not meet the demand on frequency stability and accuracy. and some of them are just desirable at a single frequency, which only can be varied in narrower spectrum

    於是出現了高振蕩器作為標準信號發生器,但他們的往往是單一的,只能在很小的范圍微調。
  5. To compare with transistor ( complete solid - state ) high - frequency linear power amplifier, there are some disadvantages : bad stability and reliability, low efficiency, high cost for operating, huge cabinet, heavy maintenance work load, low security for high - voltage electricity offering, and to ensure the continuance of tv program, the transmitter must be operating with main frame and spare frame

    它們與管(全固態)高線性功放大器相比,存在著性及可靠性差、效低、運行費用高、發射機積大、日常維護工作量大、高壓供電不安全、必須採用主機和備機的運行方式來確保電視節目不停播等缺點。
  6. With the quick development of electronic technology, high - stability crystal oscillator is being used more and more widely. especially, temperature - compensated crystal oscillator ( tcxo ) is commonly used in electronic equipments such as communication, navigation, radar, measure instruments etc.

    隨著電子技術的飛速發展,高度振蕩器得到了廣泛的應用,特別是溫度補償振蕩器( tcxo )更是廣泛應用於通信、導航、雷達、測量儀表等電子設備中。
  7. The influence of resonator parameters including the resonator length, curvature radii of mirrors and thermal focal lengths of the laser rod and doubled crystal on the system stability is analyzed with numerical examples. 4

    分析了腔幾何參數,包括腔的尺寸、反射鏡的曲半徑以及倍的熱焦距對系統性的影響,並作了數值計算和討論; 4
  8. The at - cut crystal freqency - temprature characteristice is equivalent to an equation of the third order, it display excellent freqency stability over wide temprature range

    At切石英元件的溫度特性曲線是一條三次曲線,在寬溫度?圍內具有相當良好的性。
  9. The basic principle of feedback crystal oscillator is analyzed. the basic concept of frequency stability is also introduced, following by the usual expression of phase noise in frequency domain and phase jitter in time domain. further, we describe the origin of crystal oscillator ' s phase noise and phase jitter, also list a variety of its contributors

    然後從理論上分析了反饋型振蕩器的基本工作原理,並闡述度的概念,給出了在域中相位噪聲和時域中相位抖動的表示方法,形成原因以及影響相位抖動的諸多因素。
分享友人