最佳反應 的英文怎麼說

中文拼音 [zuìjiāfǎnyīng]
最佳反應 英文
optimum response
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 最佳 : the best; optimum
  1. Secondly, according to the effect of the change in the gas properties on the burning of burners, the possible adjustive measures are analyzed and at the basis of which corresponding alterative plans are proposed

    然後，根據氣體物性改變對燃燒器燃燒的影響，分析可能的調整措施。在此基礎上提出相應的改造方案，並通過反復實驗確定其穩定工況和最佳方案。
  2. With phosphato - tungstic acid as catalyst and phosphoric acid as dehydrant, n - phenylmaleimide was prepared from aniline and maleic anhydride by two - step method. the yield was 88. 7 % and the purity was 98. 2 %

    以順酐和苯胺為原料，磷鎢酸作催化劑，磷酸作脫水劑，採用兩步法制得n -苯基馬來酰亞胺，得到最佳反應工藝條件，產品收率為88 . 7 % ，純度為98 . 2 % （質量分數） 。
  3. A decapeptide ( nh2 - nyqkdalgfl - cooh ) and a hexadecapeptide ( nh2 - kakesdagflmfvylv - cooh ) were synthesized as model peptides, then covalently attached to ditc glass beads for methodology study in tbus - itc and tpge - itc chemistry. four c - terminal residues of the synthetic decapeptide have been identified

    利用偶聯到川tc玻璃珠上的10膚，對tpge一1tc作偶聯試劑的活化劑用量、活化時間、偶聯溫度和偶聯時間進行了優化，確定了最佳反應條件。
  4. The extracellular a - amylase from the hyperthermophilic archaeon pyrococcus furiosus, pfa, is a promising candidate in starch processing, since it is optimally active at 100 and ph5. 5 - 6. 0 and does not require ca2 + for activity or thermo - stability

    來源於強烈火球菌（ pyrococcusfuriosus ）的-澱粉酶（ pfa ）具有應用於工業的潛力，因為其最佳反應溫度達100 ，最佳ph為5 . 5 6 . 0 ，且其活力或熱穩定性的維持不需要添加鈣離子。
  5. The effects of sinter conditions on physical performance and electrochemical behavior of olivine lifepo4 were studied. and we made certain the best sinter condition

    研究了燒結條件對lifepo4物理性能及其電化學性能的影響，確定了最佳反應條件。
  6. Optimal reaction temperature

    最佳反應溫度
  7. During the preparation process of the solid solution, a series of effect conditions were discussed such as ph value, si / h2o, the content of ligant, the surface active agent, the aging temperature, the drying means, the drier gel calcine and their effects on the gel quality, the process of sol - gel, the granular of powder and the density of the pellets, from which the best reaction condition was found

    在制備過程中系統地研究了各種反應條件如ph值、 sal ； o 、絡合劑的添加量、老化溫度、乾燥方式、干凝膠的鍛燒方式等對溶膠「的質量、溶膠凝膠過程、粉體粒度及燒結體密度等的影響，確定了最佳反應條件：三、以li 。石i 。 。
  8. To determine influence of technical conditions on product diameter, the influences of concentrations, molar ratio, reaction temperature and time on average size were investigated by means of uniform design. the results of experiments indicated that product diameter was mostly influenced by reaction temperature, followed by molar ratio of reactant, concentration of reactants, and reaction time. the optimum conditions were c ( co ( no3 ) 2 6h2o ) = 0. 35mol / l, n ( co ( nh2 ) 2 ) : n ( co ( no3 ) 2 6h2o ) = 3. 53 : 1, reaction temperature 94 and reaction time 3. 53h

    以產物的平均粒徑（ nm ）為優化指標，選擇硝酸鈷濃度、反應物摩爾比、反應溫度和反應時間四個因素，運用均勻試驗設計技術進行3 ~ 5 1 ~ 3因素優化試驗，發現反應溫度對產物的粒徑影響最大，其次分別為反應物摩爾比、硝酸鈷濃度以及反應時間，並確定最佳反應條件為：硝酸鈷濃度0 . 35mol l ，反應物摩爾比為3 . 53 ： 1 ，反應溫度94 ，反應時間3 . 53h ，預報值粒徑y _ 1 = 19 . 57nm ，在此優化條件下制得的納米co _ 3o _ 4平均粒徑為22nm 。
  9. The results show here, ( 1 ) the best reaction condition determined by the change of film properties in life time with uv light irradiation are : the hydrolyzation temperature is 60, the reaction time is 60 minutes, the less amount of water is of benefit to increase the hydrophobic property, the film formed with high degree polymer is steady

    研究結果如下： （ 1 ）通過調節反應參數，可制得性能優異的疏水性硅酮樹脂塗覆材料。最佳反應條件為：水解溫度60 、反應時間60min ；水解用水量較少和聚合度較大時樹脂塗層的性能較好。
  10. Under the optimum reaction conditions, the yield of benzyl propionate could reach 87. 9 %

    在最佳反應條件下，丙酸芐酯的收率可達87 . 9 % 。
  11. The effect of the mole ratio reactant, reaction temperature, reaction time, catalyzer on the each reaction were studied. the optimum reaction conditions were obtained

    研究反應物配比、反應溫度、反應時間、催化劑用量對各步反應的影響，得到最佳反應條件。
  12. There ' s a clear need for a simple effective assay to facilitate monitoring of rapamycyin levels in those patients in which an optimal response needs to be maintained

    對于那些要保持最佳反應的病人來說，顯然需要一種簡單有效的分析方法，提高雷帕黴素水平監測的效率。
  13. It is a metalloprotease, having a basic proteolytic activity with the optimum ph of 9. 5 and being inhibited by edta. its anti - coagulation activity was characterized

    此組分具有堿性蛋白酶活性，最佳反應ph約為9 . 5 ，不耐高溫， edta能抑制其蛋白酶活性，是一種金屬蛋白酶。
  14. For improving product purifying the conditions in recrystallization processes were investigated and a new method for the improving product purity is proposed

    結果表明，採用最佳反應條件，可使合成鹽酸二甲雙胍的產率提高，產品可一次性達到合格標準，找到了提高產品純度的新途徑。
  15. Reaction catalyzed by solid super acid to synthesize alkyl - polyglycoside is reported. the best reaction activity of solid super acid catalyst is discussed. the conversion of glucose arrived to 99 %

    報道了固體超強酸作催化劑合成烷基葡萄糖多苷的反應，並討論了固體超強酸的最佳反應活性，葡萄糖轉化率達99 % 。
  16. Abstract : in the preparation of 1, 2 ' - binaphthyl by means of coupling reaction, the influencing factors were investigated. by analyzing the course of byproduct formation, the optimum reaction conditions were determined

    文摘:考察了利用偶聯反應制備1 ， 2 ' -聯萘過程中的影響因素，並對生成副產物的原因進行分析，確定了最佳反應條件。
  17. 3. to explore the effects of the different ionic concentrations and ph values on the detection system of the lsaw biosensor and evaluate the consistency of the two channels corresponding to the outer reaction. 4

    3 .探索不同ph值和不同na +離子濃度對傳感器的影響，探討雙通道傳感器受外界條件影響的一致性及最佳反應條件的摸索。
  18. The optimum conditions of dot - elisa was determined : the optimal coating concentration was 8. 9 u g / ml, 1 : 400 was the best working concentration of hrp - laleled rabbit antichicken igg, the other steps and reagentes were also optimized

    抗原最適包被濃度為8 . 9 g / ml ，酶標抗體最適工作濃度為1 ： 400 ，確定了其他反應試劑和各步的最佳反應時間。
  19. The factors that affect on graft ratio are discussed. the factors include reactive temperature, reactive time, the dosage of initiating agent and the dosage of maleic anhydride etc. the optimum reactive condition and the optimum reactive compounding formula are gotten

    在本課題研究過程中，首先制備了pe - mah ，討論了反應溫度、反應時間、引發劑的用量和酸酐用量等對接枝率的影響，得出了最佳反應條件和最佳反應配方。
  20. Abstract : tertiary butylhydroquinone were synthesized by means of alkanisation with actalyst of cation exchange resin in this paper, and discusses several effective fators to the yield of tertiary butylhydroquinone, including the type of cation exchange resin, the ratioes of reagent and the time of reaction

    文摘:以強酸型陽離子交換樹脂為催化劑通過烷基化合成叔丁基對苯二酚，並系統地研究了樹脂型號、物料比、反應時間等因素對合成收率的影響，確定了最佳反應條件。
分享友人
分享到 Line

分享到臉書