最佳含量 的英文怎麼說

中文拼音 [zuìjiāhánliáng]
最佳含量 英文
desired content
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 含 : 動詞1 （東西放在嘴裏 不咽下也不吐出） keep in the mouth 2 （藏在裏面; 包含） contain 3 （帶有某種...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 最佳 : the best; optimum
  1. By the large quantity of indoor and field soil mechanics test, this paper investigated physics and mechanics property of xigeda stratum and xigeda compounding filling, profoundly and systematically studied on shearing strength, cbr ( including indoor cbr and field cbr ) and intensity feature of xigeda compounding filling. the new achievement and cognition as follows : ( 1 ) cbr value is decided by moisture content and mudstone content of xigeda compounding filling. the filling material can satisfy minimum intensity standard of express highway when mudstone content is less than some fixed value, ( 2 ) this paper established field cbr standard value which can synthetically evaluate the filling material nature and field compaction degree. ( 3 ) the optimal compacting mean of xigeda compounding filling is hard oscillation first and weak oscillation later, not traditional way which is weak oscillation first and hard oscillation later. ( 4 ) this paper put forward the conception of optimum moisture content in construction different from optimum moisture content of indoor impaction

    本文以昔格達填料強度特徵為研究對象，通過大量的室內及現場試驗，從昔格達地層巖組的物理力學性質、昔格達填料的物理性質入手，對昔格達填料的抗剪強度、室內承載比及現場承載比特徵進行了較系統地研究，獲得了如下認識及進展：昔格達混合填料承載比值受填料含水量及其中泥巖含量的影響，當泥巖含量小於一定值時，昔格達混合填料具有較高的承載比值，能夠滿足高速公路對填料的最低強度要求；建立了綜合評判昔格達填料性能及現場壓實效果的現場承載比（ cbr ）標準；對于昔格達填料而言，最佳的碾壓方式為先強振后弱振而不是傳統的先弱振后強振；提出了與室內擊實最優含水量相區別的施工最佳含水量的概念。
  2. These additives have no adverse effect on the properties of the coating, and the optimum contents of them are : hydrophobic additive 6 %, sepiolite 6 % and expanded pearlite 3 %

    在該材料中疏水添加劑的最佳含量為6 ，海泡石最佳含量為6 ，膨脹珍珠巖的最佳含量為3 。
  3. Experiments show the optimum content of pyrophyllite and dolomite is 30 % ; in contrast to original bond, the refractory point of bond is reduced by 55, the average coefficient of thermal expansion is reduced by 30 % and flexural strength and shock strength of grinding tool are increased by 27 % and 22 % respectively

    通過實驗發現：葉蠟石和白雲石最佳含量為30 % ，與原結合劑相比，結合劑耐火度降低了55 ，平均熱膨脹系數降低了30 % ，磨具抗折強度提高了27 % ，磨具抗沖擊強度提高了22 % 。
  4. In the paper, through the compaction test, the optimum moisture content and maximal dry density of aeolian sand are determined

    本文通過擊實試驗，確定了風積沙的最佳含水量和最大幹密度。
  5. The optimum conditions for air electrode preparation were shown as follow : 20 % ptfe and 20 % mno2 in active layer, thickness of active layer 0. 15 - 0. 25mm and the ratio of active carbon to ethine black 4 : 1 ; 60 % ptfe in the gas diffusion and waterproof layer, employing na2so4 as pore - making agents, thickness 0. 35 - 0. 45mm, colding forming and layer sequence catlytic layer / gas diffusion and waterproof layer / current collector layout ; employing 40 meshed nickel screen as current collector and thermal treatment temperature over 200

    確定了制備空氣電極的優化工藝條件，催化層中ptfe含量約20 ， mno _ 2的最佳含量約為20 ，催化層中活性炭和乙炔黑的比例為4 ： 1 （質量比） ，厚度在0 . 15 - 0 . 25mm之間。防水透氣層中ptfe的含量約為60 ，以無水硫酸鈉作為造孔劑，厚度一般為0 . 35 - 0 . 45mm 。電極各層採用催化層/防水透氣層/集流體的排布方式，冷壓成型，熱處理對空氣電極的性能影響較大，熱處理溫度不低於200 。
  6. The experimental results demonstrate that the suitable mea hot - pressing temperature and pressure are 120 and 15. 5mpa, respectively. the optimum catalyst loading in anode is 4 mg pt / cm2, and the best contents of nafion ionomer in anode and cathode layer are 45wt % and 35. 3wt %, respectively

    實驗結果顯示，制備膜電極時最佳的熱壓溫度和壓力分別為120和15 . 5mpa ；陽極催化劑的適宜載量為4mgpt / cm2 ；陽極和陰極催化劑層的nafion最優含量分別為45 . 0wt %和35 . 3wt % 。
  7. Water stability and strength increasing mechanism are researched and the changing trend and degree of maximum dry density, the optimum moisture and the intensity of the admixture are gained through mixing into clay

    通過在風化料中摻入粘土的對比試驗，研究風化料加入摻加劑后的水穩定性和強度增長機理，得出摻入粘土后風化料最佳含水量、最大幹密度、強度的變化趨勢和程度。
  8. ( 3 ) studying the effect of wollastonite content on performances of composite material, we can find out that the optimum content of wollastonite is 30 %, with the content continues to rise, the performances fall accordingly

    （ 3 ）硅灰石含量對復合材料性能的影響實驗表明，硅灰石在pp中的最佳含量為30 ，隨著硅灰石含量的繼續增加，其機械力學性能隨之下降。
  9. The intercalation reaction is very sensitive to moisture and a small amount of water added to the kaolinite - formamide system facilitates the intercalation reaction

    插層反應對插層劑中的水含量非常敏感，最佳含水量為5 9 。
  10. According to the data of besting experiments, the paper analyses the relationship between the optimal water content and the quantity of added lime, analyses the relationship between the maximal dry density and the quantity of added lime

    從擊實試驗的結果得到石灰土最佳含水量與摻灰量的關系，最大幹密度與摻灰量的關系。
  11. According to the data of beating experiments, the paper analyses the relationship between the optimal water content and the quantity of added lime, analyses the relationship between the maximal dry density and the quantity of added lime

    從擊實試驗的結果得出了石灰土最佳含水量與摻灰量的關系，最大幹密度與摻灰量的關系。
  12. The highest viability of pavlova viridis reached 69 % when it was dehydrated to 35 % water content. as to other two algae, 30 % water content is optimum. their highest viabilities are 10 % and 13 % respectively

    各種金藻的最佳含水量不同，綠色巴夫藻為35 % ，冰凍后存活率可達69 % ；湛江叉鞭藻和球等鞭金藻都為30 % ，冰凍后存活率分別可達10 % 、 13 % 。
  13. The optimum conditions in wheat bran and rice bran on solid state fermentation were 3 % corn starch as additional carbon sources, 4 % ( nh4 ) 2 so4 as additional nitrogen sources, 60 % moisture content of the medium, 25

    在麩皮米糠培養基中，添加3的玉米澱粉、 4的（ nh _ 4 ） _ 2804可顯著提高固體曲中植酸酶酶活，培養基最佳含水量為60 ；最佳產酶溫度為25 。
  14. Under the conditions of dry, optimum moisture content or half of optimum moisture content and three kind diameter of loading boards, the main factors relative to modulus of resilience are also studied through the test of modulus of resilience

    在乾燥、最佳含水量、一半最佳含水量和三種不同直徑大小承載板情況下做回彈模量試驗，研究了影響回彈模量大小的主要因素。
  15. ( 5 ) the analysis factor that influence the compaction craft of the xigeda filler ; the results show that the optimum moisture content of xigeda filler is about 0. 4 times of liquid limit and 0. 69 times of plastic limit, the lower compaction equipment is better than the big equipment

    研究表明：昔格達填料的最佳含水量與塑液限有關，昔格達填料的最佳含水量約為液限的0 . 4倍，約為塑限的0 . 69倍。
  16. This system finished supervisory control of boiler burning, sampled signals through sensors and calculated the signals whether reached the best content of oxygen and the best wind - coal ratio. using it controls the quantity of coal, entering wind and sending wing for reaching the best thermal efficiency of burning and improving economy benefit of boiler running

    系統對鍋爐燃燒進行監控，通過傳感器采樣信號，計算是否達到最佳含氧量、最佳風煤比，來控制給煤量、引風量和送風量，使燃燒達到最佳熱效率和提高鍋爐運行的經濟效益。
  17. It increases the precision of analysis to use differential spectrophotometry in high and trace contents. it has higher application value and upper popularization worth

    摘要用示差分光光度法進行高含量或痕量物質的分析，使吸光度落在最佳測量范圍，增大了測量方法的精確性，具有較高的應用價值，值得推廣。
  18. In this thesis we have studied the toughening and strengthing modifications of polypropylene ( pp ) by nano - particle such as cac03 ) si02 and ti02. the performance of modified polypropylene and the modifying mechanism have been introduced. we have also explored the furthest dosage of titanate coupling agent in cac03 / pp and the influence of coupling agent to the composites by the determination of the mechanical properties

    本課題主要研究納米caco _ 3 、 sio _ 2和tio _ 2粉體改性聚丙烯（ pp ）后材料的力學性能及其增強機理，同時還對鈦酸酯偶聯劑改性納米caco _ 3粒子的最佳含量以及偶聯劑的加入對復合材料的力學性能的影響進行了研究，並對納米caco _ 3粒子和微米caco _ 3粒子分別填充pp的力學性能進行了比較分析。
  19. It is the foundation of boiler burning control to find optimum excess air coefficient, in addition, it is key to adjust the damper opening and valve opening use fuzzy control algorithm according to the content signal of o2 and co in fume road

    尋找最佳過量空氣系數是鍋爐燃燒控制的基礎，而鍋爐燃燒控制的關鍵是根據煙道含氧量、煙道一氧化碳含量信號，調整氣風門開度，使過量空氣系數保持在最佳值附近。
  20. Using this expression to calculate the optimum rare - earths oxides ( nd2o3, ceo2 and la2o3 ) content of zinc oxide varistor, the quantitative calculation results are in accordance with the experimental results approximately. the double shottky potentical barrier was showed in form of catoon using flash, from which we can comprehend the conduction theory of zinc oxide varistor. the electrical properties of varistor can be improved depend on it

    運用固體物理、半導體和電子薄膜材料的相關理論，建立數學模型，推導出了最佳摻雜含量的理論計算式，並將之推廣到高溫燒結的氧化鋅壓敏陶瓷材料，運用這一計算式定量計算ndzo3 、 ceoz和lazo3等稀土摻雜的最佳含量，計算結果與本文的實驗結果比較符合。
分享友人
分享到 Line

分享到臉書