最大噪聲功率 的英文怎麼說

中文拼音 [zuìzàoshēnggōng]
最大噪聲功率 英文
maximum noise power of earphone
  • : 副詞(表示某種屬性超過所有同類的人或事物) most; best; worst; first; very; least; above all; -est
  • : 動詞1. (蟲或鳥叫) chirp 2. (大聲叫嚷) make noise; make an uproar; clamour
  • : 名詞1 (功勞) exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • : 率名詞(比值) rate; ratio; proportion
  1. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比;通過提高壓縮比來彌補動力性的損失;以動力性為主控目標,對點、扭矩點、中等轉速、低轉速點所對應的發動機轉速做了點火特性的調節;通過空燃比的合理控制,直接改善發動機的動力性、經濟和排放指標;作為對缸內燃燒過程的理論分析,進行了燃燒特性的實驗測試;對原汽油機和新開發的液化石油氣發動機,進行了外特性和部分負荷特性以及怠速的排放及對比性測試。
  2. Letter ratio : point biggest not lose the signal strength of the true voice with at the same time of the emanative noise strength opposite voice for of ratio, usually with meaning, letter comparing more bigly, turn on electricitying the road more small, quality more pure and unadulterated. want to choose the letter the ratio in the product of above. new of summer is with the series the product s letter ratio all in the above, have more professional of performance

    比:指不失真音的信號強度與同時發出的音強度之間的比,通常以表示,信比越放電路的相對就越小,音質就越純正。要選信比在以上的產品。夏新和系列產品的信比都在以上,有更加專業的表現。
  3. Then we introduce the character of the atmosphere channel, which we emphasized on the atmosphere scatter, absorption and scintillation ' s effect on the laser beam. in chapter, we explain why we used cassegrain telescope to collect the optical signal at first, then the lightsource, detector, front amplifier used in optical communication has been compared to that of fiber communication, the noise including shot noise, thermal noise and background light noise has been explained here for analysis the snr and ber in the next section

    在第三章介紹無線光接入系統的光收發單元,採用多孔徑卡塞格倫式的收發天線對消除減小氣湍流影響有較作用,針對氣通道的特點無線光系統收發單元在光源、光探測器、前置放電路上存在許多有別于光纖通信的技術,同時還闡述了光接收機包括背景機制和接收靈敏度、誤碼等指標,後給出了一個整個傳送鏈路的預算。
  4. Based on our theoretical predictions, we find optimal splicing parameters on fsm - 30s fiber splicer for low loss joints between erbium doped fiber and other single mode fibers. we also experimentally demonstrate a novel three - stage erbium - doped fiber amplifier with high gain, low noise figure, and high output power. finally, a prototype of a gain - clamped fiber amplifier is obtained with high gain ( 26 db ), low noise figure ( 5. 3 db ), high output power ( 17 dbm ), and large bandwidth ( 31 nm )

    文章研究了摻鉺光纖( edf )與其他光纖低損耗焊接問題,得到光纖熔接機低損耗熔接的佳參數,這對摻鉺光纖放器的科研生產具有一定的指導意義;研究了新型的三段級聯泵浦優配的摻鉺光纖放器的優化光路結構,得到高增益,低輸出的摻鉺光纖放器;後研製成高增益( 26db ) ,低( 5 . 3db ) ,輸出( 17dbm ) ,寬帶( 31nm )增益箝制摻鉺光纖放器樣機。
  5. In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )

    與張瑞英博士一起,首次利用該種有源區結構制備出偏振不靈敏半導體光放器,並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬,在不同信號波長,不同信號0 - 200ma的注入電流范圍內,偏振相關損耗均《 0 . 9db ,在耦合差損為7db / facet的條件下,fiber - to - fiher增益達10db ,無損操作電流為50 - 70ma ,消光比達50db以上,而指數則低於8db ,小可達4 . 6db 。
  6. A new aerodynamic design system developed by authors for draft fan with enhanced efficiency, suppressed noise, enlarged flux and high load. the new design system features : a twist regulation for vortex control is employed in designing to lessen the secondary flow loss in the blade tip and hub ; the feasibility and high efficiency of this procedure has been verified by the tests of the prototype fan ; a new computer - aided 3d blading is used to optimize the blade ; numerical inverse checking is adopted to enhance accuracy in designing and cut down the period of the designing and production. this design system can make the optimized blade with " forward inclination ", " inclining sweep ", " bending sweep ", to minimize the various secondary flow losses, to expand the steady working range of the fan, and to suppress the aerodynamic noise source

    本文通過對一種新型高性能礦用局部通風機的設計、製造及試驗全過程的綜述,展現了新的先進設計體系在民用通風機上的成運用,其研製特點是: ( 1 )在葉片氣動設計中為了降低葉根及葉尖區二次流損失,採用可控渦扭向規律設計,樣機實測的高性能驗證了這種方法的可行性和高效性; ( 2 )在設計方法中採用較精確的數值反驗算,獲取優設計方案,提高設計的準確性和成,並縮短了設計試制周期; ( 3 )在設計過程中發展了計算機輔助三維葉片造型新方法,可以根據設計需要簡便快捷地對葉片進行「前傾」 、 「傾掠」或「彎掠」造型,這些造型對減小各種二次流損失、擴穩定工況范圍和控制葉輪機氣動源起到了非常好的作用。
  7. Abstract : a new aerodynamic design system developed by authors for draft fan with enhanced efficiency, suppressed noise, enlarged flux and high load. the new design system features : a twist regulation for vortex control is employed in designing to lessen the secondary flow loss in the blade tip and hub ; the feasibility and high efficiency of this procedure has been verified by the tests of the prototype fan ; a new computer - aided 3d blading is used to optimize the blade ; numerical inverse checking is adopted to enhance accuracy in designing and cut down the period of the designing and production. this design system can make the optimized blade with " forward inclination ", " inclining sweep ", " bending sweep ", to minimize the various secondary flow losses, to expand the steady working range of the fan, and to suppress the aerodynamic noise source

    文摘:本文通過對一種新型高性能礦用局部通風機的設計、製造及試驗全過程的綜述,展現了新的先進設計體系在民用通風機上的成運用,其研製特點是: ( 1 )在葉片氣動設計中為了降低葉根及葉尖區二次流損失,採用可控渦扭向規律設計,樣機實測的高性能驗證了這種方法的可行性和高效性; ( 2 )在設計方法中採用較精確的數值反驗算,獲取優設計方案,提高設計的準確性和成,並縮短了設計試制周期; ( 3 )在設計過程中發展了計算機輔助三維葉片造型新方法,可以根據設計需要簡便快捷地對葉片進行「前傾」 、 「傾掠」或「彎掠」造型,這些造型對減小各種二次流損失、擴穩定工況范圍和控制葉輪機氣動源起到了非常好的作用。
  8. Tgnp : the greatest noise power

    最大噪聲功率
  9. Thus, the better phase noise can be obtained by adjusting the loop wave filtering. through experimental verification, the locking range of the designed ka band ilpll circuit is 2. 5 times to 9 times widened and the phase noise, compared to that without feedback loop, is reduced by 4dbc @ 1khz and the noise can be reduced by adjusting the loop wave filtering and

    經過實驗驗證,設計的ka波段ilpll電路的鎖定帶寬拓展了2 . 5倍以上,處達到9倍左右;相與開環注鎖相比降低了4dbc @ 1khz ,且可以通過調節環路濾波和注入來降低
分享友人