最小阻力速度 的英文怎麼說

中文拼音 [zuìxiǎozǔlìsùdù]
最小阻力速度 英文
minimum-drag speed
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 小 : Ⅰ形容詞1 （體積、面積、數量、強度等不大） small; little; petty; minor 2 （年紀小的; 年幼的） youn...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 阻力 : 1 （阻礙事物發展的外力） obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  1. Different algorithms were compared in the numerical simulation and model experiment of concrete velocity inversion the results showed that, compared with the least - square solutions and the damped least - square solutions, the damped and natural weighted least - square solutions reflected the inner defections of the tested object more reliably and exactly due to the usage of correct priori information, which benefited the suppression of noises and made the iterations of inverse stable and convergent

    結果表明，相對于最小二乘法和阻尼最小二乘法，基於自然權的加權阻尼最小二乘演算法，由於利用了正確的先驗信息，不但使反演過程收斂，而且具有數值穩定、抗噪能力強的優點，其成像結果能真實有效地反映對象內部缺陷，因此更適用於混凝土的超聲波速度反演。
  2. Compared with straight ray tracing, inversion of bending ray tracing is better when data of test are accurate. on the other hand, natural weight is introduced and numerical simulations and experiments of wlm on inversion of velocity and attenuation are also made, which show that wlm, with resistance of noises and convergence of iteration, may get good re - construction images

    本文引入了物理意義明確的自然權，對基於自然權的加權阻尼最小二乘反演演算法（ wlm ）在速度反演、衰減反演中進行了數值模擬和試驗研究，結果表明wlm均能獲得良好的重建圖像，迭代收斂，抗噪能力強。
  3. Chapter two constructed the mathematical model of robot and its environment solved by the fem analysis. the functions or relations between the robotic parameters and its drive forces, thickness or its velocities were given, and also the functions or relations between the environment and the robot force, friction, robot velocity, minimum thickness of film or sustain force of dynamic films were given

    論文第二章通過建立機器人和環境的數學模型，利用有限元方法求解其中的n - s方程，得出管道中微型機器人的各種設計參數與機器人的驅動力、形成的最小潤滑油膜厚度和機器人的運行速度之間的關系曲線，研究了管道環境與機器人驅動力、摩擦阻力矩、機器人運行速度、形成的最小潤滑油膜厚度、油膜的承載能力之間的關系。
  4. For shutters, the results show : 1 ) according to the formula p =, the theoretical value of is calculated by the effective velocity of the flow, and its engineering value is calculated by the arriving velocity of the flow, the relationship between the theoretical value of and its engineering value is 2 ) the smaller value of declining angle will result in the smaller pressure loss and smaller outlet velocities. as a result, the declining angle of 30 擄 or less is recommended in some places which need small wind velocity, such as broadcasting studio and library, and the declining angle of 45 擄 or less is recommended in places which need big wind velocity, such as cinema and office ; 3 ) the larger value of ratio between the wide of the shutter b and the space between two boards h ( b / h ) will result in the larger pressure loss and smaller outlet velocities. the range of b / h from 0. 8 to 2. 0 and the optimum value 1. 2 is recommended ; 4 ) the range of b from 10 mm to 50 nun and the optimum value 40 mm is recommended ; 5 ) the proper thickness of the boards 8 of the shutters is 1. 5 mm ; 6 ) cuneiform boards should replace the rectangle inlet boards of the shutters in order to obtain better ventilation

    數值模擬採用fluent軟體，計算結果用excel進行處理，通過對大量數值工況進行數值模擬計算，結果表明：對于單側百葉風口，計算表明： 1 ）對于公式p = （ ~ 2 ） 2 ，的理論計算值中定義為流體流經百葉風口內部時的速度，即有效速度，而工程上常使用流體的來流速度來計算，計算表明，的理論計算值與工程應用值的關系為（ _ （理論） ） （ _ （工程） ） = 0 . 813 ； 2 ）當來流速度一定時，擋板傾斜角度越小，壓力損失越小、出口速度越小；因此在要求進口風速比較小的場所，如播音室、圖書館等，宜採用擋板角度30的百葉風口；在要求進口風速比較大的場所，如電影院、辦公室等，百葉擋板的角度應選45 ； 3 ）當來流速度一定時，百葉擋板的擋板寬度b與擋板間距h的比值b h越大，壓力損失越大，出口速度越小，計算表明，鑒于壓力損失、出口風速、板間形成渦流區的大小，百葉擋板的b h值取0 . 8到2 . 0之間， b h = 1 . 2為最佳值； 4 ）當來流速度一定時，在計算的條件下，當百葉擋板寬度b = 40mm時，百葉擋板的阻力系數最小，考慮到渦流區等的影響，建議選用10mm b 50mm的百葉擋板；西安建築科技大學碩士學位論文5 ）百葉擋板的厚度取為1 . sinln為好; 6 ）百葉擋板的入口側可選用具有傾斜度的楔形擋板來代替矩形擋板，利用其較好的導流作用，可得到更好的出流效果。
分享友人
分享到 Line

分享到臉書