有孔膠片 的英文怎麼說

中文拼音 [yǒukǒngjiāopiān]
有孔膠片 英文
perforated film
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • : 片構詞成分。
  • 膠片 : film; cartridge; photographic film
  1. Due to the size of the defect, a fragment of bone is introduced to support the mucosal graft. strength of the repair is verified by increasing intercranial pressure with the valsalva maneuver, and it is seen to be watertight. rapid - setting fibrin glue is applied, and a second layer of mucosa is applied over this

    由於瘺較大,置入一些骨的碎以支持填塞物,通過valsalva法咽鼓管吹氣法增加顱內壓可以觀察修補的牢固性,可以看到沒泄漏,利用可以快速固定的纖維蛋白進行固定,其上鋪上一層粘膜,然後再用水進行固定。
  2. In the experiment, we use the he - ne laser and the semiconductor laser as the source, record the bessel beam patterns behind the axicon by using a digital camera and a microscope, measure the radius of the bessel beam central spot by film - scanning and measure the effect of both the radius of the aperture and the open angle of the axicon on the maximum non - diffraction distance. the experiments show that a specific propagating range has constant power and the beam has a bessel - like distribution in this range. the results agree with the beam corresponding to a diffraction free beam

    同時我們還採用掃描的方法測量了無衍射光束的中心光斑尺寸,測量了不同光闌徑和不同稜角情況下的最大無衍射距離和傳播軸附近橫截面內微小光中的光強,實驗結果顯示當激光光束經過軸棱錐轉換後一段距離功率變化很小,且分佈近似貝塞爾分佈,符合無衍射光束的特性;經過聚焦后,呈現三維分佈中空的光束bottlebeam ,實驗結果與理論分析基本吻合。
  3. Yiwu jufeng plastic co, ltd is professional manufacturer specializing in all kinds of plastic bags, like micro perforated wicket bread bags, flower bags, transparent pvc handbags, cosmetic bags, hot melt self seal bags, pp clothes bags, opp self adhesive bags, gift bags, courier bags and other plastic packaging bags

    主要產品:彩印袋bopp自粘袋襪袋飾品袋卡袋pe流延膜服裝袋鮮花袋透明pvc手提袋化妝包各種禮品袋等各種規格塑料包裝袋。同時公司還出口微穿麵包袋,水果袋,鮮花袋,郵件速遞袋, ldpe熱溶袋。
  4. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含碳納米管的溶,進而除去乙醇相得到碳納米管,其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶; cvd基體法是使用自製的六方介mcm - 41多材料為基體,負載fe催化劑活性組分,通過cvd法催化裂解c2h2來生長碳納米管。
分享友人